1. Introduction
Thank you for choosing the ANLAN Multipolar Facial Radiofrequency Massager. This device is designed to provide comprehensive facial care, combining radiofrequency (RF) technology, electrical muscle stimulation (EMS), hot and cold modes, and LED light therapy. Regular use can help improve skin elasticity, reduce the appearance of wrinkles, and enhance overall skin hydration and radiance. Please read this manual thoroughly before first use to ensure safe and effective operation.
2. Safety Precautions
- Do not use the device on broken, irritated, or infected skin.
- Avoid using the device if you have a pacemaker, heart condition, epilepsy, or are pregnant.
- Keep the device away from water and do not immerse it.
- Do not use the device while charging.
- Keep out of reach of children.
- If you experience any discomfort, discontinue use immediately.
- The device features an NTC temperature control system to maintain skin surface temperature below 43℃, preventing burns. However, always monitor your skin's reaction.
3. Package Contents
Verify that all items are present in the package:
- ANLAN Multipolar Facial Radiofrequency Massager
- USB-C Charging Cable
- Charging Adapter (5V, 2A)
- Cotton Pads
- Cotton Pad Fixing Ring
- Cleaning Cloth
- Storage Pouch
- User Manual
Image: ANLAN Facial Massager with included accessories, including charging cable, cotton pads, and storage pouch.
4. Setup Guide
4.1. Charging the Device
- Connect the USB-C charging cable to the charging port at the base of the device.
- Plug the other end of the cable into the provided charging adapter, then into a power outlet.
- The device will indicate charging status (e.g., flashing light). A full charge typically takes approximately 1.5 hours.
- Disconnect the charger once fully charged. Do not operate the device while it is charging.
4.2. Initial Preparation
- Ensure your face is clean and free of makeup before use.
- For certain modes, apply a suitable skincare product (e.g., gel, serum, cream) to your face as instructed in the operating section.
5. Operating the Device
The ANLAN Facial Massager offers five main modes and three intensity levels. It is recommended to start with the lowest intensity and gradually increase as your skin tolerates.
5.1. Controls
- Power On/Off Button: Press and hold to turn the device on or off. Short press to switch between modes.
- Intensity Level Button: Press to adjust the intensity level (1-3) within the selected mode.
- LED Light Button: Press to activate or deactivate the LED light therapy (Red or Blue), independent of the selected mode.
5.2. Modes of Operation
The device features an 18K gold flat probe, which is hypoallergenic, resistant to oxidation, and easy to clean, making it suitable for sensitive skin.
Image: Close-up of the device's 18K gold flat probe, highlighting its allergy-resistant, easy-to-clean, and anti-oxidation properties.
Image: Diagram illustrating the device's NTC temperature control system, ensuring skin temperature remains below 43℃ to prevent burns.
- CLEAN Mode (Deep Cleansing)
This mode utilizes ionic export to deeply cleanse pores and remove residual makeup and impurities. Attach a cotton pad with makeup remover or micellar water using the fixing ring. Move the device in circular motions across your face, from the center outwards.
Image: Illustration of the CLEAN mode, showing the device removing impurities from the skin.
Image: A woman demonstrating the CLEAN mode, using the device with a cotton pad and makeup remover on her cheek.
- FIRM Mode (RF Anti-Wrinkle)
This mode uses radiofrequency to stimulate collagen and elastin production, reducing fine lines and wrinkles. After cleansing, apply a suitable gel or mask to your face. Move the device in small, constant circles across the entire face.
Image: Illustration of multipolar radiofrequency technology targeting skin for wrinkle reduction and contour lifting.
Image: A woman demonstrating the FIRM mode, applying a gel and moving the device across her cheek to reduce fine wrinkles.
- LIFT Mode (V-Shape Lifting)
This mode uses EMS microcurrents to tone facial muscles and sculpt the jawline, providing a V-shape lifting effect. After applying an essence, move the device in upward sliding motions along the facial contours. Focus on areas like the jawline and cheekbones.
Image: A woman using the device on her neck in LIFT mode, performing upward sliding motions.
Image: A woman using the device on her cheek in LIFT mode, performing upward sliding motions.
- MOIST Mode (Nutrient Import)
This mode enhances the absorption of skincare products. After washing your face, apply a serum, cream, or facial mask. Select MOIST mode and move the device in circular motions over your face to help nutrients penetrate deeper into the skin.
Image: Illustration showing enhanced absorption of skincare products into the skin layers with the device.
Image: A woman demonstrating the MOIST mode, applying a serum or cream and moving the device in circular motions on her face.
- COOL Mode (Pore Closing & Soothing)
This mode uses a cooling effect to close pores, lock in moisture, and soothe the skin. No additional skincare products are typically needed for this mode. Press the device gently onto your skin to complete your skincare routine.
Image: Illustration showing the cooling effect helping to close pores and seal in nutrients within the skin.
5.3. LED Light Therapy
The device integrates two LED light therapy options:
- Red Light: Activates cells and metabolism, helping to reduce spots and wrinkles, and improve skin elasticity.
- Blue Light: Helps eliminate bacteria and has an anti-inflammatory effect, beneficial for acne-prone skin.
Image: Illustration depicting red and blue LED light penetrating the skin for rejuvenation and acne treatment.
5.4. Recommended Usage
- You can perform the full 5-step skincare routine or select specific modes based on your needs. The five modes are independent but can also form a complete routine.
- There are no strict requirements, but generally, you can use the device 2-3 times a week.
- The device has an auto-off function to prevent overuse, typically after 5 minutes in a single mode.
- Consistent use for at least 28 days is recommended to observe visible results in wrinkle reduction and collagen formation.
Image: Visual guide for using the device on different facial areas: around the eyes (MOIST mode), neck (LIFT mode), cheek (CLEAN/LIFT mode), and forehead (FIRM mode).
6. Care and Maintenance
- Cleaning: After each use, wipe the 18K gold flat probe with the provided cleaning cloth or a soft, damp cloth. For thorough cleaning, you can use a small amount of alcohol on the cloth. Ensure the device is turned off before cleaning.
- Storage: Store the device in its storage pouch in a cool, dry place, away from direct sunlight and extreme temperatures.
- Water Resistance: The device is not water-resistant. Avoid rinsing it under running water or immersing it.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not turn on | Low battery; Device not charged | Charge the device fully. Ensure the charging cable and adapter are properly connected. |
| No sensation during use | Low intensity level; Insufficient contact with skin; No conductive medium (gel/serum) | Increase the intensity level. Ensure full contact with the skin. Apply a suitable conductive gel or serum for modes requiring it. Note that vibration may take a few seconds to become noticeable. |
| Device turns off unexpectedly | Auto-off feature activated; Low battery | The device has an automatic shut-off after 5 minutes of continuous use in a mode. Recharge the device if the battery is low. |
| Skin feels too warm | High intensity level; Prolonged use in one area | Reduce the intensity level. Move the device continuously and avoid keeping it in one spot for too long. The device has a built-in temperature control to prevent overheating. |
8. Technical Specifications
| Feature | Specification |
|---|---|
| Brand | ANLAN |
| Model | B0CTH7BCC9 |
| Technology | Multipolar Radiofrequency (RF), Electrical Muscle Stimulation (EMS), Hot & Cold Modes, LED Light Therapy |
| Probe Material | 18K Gold Flat Probe |
| Temperature Control | NTC system, maintains skin temperature below 43℃ |
| Modes | CLEAN, FIRM, LIFT, MOIST, COOL (5 modes) |
| Intensity Levels | 3 levels per mode |
| LED Lights | Red, Blue |
| Auto-off Timer | Approximately 5 minutes per mode |
| Charging Time | Approx. 1.5 hours |
| Power Input | 5V, 2A (via USB-C) |
9. Warranty and Customer Support
ANLAN provides a 24-month warranty for this product, covering manufacturing defects and malfunctions under normal use. Please retain your proof of purchase for warranty claims.
If you have any questions about the ANLAN Multipolar Facial Radiofrequency Massager, require assistance with its use, or need to report an issue, please do not hesitate to contact our customer support team. Our experts are available to provide prompt assistance.
For support, please refer to the contact information provided with your purchase or visit the official ANLAN website.
Image: Graph illustrating the natural decline of collagen and elastin in the skin with age, emphasizing the need for supportive skincare.
Image: Results from a study showing percentage improvements in skin laxity, chin angle, and cutaneous wrinkles after 14 and 28 days of use.
