YAOHUIMI Replacement Remote Control Instruction Manual for Joy Fireplace Heaters

Introduction

This manual provides instructions for the YAOHUIMI Replacement Remote Control. This remote is designed to operate various Joy Electric Infrared Fireplace Space Heater models, including RFH-6001LH, RFH-7401LB, RFH-3601LC, RFH-10201LB, and RFH-3001LC. It requires no programming and is ready for use after battery installation.

Setup

1. Battery Installation

The remote control requires two AAA 1.5V batteries (not included). Follow these steps to install the batteries:

Locate the battery compartment cover on the back of the remote control.
Slide the cover downwards or press the latch and lift to open.
Insert two AAA 1.5V batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
Replace the battery compartment cover by sliding it back into place until it clicks securely.

Image showing the battery compartment of the remote control with the cover removed, indicating where to insert two AAA 1.5V batteries.

Figure 1: Battery compartment showing insertion of AAA 1.5V batteries.

Comparison image showing a new remote design with AAA battery compartment versus an old design with a coin battery compartment.

Figure 2: This remote uses AAA 1.5V batteries for longer life and easier replacement.

2. Compatibility

This remote control is compatible with the following Joy Electric Infrared Fireplace Space Heater models:

Joy RFH-6001LH
Joy RFH-7401LB
Joy RFH-3601LC
Joy RFH-10201LB
Joy RFH-3001LC

No programming is required. The remote is pre-configured for immediate use with compatible models.

Operating Instructions

Point the remote control directly at the fireplace heater's receiver. Ensure there are no obstructions between the remote and the heater.

Diagram of the remote control with labels pointing to each button and its function, including Power, Flame Bed Color, Flame Color, Control The Heater, Dimmer Button, Control The Timer, and Control Flame Speed.

Figure 3: Remote Control Button Functions.

Button	Function
ON/OFF	Powers the fireplace heater on or off.
+ / -	Adjusts settings such as temperature or flame intensity. (Functionality may vary by heater model)
COLOR A	Controls the flame bed color.
COLOR B	Controls the main flame color.
HEAT	Activates or deactivates the heater function.
DIMMER	Adjusts the brightness of the flame effect.
SPEED	Adjusts the speed of the flame effect.
TIMER	Sets or adjusts the heater's timer function.

Maintenance

Battery Replacement

Replace batteries when the remote's range decreases or it stops responding. Always replace both batteries simultaneously with new AAA 1.5V batteries. Do not mix old and new batteries or different types of batteries.

Cleaning

Wipe the remote control with a soft, dry cloth. Do not use abrasive cleaners, solvents, or wet cloths, as these can damage the surface or internal components.

Storage

If the remote control will not be used for an extended period, remove the batteries to prevent leakage and potential damage.

Troubleshooting

Remote not responding:
- Check if the batteries are correctly installed with the correct polarity.
- Replace old batteries with new AAA 1.5V batteries.
- Ensure there are no obstructions between the remote control and the fireplace heater's receiver.
- Confirm that the remote is pointed directly at the heater.
Limited range:
- Replace the batteries.
- Ensure no strong light sources or electronic devices are interfering with the signal.

Specifications

Model Number	A424011101G15(GAO04)
Compatible Heater Models	Joy RFH-6001LH, RFH-7401LB, RFH-3601LC, RFH-10201LB, RFH-3001LC
Battery Type	2 x AAA 1.5V (not included)
Item Weight	1.06 ounces (approximately 30 grams)
Package Dimensions	0.39 x 0.2 x 0.08 inches (approximately 1 x 0.5 x 0.2 cm)

YAOHUIMI A424011101G15(GAO04)