UNA GELLA UG
UNA GELLA UV Gel Nail Glue 20ml Instruction Manual
Model: UG
1. Introduction
The UNA GELLA UV Gel Nail Glue is a 20ml super strong solid glue gel designed for applying fake acrylic nail tips and press-on nails. This innovative formula requires UV/LED lamp curing for optimal adhesion and long-lasting wear. It is formulated to be gentle on natural nails, low odor, and free from air bubbles, providing a professional finish for nail art extensions.

Image: UNA GELLA Super Adhesive Glue Gel applied to nails, showcasing durability and various styles.
2. Safety Information
- For external use only. Avoid contact with eyes and skin. In case of contact, rinse immediately with plenty of water and seek medical advice.
- Keep out of reach of children.
- Store in a cool, dry place away from direct sunlight.
- Always perform a patch test before full application to check for any allergic reactions.
- Use in a well-ventilated area.
- UV/LED lamp curing is required. Ensure proper eye protection when using UV/LED lamps.
3. What's Included
Your UNA GELLA UV Gel Nail Glue package includes:
- 1 x 20ml tube of UNA GELLA UV Gel Nail Glue

Image: The UNA GELLA UV Gel Nail Glue 20ml tube and its retail packaging.
4. Setup and Preparation
Proper nail preparation is crucial for long-lasting adhesion.
- Clean Nails: Ensure your natural nails are clean and free from any old polish, oils, or debris.
- Push Back Cuticles: Gently push back your cuticles using a cuticle pusher.
- Buff Natural Nails: Lightly buff the surface of your natural nails to create a slightly rough texture for better adhesion.
- Remove Excess Cuticles and Oils: Carefully remove any excess cuticles and oils.
- Apply Nail Dehydrator: Apply a nail dehydrator to create a dry surface on the nail bed. This step is essential for long-lasting adhesion.
- Select Nail Tips: Choose the correct size of clear nail tips or press-on nails that fit your natural nails from sidewall to sidewall.
- File Inner Side of Nail Tips (Optional): For enhanced adhesion, you may lightly file the inner side of the nail tips where the glue will be applied.

Image: Visual steps for preparing natural nails before applying gel glue and nail tips.
5. Operating Instructions (Application)
Follow these steps for effective application of UNA GELLA UV Gel Nail Glue:
- Apply Glue Gel: Squeeze an appropriate amount of the solid glue gel onto the inner side of the selected nail tip. Avoid applying too much or too little. The special bottle mouth allows for precise control without needing a separate brush.
- Position Nail Tip: Place the nail tip onto your natural nail at a 45-degree angle, starting from the cuticle area.
- Press and Secure: Gently push the nail tip from the middle outwards, ensuring the glue gel spreads evenly and reaches the free edge of your natural nail. This helps to eliminate any air bubbles and ensures a perfect stick.
- Cure with UV/LED Lamp:
- For clear nail tips: Cure under a UV/LED nail lamp for 45-60 seconds.
- For X-color series tips and clear press-on nails: Cure under a UV/LED nail lamp for 2-3 minutes.
Important: Maintain gentle pressure on the nail tip during the initial curing phase to ensure proper adhesion.
- Post-Curing (Optional): After the nail tips are securely attached, you can apply a base coat, gel polish, and top coat as desired. Cure each layer for 60 seconds.

Image: Recommended curing times for different types of nail tips using a UV/LED lamp.

Image: Guidance on suitable nail types for UNA GELLA UV Gel Nail Glue, emphasizing transparency for proper curing.
Video: Official UNA GELLA demonstration of gel nail glue application.
6. Maintenance and Removal
6.1. Longevity
With proper application and care, your nail tips can last 4 weeks or more. The solid gel glue is designed to be durable and chip-resistant, allowing for normal daily activities without issues.

Image: The durability of UNA GELLA nail glue during everyday tasks.
6.2. Removal
The UNA GELLA UV Gel Nail Glue is designed for easy soak-off removal without causing damage to your natural nails. To remove, soak your nails in acetone for an appropriate amount of time until the tips soften and can be gently pushed off. Avoid peeling or forcing the tips off, as this can damage your natural nails.
7. Troubleshooting
- Nail tips lifting or popping off:
- Ensure thorough nail preparation (buffing, dehydrator).
- Apply sufficient but not excessive glue gel.
- Maintain firm pressure on the nail tip during the initial curing phase.
- Verify correct curing times for your specific nail tip type (clear vs. colored/opaque).
- Ensure your UV/LED lamp is functioning correctly and has adequate power.
- Air bubbles under nail tips:
- Apply glue gel evenly and push the nail tip from the cuticle towards the free edge slowly and gently to squeeze out air.
- Ensure the nail tip size is appropriate for your natural nail.
- Glue not curing properly:
- Confirm you are using a UV/LED lamp. This glue requires UV/LED light to cure.
- Check the wattage of your lamp and ensure it meets the requirements for gel products.
- Increase curing time if necessary, especially for thicker applications or colored/opaque tips (though opaque tips are not recommended).
- Ensure the nail tips are clear or translucent, as UV rays cannot pass through opaque or dark-colored tips to cure the glue underneath.
8. Specifications
| Brand | UNA GELLA |
| Model Number | UG |
| Item Form | Gel |
| Color | Clear |
| Unit Count | 1.00 Fluid Ounces (20ml) |
| Material Type | Acrylic |
| Curing Required | UV/LED Lamp |
9. Warranty and Support
For any product inquiries, support, or warranty information, please contact UNA GELLA customer service through the retailer where the product was purchased or visit the official UNA GELLA store on Amazon: UNA GELLA Store.
Related Documents - UG
![]() |
Instruction Manual: CLAVUZ Nail Gel Polish Application and Safety Detailed instructions and safety precautions for applying LED/UV nail gel polish, including curing times and storage recommendations. Information for EU responsible person. |
![]() |
NAILED BY K Builder Nail Gel (UG23DR) - MSDS & Technical Specifications Comprehensive Material Safety Data Sheet (MSDS) and technical specifications for NAILED BY K Builder Nail Gel (UG23DR), covering composition, hazards, first aid, handling, storage, and regulatory information. |
![]() |
Wolfspeed CGD1700HB2M-UNA Gate Driver User Guide Comprehensive user guide for the Wolfspeed CGD1700HB2M-UNA dual-channel isolated gate driver, detailing features, specifications, operation, and safety precautions for SiC MOSFET applications. |
![]() |
Macnaught BOP Battery Operated Pumps Instruction Manual (20L/60L/205L) Comprehensive instruction manual for Macnaught BOP Battery Operated Pumps (20L, 60L, 205L models). Covers safety, operation, assembly, maintenance, troubleshooting, and specifications for these industrial and automotive fluid transfer pumps. |
![]() |
2013 Nissan JUKE Service Manual: Technical Guide and Repair Procedures Official service manual for the 2013 Nissan JUKE, providing comprehensive information on diagnostics, troubleshooting, wiring diagrams, maintenance, and repair procedures for automotive technicians. |
![]() |
STRONG LEAP UNA 2K TV-STICK User Manual This user manual provides comprehensive instructions for setting up, configuring, and using the STRONG LEAP UNA 2K TV-STICK. It covers features, troubleshooting, technical specifications, and safety information. |
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.





