MySmile LP211 Cordless Advanced Water Flosser User Manual

Introduction

The MySmile LP211 Cordless Advanced Water Flosser is designed to provide an effective and thorough oral cleaning experience. Utilizing advanced pump technology, it delivers a strong and stable water flow with pulses ranging from 2000 to 2800 times per minute and a pressure range of 40-150 PSI. This device is equipped with 5 cleaning modes and comes with 8 specialized jet tips to cater to various oral hygiene needs. Its cordless, rechargeable design and IPX7 waterproof rating ensure convenience and flexibility for daily use at home or while traveling.

What's in the Box

Your MySmile LP211 Cordless Advanced Water Flosser package includes the following items:

• 1 x MySmile LP211 Water Flosser Unit
• 4 x Standard Jet Tips
• 1 x Plaque Seek Tip
• 1 x Orthodontic Tip
• 1 x Periodontal Pocket Tip
• 1 x Tongue Cleaner Tip
• 1 x Portable Travel Storage Pouch
• 1 x USB Charging Cable

The MySmile LP211 Cordless Advanced Water Flosser, showcasing its sleek design and accompanying retail packaging.

An illustrative diagram detailing the various types of jet tips included with the MySmile LP211, each designed for specific oral care needs.

Setup

1. Charging the Device

Before first use, fully charge the water flosser. Connect the USB charging cable to the charging port located at the bottom of the device and plug the other end into a power adapter (not included). The battery indicator light will show charging status. A full charge provides approximately 30-35 days of use.

2. Filling the Water Reservoir

Open the reservoir fill door located at the bottom of the unit. Fill the 260ml reservoir with lukewarm water. Close the fill door securely to prevent leaks. The one-piece design minimizes the risk of accidental detachment during refilling.

3. Attaching a Jet Tip

Select the desired jet tip for your oral care needs. Insert the tip into the opening at the top of the flosser unit until it clicks into place. To remove, press the tip eject button and pull the tip out.

The MySmile LP211 Water Flosser unit alongside its array of interchangeable jet tips, ready for use.

Operating Instructions

1. Power On/Off

Press and hold the power button for 2 seconds to turn the device on or off.

2. Selecting a Cleaning Mode

Once powered on, press the 'M' (Mode) button to cycle through the 5 available cleaning modes: Strong, Normal, Soft, Pulse, and Child. An indicator light will illuminate next to the selected mode.

• Strong: For deep cleaning and stubborn plaque removal.
• Normal: Standard daily cleaning.
• Soft: Gentle cleaning for sensitive gums.
• Pulse: For gum massage and improved circulation.
• Child: Very gentle pressure suitable for children or very sensitive users.

3. Proper Usage Technique

Lean over a sink and place the jet tip into your mouth, aiming the tip at the gumline at a 90-degree angle. Close your lips slightly to prevent splashing but allow water to flow from your mouth into the sink. Move the tip along the gumline, pausing briefly between teeth to ensure thorough cleaning. Start with the lowest pressure setting and gradually increase as you become comfortable.

4. Specialized Tip Usage

• Standard Jet Tips (4 pieces): Ideal for general cleaning deep between teeth and below the gumline.
• Plaque Seek Tip (1 piece): Designed for areas prone to plaque accumulation, such as around dental implants, crowns, bridges, and permanent retainers.
• Orthodontic Tip (1 piece): Features a tapered brush head to effectively remove hard-to-reach plaque around orthodontic brackets and wires.
• Periodontal Pocket Tip (1 piece): With a slim and angled design, it provides gentle yet effective cleaning in periodontal pockets and along the gumline.
• Tongue Cleaner Tip (1 piece): Helps remove bacteria and debris from the surface of the tongue for improved oral hygiene and fresh breath.

A detailed view of the MySmile LP211 control panel, illustrating the five distinct cleaning modes.

An animated graphic showing the precise water jet effectively cleaning plaque and debris from between teeth and below the gumline.

Maintenance

1. Cleaning the Unit

After each use, empty any remaining water from the reservoir. Rinse the reservoir thoroughly with clean water. Wipe the exterior of the unit with a soft, damp cloth. Do not immerse the main unit in water beyond its IPX7 rating.

2. Cleaning Jet Tips

Remove the jet tip from the unit. Rinse the tip under running water. For deeper cleaning, tips can be soaked in a solution of 2 parts water to 1 part white vinegar for 5-10 minutes, then rinsed thoroughly.

3. Tip Replacement

It is recommended to replace jet tips every 3-6 months, depending on usage frequency, to ensure optimal performance and hygiene.

Troubleshooting

If you encounter any issues with your MySmile LP211 Water Flosser, please refer to the following general advice:

• No water flow: Ensure the reservoir is filled correctly and the jet tip is securely attached. Check if the unit is fully charged.
• Weak water pressure: Verify the selected cleaning mode is appropriate. Ensure the jet tip is not clogged.
• Device not turning on: Confirm the unit is charged. Try pressing and holding the power button for the recommended 2 seconds.

For persistent problems or specific technical support, please contact MySmile customer service.

Specifications

Warranty and Support

MySmile products are manufactured in an FDA-registered facility, ensuring safety and quality. For any questions, concerns, or support regarding your MySmile LP211 Cordless Advanced Water Flosser, please contact MySmile customer service. We are committed to providing assistance and ensuring your satisfaction.