G-Mac Concept Evo Motorcycle Helmet Visor Instruction Manual

Product Overview

This manual provides essential information for the proper installation, use, and maintenance of your G-Mac Concept Evo Motorcycle Helmet Replacement Visor. This genuine G-Mac replacement visor is specifically designed for the G-Mac Concept Evo Helmet, featuring an injection-moulded 3D design with an anti-scratch coating for enhanced durability and clarity.

Image: The G-Mac Concept Evo Replacement Visor, showing its curved, dark tint design with a yellow information sticker.

Setup and Installation

Installing your new G-Mac Concept Evo replacement visor is a quick and straightforward process. Ensure your helmet is clean and free of debris before installation.

1. Prepare the Helmet: Open the existing visor fully or remove it if you are replacing an old one. Consult your G-Mac Concept Evo helmet's original manual for specific visor removal instructions if needed.
2. Remove Protective Sticker: Before using the new visor, it is crucial to remove the yellow information sticker located on the visor surface. This sticker is for packaging and display purposes only and must be removed for clear vision.
3. Align the Visor: Carefully align the mounting points of the new replacement visor with the visor mechanism on your G-Mac Concept Evo helmet. The visor is designed for a precise fit.
4. Secure the Visor: Gently press the visor into place until it clicks securely into the helmet's mechanism on both sides. Ensure it is firmly attached and operates smoothly through its full range of motion.
5. Check Operation: Once installed, open and close the visor several times to confirm it moves freely and locks securely in both open and closed positions.

Image: A G-Mac Concept Evo helmet with a clear visor installed, demonstrating the type of helmet this replacement visor is compatible with.

Operating Instructions

Your G-Mac Concept Evo replacement visor is designed for optimal performance and clarity. It features an anti-scratch coating and is Pinlock ready (Pinlock insert not included).

• Visor Movement: The visor can be easily opened and closed using the tab located on the bottom edge. Ensure the visor is fully closed for maximum protection and aerodynamic performance.
• Anti-Scratch Coating: The injection-moulded 3D visor comes with an anti-scratch coating. While this coating provides significant protection against minor abrasions, it is not scratch-proof. Always handle the visor with care.
• Pinlock Readiness: This visor is designed to accept a Pinlock anti-fog insert (sold separately). If you wish to install a Pinlock, follow the instructions provided with your Pinlock insert. The visor has pre-drilled pins for easy installation.

Maintenance and Care

Proper care will extend the life and maintain the clarity of your visor.

• Cleaning: Clean the visor regularly with a soft, clean microfibre cloth and lukewarm water. For stubborn dirt or insects, soak the visor in lukewarm water for a few minutes to soften the debris before gently wiping it away.
• Avoid Harsh Chemicals: Do not use abrasive cleaners, solvents, or petroleum-based products (e.g., gasoline, paint thinner) as these can damage the anti-scratch coating and the visor material.
• Drying: Air dry the visor or gently pat it dry with a clean, soft cloth. Avoid rubbing vigorously.
• Storage: When not in use, store your helmet and visor in a clean, dry place away from direct sunlight and extreme temperatures. Avoid placing the visor face down on rough surfaces.

Troubleshooting

If you encounter issues with your G-Mac Concept Evo replacement visor, consider the following common solutions:

Specifications

Warranty and Support

For warranty information or technical support regarding your G-Mac Concept Evo Replacement Visor, please refer to the retailer where the product was purchased or visit the official G-Mac website. Keep your proof of purchase for any warranty claims.

For general inquiries or to explore other G-Mac products, you may visit the G-Mac Store on Amazon.