BlackZon Slyder ST Turbo 1/16 4WD 2S Monster Truck Instruction Manual

Introduction

This manual provides essential information for the safe and effective operation, setup, and maintenance of your BlackZon Slyder ST Turbo 1/16 4WD Electric Stadium Truck. Please read this manual thoroughly before operating the vehicle to ensure proper function and to prevent damage or injury.

Figure 1: BlackZon Slyder ST Turbo 1/16 4WD 2S Monster Truck, top-side view, showcasing its green body and aggressive tires.

The BlackZon Slyder ST Turbo is a high-performance remote-controlled vehicle designed for off-road racing and bashing. Its durable polycarbonate body and four-wheel drive system are engineered to handle rough terrain. This 1/16th scale truck is compact and agile, featuring a powerful electric motor for quick acceleration and speed, complemented by an adjustable suspension system for a smooth ride over various obstacles.

Safety Information

• Always operate the vehicle in open areas away from people, pets, and obstacles.
• Do not operate near public roads, water, or in crowded environments.
• Keep hands, hair, and loose clothing away from moving parts.
• Ensure the battery is fully charged before each use and disconnect it when not in use.
• Never leave charging batteries unattended.
• Use only the provided charger and battery type.
• Adult supervision is recommended for users under 14 years of age.
• Avoid operating in wet conditions to prevent damage to electronics.

Package Contents

Included in the Box:

• BlackZon Slyder ST Turbo 1/16 4WD Electric Stadium Truck
• 2.4GHz Radio Transmitter
• 2S 7.4V 1000mAh LiPo Battery with T-Plug connector
• USB Charger
• Front LED Lights (requires installation)
• Wheelie Bar (requires installation)

Required for Operation (Not Included):

• 4 x AA Batteries for Transmitter

Setup

1. Charging the LiPo Battery

1. Connect the 2S 7.4V 1000mAh LiPo battery to the included USB charger.
2. Plug the USB charger into a compatible USB power source (e.g., computer USB port, USB wall adapter).
3. Monitor the charging process. The indicator light on the charger will typically show red during charging and turn green when fully charged.
4. Once fully charged, disconnect the battery from the charger. Never overcharge LiPo batteries.

2. Installing Transmitter Batteries

1. Open the battery compartment on the bottom of the 2.4GHz radio transmitter.
2. Insert 4 AA batteries, ensuring correct polarity (+/-).
3. Close the battery compartment securely.

3. Installing Optional Accessories (LED Lights & Wheelie Bar)

The front LED lights and wheelie bar are included in the box and can be installed if desired. Refer to the diagrams in the separate assembly guide (if provided) for specific installation steps. Generally, the LED lights connect to a designated port on the ESC/receiver unit, and the wheelie bar attaches to the rear chassis.

Figure 2: Underside view of the BlackZon Slyder ST Turbo chassis, revealing the motor, battery compartment, and suspension components.

Operating Instructions

1. Powering On

1. Ensure the vehicle's battery is securely connected and placed in its compartment.
2. Turn on the transmitter first. The power indicator light should illuminate.
3. Next, turn on the power switch on the vehicle. The vehicle's electronics will initialize, and you may hear a series of beeps.
4. If the vehicle and transmitter do not link automatically, refer to the binding procedure in the troubleshooting section or a separate binding guide.

2. Basic Controls

• Throttle Trigger: Pull the trigger to accelerate forward. Push the trigger forward to brake, then push again for reverse.
• Steering Wheel: Turn the wheel left or right to steer the vehicle.
• Speed Limiter Dial: Located on the transmitter, this dial allows you to adjust the maximum speed of the vehicle. Turn clockwise for higher speed, counter-clockwise for lower speed. This is useful for beginners or when operating in smaller spaces.
• Steering D/R (Dual Rate): Adjusts the maximum steering angle. Useful for fine-tuning steering response.

3. Driving Tips

• Start with the speed limiter set to a lower setting until you are comfortable with the controls.
• Practice steering and throttle control in an open, clear area.
• Avoid sudden, sharp turns at high speeds to prevent rollovers.
• Be mindful of battery life. When the vehicle starts to slow down significantly, it's time to recharge.

4. Powering Off

1. Turn off the vehicle's power switch first.
2. Then, turn off the transmitter.
3. Disconnect the battery from the vehicle for storage.

Maintenance

Regular Checks:

• After Each Run: Inspect the vehicle for any loose screws, damaged parts, or debris. Clean off dirt and dust.
• Wheels and Tires: Check for wear, tears, or punctures. Ensure wheel nuts are tight.
• Suspension: Verify that shocks are functioning smoothly and that suspension arms are not bent or broken.
• Drivetrain: Inspect the spur gear for damage and ensure it's free of debris. Check metal rear drive shafts for bends or wear.
• Electronics: Ensure all wires are securely connected and free from damage. Keep electronics dry.

Battery Care:

• Store LiPo batteries in a cool, dry place, away from direct sunlight and extreme temperatures.
• Do not store fully charged or fully discharged LiPo batteries for extended periods. Charge them to a storage voltage (typically around 3.8V per cell) if storing for more than a few days.
• Never puncture or damage LiPo batteries. Dispose of damaged batteries safely according to local regulations.

Troubleshooting

Specifications

• Scale: 1/16th
• Drive: 4WD - Shaft Driven
• Motor: 3800KV Brushless Motor
• ESC/Receiver: 2-in-1 Brushless ESC/Receiver (2S LiPo Max Capable)
• Battery: 2S 7.4V 1000mAh LiPo w/ T-Plug connector
• Radio System: 2.4GHz
• Suspension: Independent Double Wishbone, Adjustable Coilover Shocks
• Differentials: 4-Gear (Front & Rear)
• Steering: Dual Point Bell Crank System with Built-in Servo Saver
• Chassis Features: Covered Spur Gear, Metal Rear Drive Shafts, Ball Bearings throughout
• Electronics: Splashproof
• Length: 270 mm (10.62 inches)
• Width: 215 mm (8.4 inches)
• Height: 130 mm (5.11 inches)
• Wheelbase: 175 mm
• Weight: Approximately 1 pound

Warranty and Support

BlackZon products are manufactured to high standards. For warranty information, technical support, or replacement parts, please contact BlackZon customer service through their official website or your retailer. Keep your proof of purchase for warranty claims.