Introduction
Thank you for choosing the NICRON B60 Flashlight. This manual provides essential information for the safe and effective operation, maintenance, and troubleshooting of your new flashlight. Please read it thoroughly before use and retain it for future reference.
Image: The NICRON B60 flashlight, showcasing its compact design and included USB-C charging cable.
Safety Information
- Do not shine the flashlight directly into eyes. The high lumen output can cause temporary vision impairment.
- Keep out of reach of children.
- Do not disassemble the flashlight beyond what is instructed in this manual. Unauthorized modifications may damage the device and void the warranty.
- Use only the specified battery type and charging method.
- Avoid exposing the flashlight to extreme temperatures or direct sunlight for prolonged periods.
Package Contents
- NICRON B60 Flashlight
- 1 x Lithium Ion Battery (pre-installed)
- USB Type-C Charging Cable
- Wrist Strap
- Spare USB Port Cover / O-ring (may vary by package)
Setup
- Battery Installation: The flashlight comes with a pre-installed battery. Before first use, unscrew the tail cap and remove the small plastic insulating disc from between the battery and the contact point. Re-screw the tail cap firmly.
- Initial Charging: For optimal performance, fully charge the flashlight before first use.
- Locate the USB Type-C charging port on the side of the flashlight, usually covered by a rubber flap.
- Connect the provided USB Type-C cable to the flashlight and the other end to a compatible USB power source (e.g., power bank, laptop, car charger, wall adapter).
- The indicator light under the switch button will show red during charging and turn green when fully charged.
Image: The NICRON B60 flashlight connected via USB-C for charging, with indicators for charging status.
Operating Instructions
The NICRON B60 features a single metal smart switch button for all operations.
- Turning On/Off: Press and hold the switch button for approximately 1-2 seconds to turn the flashlight ON or OFF. This prevents accidental activation.
- Changing Brightness Modes: Once the flashlight is ON, tap the switch button repeatedly to cycle through the brightness modes: Low → Med → High → MAX.
- Strobe Mode: From any brightness mode, press and hold the switch button for approximately 2 seconds to activate Strobe mode.
- SOS Mode: While in Strobe mode, tap the switch button to switch to SOS mode.
- Return to Normal Mode: From Strobe or SOS mode, tap the button to return to the last used normal brightness mode.
Image: Visual guide demonstrating the button operations for turning on/off, cycling modes, and activating Strobe/SOS functions.
Image: Illustration of the flashlight's various brightness levels (Max, High, Med, Low, Strobe, SOS) and its maximum beam range of 500 meters.
Maintenance
- Cleaning: Wipe the flashlight with a clean, soft cloth. For stubborn dirt, use a slightly damp cloth. Do not use abrasive cleaners or solvents.
- Lubrication: Periodically apply silicone grease to the O-rings and screw threads to maintain water resistance and smooth operation.
- Battery Care: If storing the flashlight for an extended period, remove the battery to prevent leakage. Recharge the battery every 3-6 months to maintain its lifespan.
- Water Resistance: The B60 is IPX8 water resistant, meaning it can withstand temporary submersion. Ensure the USB port cover is securely closed before exposing it to water.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Flashlight does not turn on. | Battery is dead or not properly installed. | Charge the battery. Ensure the plastic insulating disc is removed and the battery is inserted correctly. Tighten the tail cap. |
| Light output is dim. | Low battery. | Recharge the battery. |
| Cannot change modes. | Button malfunction or software issue. | Ensure the button is clean and free of debris. Try turning the flashlight off and on again. If the issue persists, contact customer support. |
| Water ingress. | USB port cover not sealed or O-rings damaged. | Ensure the USB port cover is fully closed. Check O-rings for damage and replace if necessary. |
Specifications
| Feature | Detail |
|---|---|
| Brand | NICRON |
| Model | B60 |
| Brightness | 1400 Lumens (Max) |
| Light Source Type | LED (Luminus LED) |
| Beam Distance | 500 Meters |
| Material | Aluminum Alloy |
| Water Resistance Level | IPX8 |
| Power Source | Battery Powered (1 Lithium Ion battery included) |
| Battery Type | 18650 Lithium-Ion (2600mAh internal battery) |
| Charging Port | USB Type-C |
| Runtime (Max Mode) | 2.5 hours |
| Runtime (Longest) | 18 hours |
| Product Dimensions | 1.63"D x 1.61"W x 6.05"H |
| Item Weight | 5.9 ounces (166.5 Grams without battery) |
Warranty and Support
NICRON products are designed for durability and performance. For specific warranty details, please refer to the warranty card included with your product or visit the official NICRON website. Standard return policy is 30 days for refund/replacement.
For technical support, troubleshooting assistance, or warranty claims, please contact the seller directly:
Seller: Nicron
Support Link: Contact Nicron Seller Support
