LUCORB 15

LUCORB Gym Timer Remote Control Instruction Manual

Model: 15

1. Introduction

This manual provides comprehensive instructions for the proper use and maintenance of your LUCORB Gym Timer Remote Control. Please read this manual thoroughly before operating the device to ensure correct functionality and to prevent damage.

Compatibility Note: This remote controller is specifically designed as a replacement for the LUCORB 15-inch large display wall-mounted gym timer. It is not compatible with other brands or models of gym timers. Please verify that your existing remote matches the images provided in this manual before use.

2. Safety Information

  • Keep the remote control away from water and excessive moisture.
  • Do not expose the remote to direct sunlight or extreme temperatures.
  • Use only AAA batteries as specified. Do not mix old and new batteries or different types of batteries.
  • Dispose of used batteries according to local regulations.
  • Do not attempt to disassemble or repair the remote control yourself. Contact customer support if issues arise.

3. Package Contents

  • 1 x LUCORB Gym Timer Remote Control
  • Note: AAA batteries are not included and must be purchased separately.

4. Product Overview

The LUCORB Gym Timer Remote Control is designed for intuitive operation of your compatible gym timer. Its ergonomic design and clearly labeled buttons allow for quick and efficient control over various timer functions.

LUCORB Gym Timer Remote Control, angled view

Figure 4.1: Angled view of the LUCORB Gym Timer Remote Control, showcasing its compact design and button layout.

Refer to the diagram below for a detailed layout of the remote control buttons and their corresponding functions.

LUCORB Gym Timer Remote Control with labeled buttons

Figure 4.2: Detailed diagram of the LUCORB Gym Timer Remote Control with each button clearly labeled for its function.

Button Functions

Button LabelFunction
ON/OFF (Red Power Button)Powers the timer on or off.
DNCountdown mode.
UPCount Up mode.
STStopwatch mode.
TATABATA interval timer mode.
HIITHigh-Intensity Interval Training mode.
FGB1Fight Gone Bad 1 interval timer mode.
FGB2Fight Gone Bad 2 interval timer mode.
10sActivates 10-second preparation time.
Music Note IconAdjusts optional tone type.
Speaker IconAdjusts volume.
Loop IconActivates Loop Countdown (EMOM).
Play/Pause IconStarts, pauses, or resumes the timer.
Skip IconAdjusts countdown time before the end.
Up ArrowPage Up / Increase value.
Down ArrowPage Down / Decrease value.
Left ArrowLeft Shift / Navigate left.
Right ArrowRight Shift / Navigate right.
OKConfirms selection or setting.
Pencil IconEdit function.
Trash Can IconDelete function.
1 P1 to 9 P9Programmable Plans (P1-P9) selection.
Alarm Clock IconActivates Alarm Clock settings.
12/24HToggles between 12-hour and 24-hour time format.
Clock IconAccesses Time Clock settings.
Brightness IconAdjusts display brightness.

5. Setup

5.1 Battery Installation

The remote control requires two (2) AAA batteries (not included) for operation.

  1. Locate the battery compartment cover on the back of the remote control.
  2. Slide the cover downwards or press the latch (if present) to open the compartment.
  3. Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
  4. Replace the battery compartment cover until it clicks securely into place.

After battery installation, the remote is ready to be used with your LUCORB 15-inch gym timer.

LUCORB Remote Control pointing at a gym timer

Figure 5.1: The remote control being used to operate a LUCORB gym timer, demonstrating its intended function.

6. Operating Instructions

Ensure the gym timer is powered on and within range of the remote control. Point the remote directly at the timer for optimal signal transmission.

6.1 Power On/Off

  • Press the ON/OFF (red power) button to turn the gym timer on or off.

6.2 Adjusting Volume and Brightness

  • Press the Speaker Icon button to cycle through volume levels or mute the timer.
  • Press the Brightness Icon button to adjust the display brightness of the gym timer.

6.3 Timer Modes

Select the desired timer mode by pressing the corresponding button:

  • DN (Countdown): Initiates a countdown from a set time. Use arrow keys to set time, then OK and Play/Pause.
  • UP (Count Up): Starts counting upwards from zero. Press Play/Pause to start/stop.
  • ST (Stopwatch): Functions as a stopwatch. Press Play/Pause to start/stop.
  • TA (TABATA): Activates the TABATA interval protocol (e.g., 20s work, 10s rest, 8 rounds).
  • HIIT (High-Intensity Interval Training): Engages HIIT specific interval settings.
  • FGB1 / FGB2 (Fight Gone Bad): Selects pre-programmed Fight Gone Bad interval routines.

6.4 General Operation

  • 10s: Press to add a 10-second preparation time before a workout begins.
  • Music Note Icon: Cycles through available tone types for alerts and beeps.
  • Loop Icon: Activates or deactivates the Loop Countdown (EMOM - Every Minute On the Minute) function.
  • Play/Pause Icon: Starts, pauses, or resumes any active timer or program.
  • Skip Icon: Adjusts the countdown time before the end of an interval or program.
  • Arrow Keys (Up, Down, Left, Right): Used for navigation, adjusting values, or shifting between digits during setup.
  • OK: Confirms selections or saves settings.
  • Pencil Icon (Edit): Enters edit mode for modifying timer settings or programmable plans.
  • Trash Can Icon (Delete): Deletes selected settings or programmable plans.

6.5 Programmable Plans (P1-P9)

  • The buttons labeled 1 P1 through 9 P9 allow you to select and activate pre-saved or custom programmable workout plans.
  • To program a plan, enter edit mode using the Pencil Icon, configure your desired intervals, and then save it to one of the P1-P9 slots using the OK button.

6.6 Alarm Clock and Time Clock

  • Press the Alarm Clock Icon to access and set alarm functions on the gym timer.
  • Press the Clock Icon to view or adjust the current time displayed on the gym timer.
  • Use the 12/24H button to switch between 12-hour and 24-hour time formats.

7. Maintenance

7.1 Cleaning

  • Wipe the remote control with a soft, dry cloth.
  • Do not use abrasive cleaners, solvents, or chemical sprays, as these can damage the surface or internal components.

7.2 Battery Replacement

  • If the remote control's range decreases or it becomes unresponsive, replace the batteries as described in Section 5.1.
  • Always replace both batteries at the same time.

8. Troubleshooting

  • Remote not responding:
    • Check if the batteries are inserted correctly and have sufficient charge. Replace if necessary.
    • Ensure there are no obstructions between the remote and the gym timer.
    • Confirm the remote is pointed directly at the timer's receiver.
  • Limited range:
    • Replace the batteries with fresh ones.
    • Ensure no strong light sources (like direct sunlight) are interfering with the infrared signal.
  • Incorrect timer response:
    • Verify that this remote is indeed for the LUCORB 15-inch gym timer and not another model or brand.
    • Refer to your gym timer's specific instruction manual for detailed programming steps.

9. Specifications

  • Brand: LUCORB
  • Model Number: 15
  • Material: Plastic
  • Color: Black
  • Product Dimensions: 5.5 x 1.6 x 0.6 inches (13.97 x 4.06 x 1.52 cm)
  • Item Weight: 1.2 ounces (34 grams)
  • Battery Type: 2 x AAA (not included)

10. Warranty and Support

For warranty information, technical support, or any inquiries regarding your LUCORB Gym Timer Remote Control, please contact LUCORB customer service through the official channels provided with your original product purchase or via the LUCORB brand store on Amazon.

Related Documents - 15

Preview LUCORB Interval Workout Timer Welcome Guide
A comprehensive welcome guide for the LUCORB Interval Workout Timer, covering product features, operating instructions, FAQs, and warranty information. Learn how to use various modes, set alarms, and charge your device.
Preview BN-LINK BNH-60/U92 Mechanical Countdown Timer - Specifications and Features
Detailed specifications, features, ratings, and packing information for the BN-LINK BNH-60/U92 mechanical countdown timer. Ideal for indoor use with a 12-hour countdown and 15-minute setting interval.
Preview Intermatic E-1020 24-Hour Automatic In-Wall Timer: Installation and Operation Guide
Comprehensive guide for installing and operating the Intermatic E-1020 24-hour automatic in-wall multiple program timer. Includes step-by-step instructions, wiring diagrams, and warranty details.
Preview TickTime Hexagonal Focus Timer User Manual - Setup and Operation Guide
Comprehensive user manual for the TickTime hexagonal focus timer. Learn how to set up, use quick and custom countdowns, operate the stopwatch function, manage charging, and adjust volume. Includes product overview and manufacturer details.
Preview Intermatic HB31K Outdoor Plug-in Timer: Installation, Operation, and Safety Guide
Comprehensive guide for the Intermatic HB31K outdoor plug-in timer. Learn about installation, operation, safety precautions, and warranty information for this 15 Amp, 125V timer.