1. Introduction
This user manual provides essential information for the proper use, installation, and maintenance of the Makita 1910R3-2 Disposal Bags. These bags are designed specifically for use with Makita Cordless Vacuum Cleaners models VC006GM and VC007GL, ensuring efficient dust collection and easy disposal.
2. Product Overview
The Makita 1910R3-2 Disposal Bags are high-quality plastic bags intended for single-use dust collection in compatible Makita vacuum cleaners. Each package contains 10 disposal bags, providing a convenient and hygienic solution for managing collected debris.
Figure 2.1: A single Makita 1910R3-2 Disposal Bag, shown folded flat. This image illustrates the general appearance of the plastic disposal bag.
These bags are crucial for maintaining the performance of your vacuum cleaner and preventing dust from escaping back into the environment during operation and disposal.
3. Safety Instructions
- Always ensure the vacuum cleaner is turned off and unplugged (or battery removed) before installing or removing disposal bags.
- Do not attempt to wash or reuse disposal bags. They are designed for single use.
- Keep disposal bags out of reach of children and pets to prevent accidental suffocation.
- Dispose of used bags according to local waste disposal regulations.
- Do not vacuum hazardous materials, hot ashes, or liquids with these bags unless the vacuum cleaner is specifically designed for such use and the bags are rated for it.
4. Setup (Bag Installation)
Follow these steps to properly install a new Makita 1910R3-2 Disposal Bag into your compatible Makita Cordless Vacuum Cleaner (VC006GM or VC007GL):
- Prepare the Vacuum Cleaner: Ensure the vacuum cleaner is powered off and the battery pack is removed to prevent accidental startup.
- Open the Dust Compartment: Locate and open the dust compartment cover on your vacuum cleaner. Refer to your vacuum cleaner's specific user manual for instructions on opening its dust compartment.
- Remove Old Bag (if applicable): If a used bag is present, carefully remove it by pulling it away from the inlet port. Seal the opening of the used bag to prevent dust leakage before disposal.
- Insert New Bag: Take a new Makita 1910R3-2 Disposal Bag. Align the bag's opening with the inlet port inside the dust compartment. Push the bag firmly onto the inlet port until it is securely seated. Ensure the bag is fully unfolded inside the compartment and does not obstruct the closing mechanism.
- Close the Dust Compartment: Carefully close the dust compartment cover, ensuring it latches securely. Do not force the cover if it feels obstructed; recheck the bag's positioning.
- Verify Installation: Before operating, gently shake the vacuum cleaner to ensure the bag is stable and properly installed.
5. Operating
Once the disposal bag is correctly installed, you can operate your Makita Cordless Vacuum Cleaner as usual. The bag will collect dust and debris, preventing it from entering the motor or being recirculated into the air.
- Monitor the vacuum cleaner's performance. A decrease in suction power often indicates that the disposal bag is full and needs replacement.
- Avoid overfilling the bag, as this can reduce suction efficiency and potentially damage the vacuum cleaner.
6. Maintenance (Bag Replacement)
Regular replacement of the disposal bag is essential for optimal vacuum cleaner performance and hygiene.
- Identify Full Bag: Replace the disposal bag when suction power noticeably decreases, or if your vacuum cleaner has an indicator for a full bag.
- Power Off: Turn off the vacuum cleaner and remove the battery pack.
- Open Compartment: Open the dust compartment cover.
- Remove and Seal: Carefully detach the full bag from the inlet port. Most bags have a self-sealing mechanism or a flap to close the opening. Ensure it is sealed to contain dust.
- Dispose: Place the sealed, used bag directly into a waste bin. Do not empty and reuse.
- Install New Bag: Follow the "Setup (Bag Installation)" instructions in Section 4 to install a new Makita 1910R3-2 Disposal Bag.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Reduced Suction Power | Disposal bag is full. | Replace the disposal bag with a new one. |
| Reduced Suction Power | Disposal bag is not properly installed. | Re-install the disposal bag, ensuring it is securely attached to the inlet port and fully unfolded. |
| Dust Leakage from Vacuum | Disposal bag is damaged or not sealed. | Replace the damaged bag immediately. Ensure the bag is properly sealed upon removal. |
| Bag does not fit | Incorrect bag model for your vacuum cleaner. | Verify your vacuum cleaner model (VC006GM or VC007GL) and ensure you are using genuine Makita 1910R3-2 disposal bags. |
8. Specifications
- Model Number: 1910R3-2
- Brand: Makita
- Compatible Vacuum Cleaners: Makita VC006GM, Makita VC007GL
- Material: Plastic (Kunststoff)
- Package Contents: 10 disposal bags
- Item Weight (Package): Approximately 1.58 pounds (0.72 kg)
- Product Dimensions (Package): Approximately 6.3 x 5.51 x 10.24 inches (16 x 14 x 26 cm)
9. Warranty and Support
For information regarding warranty coverage for Makita accessories, please refer to the warranty documentation provided with your Makita vacuum cleaner or visit the official Makita website. For technical support or inquiries about the 1910R3-2 Disposal Bags, please contact Makita customer service directly.
You can find contact information and additional resources on the official Makita website: www.makitatools.com
