Introduction
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your BLACK+DECKER BCED37 Compact Dryer and BWDS Washer Dryer Stacking Rack. Designed for smaller living spaces, this compact laundry solution offers convenience and functionality. Please read all instructions thoroughly before use to ensure proper performance and safety.
Important Safety Instructions
To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including:
- Read all instructions before using the appliance.
- Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances as they give off vapors that could ignite or explode.
- Do not allow children to play on or in the appliance. Close supervision of children is necessary when the appliance is used near children.
- Do not reach into the appliance if the drum is moving.
- Do not install or store this appliance where it will be exposed to the weather.
- Do not tamper with controls.
- Clean lint screen before or after each load.
- Do not use heat to dry articles containing feathers or down.
- Always disconnect the appliance from the power supply before cleaning or servicing.
Package Contents
- BLACK+DECKER BCED37 Compact Dryer
- BLACK+DECKER BWDS Washer Dryer Stacking Rack
- Dryer Vent Hose (4-inch diameter)
- Exhaust Connector
- Lint Filter and Exhauster Filters
- Adjustable Leveling Legs (for dryer)
- Anti-Tip Brackets (for stacking rack)
Setup and Installation
Compact Dryer Installation
Place the compact dryer on a stable, level surface. Ensure adequate clearance around the unit for proper ventilation. The dryer operates on a standard 120V electrical outlet with a 3-prong plug. Connect the provided 4-inch diameter vent hose to the exhaust connector at the rear of the dryer. Route the vent hose to an appropriate exhaust point, ensuring it is not kinked or obstructed.

Stacking Rack Installation (BWDS)
The BWDS Stacking Rack is designed to save space by allowing you to place your compact dryer above a compatible portable washer. It is compatible with BLACK+DECKER portable washers BPWM09W, BPWM16W, and BPWM20W, and other washers with a footprint of 22.7” W x 21.5” D. The rack can hold dryers up to 60 lbs. Assembly requires a screwdriver and drill for anti-tip bracket installation.
- Assemble the stacking rack components according to the included instructions.
- Ensure the rack is placed on a stable, level surface.
- Anchor the rack to a wall using the provided anti-tip brackets to prevent accidental tipping.
- Carefully lift and place the compact dryer onto the designated shelf space of the rack.
- The bottom washer space has a height of 48.8 inches.



Video: Overview of the BLACK+DECKER Compact Dryer. This video provides a visual demonstration of the compact dryer, highlighting its features and compact size suitable for various living arrangements.
Operating Instructions
Dryer Controls
The dryer features an intuitive control panel for selecting drying options.

- Timer Dial: Set desired drying time from 30 to 200 minutes.
- Sensor Dry: Activates the sensor to measure moisture levels and automatically adjust drying time.
- Mode Button: Select from Air Dry, Cool, Warm, and Hot drying modes.
Drying Modes and Load Recommendations
The dryer has a load volume capacity of 13.2 lbs. For optimal drying results, especially with heavier items, it is recommended to use smaller loads.
- Regular Loads (T-shirts, light garments): Typically dry within 60-90 minutes.
- Heavy Loads (Towels, blankets): May require longer drying times (up to 1.5-2 hours) and smaller load sizes for thorough drying.
- Air Dry: For delicate items or refreshing clothes without heat.
- Cool/Warm/Hot: Adjust heat setting based on fabric type and desired drying speed.

Maintenance
Lint Filter Cleaning
Regular cleaning of the lint filter is crucial for maintaining drying efficiency and preventing fire hazards. Clean the lint filter before or after every load.
- Open the dryer door.
- Locate the lint filter at the back of the drum.
- Gently pull the filter out.
- Remove any accumulated lint by hand or with a soft brush.
- Reinsert the clean lint filter securely into its position.
General Cleaning
Wipe the exterior of the dryer with a soft, damp cloth. Periodically clean the interior of the drum with a mild detergent and water solution, then wipe dry.
Troubleshooting
If you encounter issues with your dryer, refer to the following common solutions:
- Dryer not starting: Check if the power cord is securely plugged in and if the circuit breaker has tripped. Ensure the door is fully closed.
- Clothes not drying properly: Verify the lint filter is clean. Reduce load size. Select a higher heat setting or longer drying time. Ensure the vent hose is not blocked.
- Unusual noises: Check for foreign objects in the drum. Ensure the dryer is level and stable.
For persistent issues, contact customer support.
Product Specifications
| Feature | Specification |
|---|---|
| Manufacturer | BLACK+DECKER |
| Dryer Model | BCED37 |
| Stacking Rack Model | BWDS |
| Dryer Dimensions (W x D x H) | 23.6 x 21.5 x 27.5 inches |
| Dryer Capacity | 3.5 Cu. Ft (13.2 lbs) |
| Dryer Power | 1500W, 120V |
| Drying Modes | Air Dry, Cool, Warm, Hot |
| Special Features | Overheat Protection, Sensor Dry, Adjustable Leveling Legs |
| Stacking Rack Dimensions (W x D x H) | 24.6 x 25.7 x 50.8 inches |
| Stacking Rack Dryer Shelf Space (W x D) | 24.6 x 21.4 inches |
| Stacking Rack Washer Clearance Height | 48.8 inches |
| Stacking Rack Max Dryer Weight | 60 lbs |
Warranty and Customer Support
The BLACK+DECKER BCED37 Compact Dryer and BWDS Washer Dryer Stacking Rack come with a 1-year warranty. For warranty claims, technical assistance, or general inquiries, please refer to the contact information provided in your product packaging or visit the official BLACK+DECKER website.







