Introduction
This manual provides essential instructions for the safe and effective use of your GP ReCyko 1300 AA Ni-Mh rechargeable batteries. These batteries are designed for high performance and long life, offering a sustainable power solution for various electronic devices.
Please read this manual thoroughly before using the batteries and retain it for future reference.
Safety Information
To prevent personal injury or damage to your batteries and devices, observe the following safety precautions:
- Do not disassemble, open, or shred battery cells or packs.
- Do not short-circuit a battery. Do not store batteries haphazardly in a box or drawer where they may short-circuit each other or be short-circuited by other metal objects.
- Do not expose batteries to heat or fire. Avoid storage in direct sunlight.
- Do not subject batteries to mechanical shock.
- In the event of a battery leaking, do not allow the liquid to come into contact with skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.
- Do not use any charger other than that specifically provided for use with the equipment.
- Observe the plus (+) and minus (-) marks on the battery and equipment to ensure correct usage.
- Keep batteries out of reach of children.
- Seek medical advice immediately if a battery has been swallowed.
- Always purchase the correct size and grade of battery most suitable for the intended use.
- Clean the battery contacts and also those of the device prior to battery installation.
- Remove batteries from equipment when not in use for extended periods.
- Dispose of batteries properly at designated collection points. Do not dispose of in household waste.
Setup
Your GP ReCyko 1300 AA Ni-Mh batteries are pre-charged and ready to use upon purchase. However, for optimal performance and to ensure a full charge, it is recommended to fully charge them before their first use.
- Unpack the Batteries: Carefully remove the batteries from their packaging.
- Insert into Charger: Place the batteries into a compatible Ni-Mh battery charger, ensuring correct polarity (+ and - terminals match).
- Charge Fully: Allow the batteries to charge until the charger indicates they are full. Charging times vary depending on the charger model.
- Install in Device: Once charged, insert the batteries into your electronic device, again observing correct polarity.
Operating Instructions
These GP ReCyko AA Ni-Mh batteries are suitable for a wide range of devices requiring AA batteries, including:
- Cameras and Camera Flashes
- Gaming Controllers
- Photographic Lighting Equipment
- Remote Control Vehicles
- TV Remotes and other household electronics
To operate, simply insert the fully charged batteries into your device, ensuring the positive (+) and negative (-) terminals align correctly with the device's battery compartment markings. Close the battery compartment, and the device should be ready for use.
Maintenance
Charging
Always use a charger specifically designed for Ni-Mh batteries. Overcharging or using an incompatible charger can damage the batteries and pose a safety risk. The batteries can be recharged up to 500 times.
Storage
For optimal battery life, store unused batteries in a cool, dry place, away from direct sunlight and extreme temperatures. Avoid storing them with metal objects that could cause a short circuit. These batteries maintain up to 80% charge after 12 months of storage.
Operating Temperature
The batteries are designed to operate reliably in temperatures ranging from -20°C to +50°C (-4°F to +122°F).
Disposal
Do not dispose of batteries in general household waste. Ni-Mh batteries contain recyclable materials. Please dispose of them at an authorized battery recycling facility in accordance with local regulations.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not power on. | Batteries are not charged or incorrectly inserted. | Ensure batteries are fully charged and inserted with correct polarity. Clean battery contacts if necessary. |
| Batteries do not hold charge for long. | Batteries are old, frequently deep-discharged, or charger is faulty. | Ensure you are using a compatible and functional Ni-Mh charger. If batteries are very old, consider replacement. Avoid frequent deep discharge cycles. |
| Batteries become hot during charging. | Normal for some warmth, but excessive heat indicates an issue. | Ensure proper ventilation around the charger. If heat is excessive, discontinue charging and check the charger and batteries for damage. |
Specifications
- Battery Type: Ni-Mh (Nickel-Metal Hydride)
- Size: AA
- Capacity: 1300mAh
- Voltage: 1.2V
- Cycle Life: Up to 500 cycles
- Low Self-Discharge: Retains up to 80% charge after 12 months
- Operating Temperature: -20°C to +50°C (-4°F to +122°F)
- Recycled Materials: Made of more than 10% recycled materials
- Weight: Approximately 23g per battery
- Model Number: GPRCK130AA611C4
Warranty Information
GP products are manufactured to high-quality standards. For specific warranty details, please refer to the warranty card included with your purchase or visit the official GP website. Keep your proof of purchase for any warranty claims.
Customer Support
For further assistance, technical support, or inquiries regarding your GP ReCyko batteries, please contact GP customer service through their official website or the contact information provided on the product packaging.
Thank you for choosing GP ReCyko batteries.