Traxxas XRT Body 7899 Instruction Manual

1. Introduction

This manual provides essential information for the proper installation, use, and maintenance of your Traxxas XRT Body 7899. The Traxxas XRT Body is a tough polycarbonate body featuring ProGraphix paint and pre-applied decals, designed for the Traxxas XRT model. It comes fully-assembled and ready to mount with pre-installed front and rear body supports, roof, and hood skids.

2. Safety Information

Always exercise caution when handling RC components. Keep all small parts and packaging materials away from children. This product is specifically designed for use with the Traxxas XRT model. Ensure all components are securely fastened before operating your vehicle to prevent injury or damage.

3. Package Contents

Verify that all items listed below are present in your package:

• Assembled Traxxas XRT Body (ProGraphix RNR)
• Pre-installed Front Body Supports
• Pre-installed Rear Body Supports
• Pre-installed Roof Skid Pad
• Pre-installed Hood Skid Pads

4. Setup and Installation

The Traxxas XRT Body 7899 is designed for straightforward installation on your Traxxas XRT chassis. Follow these steps:

1. Ensure your Traxxas XRT vehicle is powered off and the battery is disconnected.
2. Carefully remove the existing body from your XRT chassis, if applicable.
3. Align the new XRT Body 7899 with the body mounts on your chassis. The pre-installed front and rear body supports will guide the body into position.
4. Gently press the body down until it securely latches onto the body mounts. Ensure all four corners are properly seated.
5. Verify that the body is firmly attached and does not wobble.

This image displays the fully assembled Traxxas XRT Body 7899, highlighting the pre-installed front and rear body supports, roof skid, and hood skids, ready for mounting on the Traxxas XRT chassis.

5. Operating Instructions

Once the body is securely installed, you can operate your Traxxas XRT as usual. Periodically check the body mounts for any signs of wear or damage, especially after impacts. The pre-installed skid pads offer additional protection during use.

6. Maintenance

Proper maintenance will extend the life and appearance of your XRT Body 7899:

• Cleaning: After use, wipe the body with a soft, damp cloth to remove dirt and debris. Avoid using harsh chemicals or abrasive cleaners, as these can damage the paint and decals.
• Inspection: Regularly inspect the body for cracks, tears, or damage, especially around the mounting points and skid pads. Replace the body if significant damage is present to maintain vehicle performance and protection.
• Storage: Store the body in a cool, dry place away from direct sunlight when not in use to prevent material degradation and fading of the paint.

7. Troubleshooting

This section addresses common issues you might encounter:

• Body does not fit correctly: Ensure the body is oriented correctly and that no debris is obstructing the body mounts. Check if the chassis components are properly aligned.
• Body becomes loose during operation: Verify that the body is fully seated on all mounts. Inspect the body mounts on the chassis for wear or damage.
• Paint or decals peeling: This can occur from impacts or prolonged exposure to harsh conditions. While the ProGraphix paint is durable, extreme conditions can affect it. Consider protective films if desired.

8. Specifications

9. Warranty and Support

For detailed warranty information, technical support, or to purchase replacement parts, please visit the official Traxxas website or contact their customer service department directly. Keep your purchase receipt as proof of purchase.