Introduction
This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your Dapper Supply Battery Powered Floor Scrubber. Designed for effective floor care, this machine features a wide 20-inch cleaning path and large capacity solution and recovery tanks. It is powered by a 3/4 peak horsepower brush motor offering 220 RPM, incorporating soft-start technology for extended lifespan. Please read this manual thoroughly before initial use.
Key Features
- Powerful Cleaning: 220 RPM brush speed for efficient cleaning performance.
- Large Capacity Tanks: 13-gallon solution tank and 14.5-gallon recovery tank for prolonged cleaning sessions.
- Wide Squeegee Coverage: Equipped with a 32-inch squeegee for effective water and solution recovery.
- Dual Battery System: Includes two 12V batteries, providing a 4.5-hour runtime per charge.
- Fast Charging: Fully charges in just 6 hours, minimizing downtime.
- Comprehensive Accessories: Comes with a scrub brush, pad driver, and a set of 3 scouring pads.
- Extensive Coverage: Capable of cleaning up to 23,000 sq. ft. per hour.
- Compact Dimensions: Product dimensions are 51 inches x 31 inches x 43.5 inches.
Setup
1. Unpacking and Inspection
Carefully remove all components from the packaging. Inspect the machine for any signs of damage that may have occurred during shipping. Report any damage to Dapper Supply immediately.
2. Battery Installation and Initial Charge
The floor scrubber comes with two 12V batteries. Ensure they are properly installed in the designated battery compartment. For initial use, fully charge the batteries for approximately 6 hours. Refer to the charging port location for connection.
Image: Open battery compartment showing the two 12V batteries.
3. Attaching the Scrub Brush and Pad Driver
Attach the scrub brush or the pad driver with the appropriate scouring pad to the underside of the machine. Ensure it is securely fastened before operation.
Image: Front view of the scrubber, highlighting the brush assembly.
4. Filling the Solution Tank
Locate the 13-gallon solution tank. Fill it with clean water and an appropriate, non-foaming floor cleaning solution as recommended for your floor type. Do not overfill.
Image: Solution tank fill port.
Operating Instructions
1. Starting the Machine
Ensure the machine is fully charged and the solution tank is filled. Grip the starting handle firmly. The control panel is located on the handle for easy access to power and brush controls.
Image: Control panel and starting handle.
2. Cleaning Process
Engage the brush motor and solution flow. Guide the scrubber across the floor in overlapping passes. The 220 RPM brush speed ensures thorough scrubbing, while the 32-inch squeegee efficiently recovers dirty water into the 14.5-gallon recovery tank.
Video: Demonstration of the Dapper Supply Battery Powered Floor Scrubber in operation, showing its efficient cleaning and water recovery capabilities.
3. Dirty Water Disposal
Once cleaning is complete or the recovery tank is full, locate the dirty water outlet to drain the collected water. Dispose of dirty water according to local regulations.
Image: Dirty water outlet hose.
Maintenance
1. Battery Charging
After each use, connect the scrubber to the charger. A full charge takes approximately 6 hours. Do not overcharge the batteries. Store the machine in a cool, dry place when not in use.
2. Tank Cleaning
Regularly clean both the solution and recovery tanks to prevent residue buildup and maintain hygiene. Rinse thoroughly with clean water after each use.
3. Brush and Squeegee Inspection
Inspect the scrub brush and squeegee blades regularly for wear and tear. Replace them as needed to ensure optimal cleaning performance and water recovery.
Image: Squeegee assembly.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Machine does not power on. | Low battery charge; Power switch off; Loose battery connection. | Charge batteries; Turn on power switch; Check battery connections. |
| Poor cleaning performance. | Worn brush/pad; Incorrect solution concentration; Clogged solution nozzle. | Replace brush/pad; Adjust solution; Clean nozzle. |
| Water not being recovered. | Worn squeegee blades; Recovery tank full; Clogged recovery hose. | Replace squeegee blades; Empty recovery tank; Clear hose. |
Specifications
- Brand: Dapper Supply
- Model Number: DP-WBFS1200
- Brush Speed: 220 RPM
- Solution Tank Capacity: 13 gallons
- Recovery Tank Capacity: 14.5 gallons
- Squeegee Width: 32 inches
- Battery System: Dual 12V batteries (included)
- Charging Time: Approximately 6 hours
- Runtime: 4.5 hours per charge
- Cleaning Coverage: Up to 23,000 sq. ft. per hour
- Product Dimensions: 51 x 31 x 43.5 inches
- Included Components: Pad Driver, Scrub Brush, Set of 3 Scouring Pads
- Material: Plastic
- Color: White
- Power Source: Battery Powered
- GTIN: 00860010434611
Warranty and Support
Your Dapper Supply Floor Scrubber is covered by a 3-Year Manufacturer Warranty. This warranty protects your purchase against manufacturing defects or malfunctions. For warranty claims, technical support, or any inquiries, please contact Dapper Supply customer service. Refer to the product packaging or the official Dapper Supply website for the most current contact information.
For more information, visit the Dapper Supply Store.
