Introduction
This manual provides essential information for the safe and efficient operation, maintenance, and care of your Pure Air 3 Pro+ Adult Electric Scooter. Please read this manual thoroughly before your first ride and retain it for future reference. Adherence to these instructions will ensure optimal performance and longevity of your scooter.
Image: The Pure Air 3 Pro+ Electric Scooter, showcasing its sleek Mercury Grey design.
Safety Guidelines
Operating an electric scooter carries inherent risks. To minimize these risks, always follow these safety guidelines:
- Always wear a helmet and appropriate protective gear (knee pads, elbow pads).
- Familiarize yourself with local laws and regulations regarding electric scooter use.
- Perform a pre-ride check: ensure brakes are functional, tires are properly inflated, and all components are secure.
- Maintain a safe speed and distance from other vehicles and pedestrians.
- Avoid riding in heavy traffic, on slippery surfaces, or in adverse weather conditions. The scooter is IP65 rated for wet weather, but caution is still advised.
- Do not carry passengers or exceed the maximum weight limit of 120 kg.
- Be aware of your surroundings and avoid distractions while riding.
- Ensure proper lighting is used during low-light conditions. The scooter features a 150 lumen front light and upgraded rear brake light.
Setup and Initial Preparation
1. Unboxing and Inspection
Carefully remove all components from the packaging. Inspect the scooter for any signs of damage that may have occurred during transit. Ensure all parts listed in the packing list are present.
2. Unfolding the Scooter
The Pure Air 3 Pro+ features a folding steering tube for portability. To unfold:
- Place the scooter on a flat surface.
- Locate the folding mechanism near the base of the handlebar stem.
- Release the locking latch and carefully raise the handlebar stem until it clicks securely into the upright position.
- Ensure the locking mechanism is fully engaged before riding.
Image: The Pure Air 3 Pro+ Electric Scooter in its compact, folded configuration, ready for storage or transport.
3. Initial Charging
Before your first ride, fully charge the scooter's battery. Connect the charger to the charging port on the scooter and then to a power outlet. The indicator light on the charger will change when charging is complete. A full charge provides approximately 50 km (31 miles) of range.
Image: A close-up of the Pure Air 3 Pro+ Electric Scooter, highlighting its impressive 50km range capability.
Operating Instructions
1. Powering On and Off
Press and hold the power button on the handlebar display to turn the scooter on or off. The display will illuminate, showing battery level, speed, and riding mode.
2. Riding the Scooter
- Starting: Place one foot on the deck and push off with the other foot to gain initial momentum. Once moving, gently press the throttle to engage the motor.
- Acceleration: Use the thumb throttle on the right handlebar to control your speed. The 500W motor provides brisk acceleration and can handle inclines up to 19%.
- Braking: The scooter is equipped with a dual braking system: a front drum brake and a rear regenerative brake. Apply both brakes simultaneously for effective stopping power. The regenerative brake also helps recharge the battery.
- Steering: The Active Steering Stabilisation technology provides better control, even on uneven surfaces.
Image: A detailed view of the scooter's dual brake system, designed for responsive stopping power.
Image: The handlebars of the Pure Air 3 Pro+ Electric Scooter, illustrating the active steering stabilisation feature for enhanced control.
3. Visibility Features
The scooter is designed for maximum visibility:
- Lights: A 150 lumen front light and an upgraded rear brake light ensure you are seen.
- Indicators: Bright handlebar indicators allow you to signal turns effectively.
4. Weather Resistance
The Pure Air 3 Pro+ has an IP65 waterproof rating, allowing for use in wet weather conditions. However, avoid submerging the scooter in water and always exercise caution when riding on wet or slippery surfaces.
Image: The Pure Air 3 Pro+ Electric Scooter being ridden in the rain, demonstrating its IP65 waterproof rating for all-weather use.
Maintenance
1. Tire Care
The scooter is equipped with 10-inch tubeless, puncture-resistant tires. Regularly check tire pressure to ensure optimal performance and prevent punctures. Refer to the tire sidewall for recommended pressure. While puncture-resistant, sharp objects can still cause damage.
Image: A close-up view of the scooter's 10-inch puncture-resistant tire, designed for smoother and safer riding.
2. Brake System
Periodically inspect the front drum brake and rear regenerative brake for wear and proper function. If you notice reduced braking performance or unusual noises, consult a qualified technician.
3. Battery Care
- Charge the battery regularly, even if the scooter is not in use for extended periods, to maintain battery health.
- Avoid completely draining the battery before recharging.
- Store the scooter in a cool, dry place away from direct sunlight and extreme temperatures.
4. Cleaning
Wipe down the scooter with a damp cloth. Avoid using high-pressure water jets or harsh chemicals, as these can damage electronic components.
Troubleshooting
This section addresses common issues you might encounter. For problems not listed here, please contact customer support.
| Problem | Possible Cause | Solution |
|---|---|---|
| Scooter does not power on | Low battery; loose connections; power button malfunction | Charge the battery; check all visible connections; contact support if issue persists |
| Reduced range or power | Under-inflated tires; heavy load; riding uphill frequently; cold weather; battery degradation | Check tire pressure; reduce load; ride on flatter terrain; ensure battery is fully charged and maintained |
| Brakes feel weak | Brake pads worn; cable adjustment needed | Inspect brake components; adjust brake cables if necessary (consult manual or technician); replace worn parts |
| Unusual noises during operation | Loose components; debris in wheels; motor issue | Inspect scooter for loose parts; clear any debris; if motor noise, contact support |
Specifications
| Feature | Detail |
|---|---|
| Brand | Pure |
| Model Name | Air 3 Pro+ |
| Color | Mercury Grey |
| Motor Power | 500W (710W Peak Power) |
| Maximum Range | 50 KM (31 Miles) |
| Weight Limit | 120 Kilograms |
| Item Weight | 16.9 Kilograms |
| Dimensions (LxWxH) | 113 x 55 x 115 Centimeters |
| Foldable | Yes |
| Number of Wheels | 2 |
| Handlebar Type | Fixed |
| Wheel Size | 10 Inches |
| Wheel Type | Pneumatic, Tubeless, Puncture-resistant |
| Brake Style | Front Drum Brake, Rear Regenerative Brake |
| Suspension Type | Front Suspension |
| Waterproof Rating | IP65 |
| Frame Material | Aluminium |
Image: The Pure Air 3 Pro+ Electric Scooter with visual callouts for its 50km range, 500W motor power, bright indicators, and 10-inch tires.
Image: A detailed view of the scooter's motor, emphasizing its 710W peak power for strong hill climbing and acceleration.
Warranty Information
For detailed warranty information, please refer to the official Pure Electric website or the warranty card included with your purchase. Keep your proof of purchase for any warranty claims.
Customer Support
If you require assistance, have questions, or need to report an issue, please contact Pure Electric customer support. Contact details can typically be found on the manufacturer's website or in the documentation provided with your scooter.
