Introduction
Thank you for choosing the Blaze 20-Inch Roll-Out Stainless Steel Double Trash/Recycling Bin. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your new product. Please read these instructions thoroughly before beginning installation or use, and retain this manual for future reference.
Safety Information
Please observe the following safety guidelines to prevent injury or damage to the product:
- Always handle the unit with care. Stainless steel edges can be sharp.
- Ensure proper support during installation to prevent the unit from falling.
- Do not overload the trash bins or the drawer mechanism.
- Keep hands clear of moving parts when opening or closing the drawer.
- This product is designed for outdoor use.
Package Contents
Verify that all components are present before beginning installation:
- Blaze Roll-Out Stainless Steel Double Trash/Recycling Bin Unit
- Two (2) Internal Trash/Recycling Bins
- Installation Hardware (screws, brackets, etc. - may vary)

Image: The roll-out drawer fully extended, revealing two light-colored rectangular bins designed for trash and recycling separation.
Setup and Installation
This unit is designed for built-in installation into an outdoor kitchen island or cabinet. Professional installation is recommended.
Required Tools (Not Included):
- Measuring Tape
- Drill
- Screwdriver
- Level
Installation Steps:
- Prepare the Opening: Ensure the cabinet opening dimensions match the product specifications. The opening should be clean and free of obstructions.
- Position the Unit: Carefully slide the trash bin unit into the prepared opening. Ensure it is level and flush with the cabinet face.
- Secure the Unit: Use appropriate screws and mounting hardware (provided) to secure the unit to the cabinet structure. Refer to the specific hardware instructions for your installation type.
- Install Bins: Place the two internal trash/recycling bins into the drawer compartments.
- Test Operation: Gently open and close the drawer to ensure smooth operation.

Image: A side view of the open roll-out drawer, highlighting the sturdy drawer slides and the internal structure supporting the bins.

Image: A detailed close-up of the heavy-duty drawer slide mechanism, showing its construction and smooth operation components.
Operation
The Blaze Roll-Out Trash/Recycling Bin is designed for simple and convenient use.
- Opening the Drawer: Gently pull the sleek straight handle located on the front panel to extend the drawer. The roll-out mechanism allows for full extension, providing easy access to both internal bins.
- Using the Bins: The unit includes two separate bins, ideal for separating trash and recyclables. Place standard trash bags inside the bins as needed.
- Closing the Drawer: Push the drawer firmly until it is fully recessed and flush with the cabinet face.

Image: A view looking down into the two internal bins, showing their rectangular shape and ample capacity for waste separation.
Maintenance
Regular cleaning and maintenance will ensure the longevity and appearance of your Blaze trash bin.
- Stainless Steel Exterior: Clean the polished stainless steel surfaces with a soft cloth and a mild stainless steel cleaner. Avoid abrasive cleaners or scouring pads, which can scratch the finish. Wipe in the direction of the grain.
- Internal Bins: Remove the internal bins regularly for cleaning. Wash with warm, soapy water and rinse thoroughly. Allow to dry completely before returning to the unit.
- Drawer Slides: Periodically inspect the drawer slides for debris. Clean with a damp cloth. Lubrication is generally not required for these types of slides, but if movement becomes stiff, consult a professional.
Troubleshooting
If you encounter issues with your trash bin, try the following solutions:
- Drawer is Sticking: Check for any obstructions in the drawer slides or around the bins. Ensure the bins are properly seated. Clean the slides as described in the Maintenance section.
- Bins Not Fitting: Ensure you are using the correct size and type of bins provided with the unit.
- Unusual Noises: Inspect the drawer slides for loose components or debris. If the issue persists, contact customer support.
Specifications
| Brand | Blaze Grills |
| Model Number | BLZ-TREC-DRW-H |
| Product Dimensions (D x W x H) | 24"D x 30"W x 48"H |
| Color | Stainless Steel |
| Material | Stainless Steel |
| Handle Material | Stainless Steel |
| Frame Material | Stainless Steel |
| Item Weight | 45 Pounds |
| Installation Type | Built-In |
| Configuration | Double Compartment (Trash & Recycle) |
| Recommended Use | Outdoor |
| UPC | 818718013829 |
Note: Specifications are subject to change without notice.
Warranty Information
Blaze products are expertly crafted from quality materials and are backed by a lifetime warranty. For specific terms and conditions of your warranty, please refer to the official Blaze Grills website or contact customer support.

Image: A circular blue logo with white text stating 'MADE IN THE USA' and five stars, indicating the product's origin.
Customer Support
For technical assistance, warranty claims, or to order replacement parts, please contact Blaze Grills customer service:
- Website: Visit the official Blaze Grills website for support resources and contact information.
- Phone: Refer to the contact section of the Blaze Grills website for the appropriate phone number.
Please have your model number (BLZ-TREC-DRW-H) and proof of purchase available when contacting support.