ECONTROLLY 100056522

Instruction Manual

ECONTROLLY 100056522 Replacement Remote Control

Model: 100056522 | Brand: ECONTROLLY

Introduction

This manual provides essential information for the setup, operation, and maintenance of your ECONTROLLY 100056522 Replacement Remote Control. This remote is specifically designed to replace the original remote for ONN Bluetooth TV Soundbar Audio System Speakers.

No programming is required. Simply install the batteries, and the remote is ready for use with compatible ONN soundbar models.

Setup and Battery Installation

The ECONTROLLY 100056522 Replacement Remote Control operates on two AAA batteries (not included). Follow these steps to install the batteries:

  1. Locate the Battery Compartment: Turn the remote control over. The battery compartment is located on the back of the remote, typically at the bottom section.
  2. Open the Battery Cover: Gently slide the battery compartment cover downwards or press the latch (if present) and lift the cover off.
  3. Insert Batteries: Insert two new AAA alkaline batteries into the compartment. Ensure the positive (+) and negative (-) terminals of the batteries align correctly with the markings inside the compartment. Incorrect insertion can prevent the remote from functioning.
  4. Close the Battery Cover: Replace the battery compartment cover by sliding it back into place until it clicks securely.
Back view of the ECONTROLLY 100056522 remote control with the battery compartment open, showing where two AAA batteries would be inserted.

Image: Rear view of the remote control with the battery cover removed, illustrating the battery insertion process.

Once batteries are installed, the remote is ready for immediate use with your compatible ONN Bluetooth TV Soundbar Audio System Speaker.

Operating Instructions

This replacement remote control provides full functionality for your ONN Bluetooth TV Soundbar. Below is a description of the primary buttons and their functions:

Front view of the ECONTROLLY 100056522 remote control showing all buttons.

Image: Front view of the remote control, displaying all functional buttons.

Button Functions:

  • Power Button (Red, Top Left): Turns the soundbar On or Off.
  • Bluetooth Button (Top Middle): Switches the soundbar to Bluetooth input mode.
  • Mute Button (Top Right): Mutes or unmutes the sound.
  • Volume Up (VOL+): Increases the soundbar's volume.
  • Volume Down (VOL-): Decreases the soundbar's volume.
  • Previous Track (Left Playback Button): Skips to the previous audio track.
  • Play/Pause (Middle Playback Button): Plays or pauses audio playback.
  • Next Track (Right Playback Button): Skips to the next audio track.
  • HDMI Button: Selects the HDMI input source.
  • Input/Source Button (Arrow, Right of HDMI): Cycles through available input sources (e.g., Optical, AUX, USB).
  • MUSIC Button: Activates the Music sound mode, optimizing audio for music playback.
  • MOVIE Button: Activates the Movie sound mode, enhancing audio for cinematic experiences.
  • TALK Button: Activates the Talk sound mode, often enhancing dialogue clarity.

Ensure there are no obstructions between the remote control and the soundbar's infrared receiver for optimal performance.

Maintenance

Cleaning the Remote:

To clean the remote control, use a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Do not use harsh chemicals or abrasive materials, as they can damage the remote's surface or internal components.

Battery Care:

  • Replace batteries when the remote's response becomes sluggish or inconsistent.
  • Always replace both batteries at the same time with new ones of the same type (AAA alkaline).
  • If the remote will not be used for an extended period, remove the batteries to prevent leakage and potential damage to the remote.
  • Dispose of used batteries according to local regulations.

Troubleshooting

If you experience issues with your ECONTROLLY 100056522 Replacement Remote Control, please refer to the following common solutions:

ProblemPossible Cause / Solution
Remote is not responding.
  • Batteries: Check if the batteries are inserted correctly (+/- alignment). Replace with new AAA alkaline batteries.
  • Line of Sight: Ensure there are no obstructions between the remote and the soundbar's infrared receiver.
  • Distance: Make sure you are within the effective operating range of the soundbar.
Some buttons are not working.
  • Batteries: Low battery power can cause intermittent button functionality. Replace batteries.
  • Dirt/Debris: Check for any dirt or debris lodged under the buttons. Clean the remote as described in the Maintenance section.
  • Compatibility: Ensure your soundbar is an ONN Bluetooth TV Soundbar Audio System Speaker, as this remote is a specific replacement.
Remote range is short.
  • Batteries: Batteries may be low. Replace them.
  • Interference: Strong light sources (like direct sunlight) or other infrared devices can interfere. Try using the remote in a different environment.

Product Specifications

FeatureDetail
Model Number100056522
BrandECONTROLLY
Compatible DevicesONN Bluetooth TV Soundbar Audio System Speaker
Connectivity TechnologyInfrared (IR)
Power Source2 x AAA Batteries (not included)
Product Dimensions7 x 2 x 0.65 inches (approx.)
Item Weight3 ounces (approx.)
Special FeatureErgonomic design
ManufacturerECONTROLLY Factory

Warranty Information

Specific warranty details for this product are not provided in the available information. Please refer to the seller's return policy or contact the manufacturer directly for warranty inquiries.

Customer Support

For further assistance or technical support, please contact the seller or manufacturer through the platform where the product was purchased. Ensure you have your product model number (100056522) and purchase details ready when contacting support.

© 2023 ECONTROLLY. All rights reserved. Information in this manual is subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.