APLOS T03 Professional Tactical Flashlight User Manual

1. Introduction

Thank you for choosing the APLOS T03 Professional Tactical Flashlight. This manual provides essential information for the safe and effective use of your new flashlight. Please read it thoroughly before operation and retain it for future reference.

The APLOS T03 is a high-performance tactical flashlight designed for various applications, offering up to 5000 lumens of brightness and a long-range beam. It features multiple lighting modes, a durable aluminum alloy construction, and convenient USB-C recharging.

2. Package Contents

Upon opening your APLOS T03 package, please verify that all the following items are included:

• APLOS T03 Professional Tactical Flashlight
• 1 x 21700 Lithium-Ion Battery (5000mAh, pre-installed)
• USB-A to USB-C Charging Cable
• Pocket Clip (pre-attached)
• Lanyard
• Spare O-rings (2)
• User Manual

3. Product Overview and Features

The APLOS T03 is engineered for reliability and performance. Key features include:

• High Brightness: Up to 5000 lumens output.
• Long Range: Illuminates distances up to 500 meters.
• Multiple Lighting Modes: 7 modes including High, Medium, Low, Strobe, SOS, Save, and Moonlight.
• Memory Function: Remembers the last used mode for convenience.
• Durable Construction: Made from hard anodizing aluminum alloy with a stainless steel attack head.
• Rechargeable: Integrated USB-C charging port.
• High Capacity Battery: Powered by a 5000mAh Lithium-Ion battery.
• Intelligent Power Management: Prevents overheating and extends battery life.
• Water and Dirt Resistant: IP68 rated for protection against water and dust ingress.

4. Setup

Before first use, please follow these steps:

1. Battery Preparation: The 21700 Lithium-Ion battery is pre-installed. Unscrew the tail cap and remove the small insulating sticker from the positive end of the battery. This sticker prevents battery discharge during shipping. Re-screw the tail cap firmly.
2. Initial Charge: It is recommended to fully charge the flashlight before its first use. Refer to the 'Charging' section for detailed instructions.
3. Attach Lanyard/Clip: If desired, attach the included lanyard to the tail cap or adjust the pocket clip for secure carrying.

5. Operating Instructions

The APLOS T03 features a tactical tail switch with two detent levels for various functions.

5.1 Basic Operation

• Momentary On: Lightly tap and hold the tail switch for momentary illumination. Release to turn off.
• Constant On/Off: Fully press the tail switch until it clicks to turn the flashlight on or off.

5.2 Mode Switching

When the flashlight is ON:

• Cycle Modes: With the flashlight ON, lightly tap the tail switch (without clicking) to cycle through the main brightness modes: Low → Medium → High.
• Special Modes:
• Strobe: From OFF, fully press and hold the tail switch for approximately 1 second to activate Strobe mode. Release to turn off. From ON, a quick double-tap of the tail switch (without clicking) may also activate Strobe.
• SOS: From OFF, a quick triple-tap of the tail switch (without clicking) may activate SOS mode.
• Moonlight/Save: These modes are typically accessed by cycling through the main modes or through specific quick-press combinations. Refer to the quick guide card for exact sequences if not covered by the main cycle.

5.3 Memory Function

The APLOS T03 features a mode memory function. When the flashlight is turned off and then back on, it will activate in the last used general lighting mode (Low, Medium, High).

5.4 Lockout Function

To prevent accidental activation, the flashlight may enter a lockout mode if left unused for a period (e.g., 3 minutes). To exit lockout, perform two rapid full presses (clicks) of the tail switch.

6. Charging

The APLOS T03 is equipped with a convenient USB-C charging port.

1. Connect Cable: Open the rubber cover on the side of the flashlight to expose the USB-C port. Insert the USB-C end of the charging cable into the flashlight's port.
2. Connect Power: Plug the USB-A end of the cable into a compatible USB power source (e.g., wall adapter, power bank, computer USB port).
3. Charging Indicator: The indicator light near the charging port will show the charging status:
• Red: Charging in progress.
• Green: Charging complete.
4. Charging Time: A full charge typically takes approximately 2 hours and 15 minutes.
5. Disconnect: Once fully charged, disconnect the cable and securely close the rubber cover to maintain water resistance.

7. Maintenance

Proper maintenance ensures the longevity and optimal performance of your APLOS T03 flashlight.

• Cleaning: Clean the flashlight body with a soft, damp cloth. Do not use abrasive cleaners or solvents.
• O-rings: Periodically inspect the O-rings for wear and tear. Replace them with the provided spare O-rings if necessary to maintain water resistance. Apply a thin layer of silicone grease to the O-rings to ensure a good seal.
• Threads: Keep the threads of the tail cap clean and lightly lubricated to ensure smooth operation and proper electrical contact.
• Battery Care: If the flashlight will not be used for an extended period, remove the battery to prevent potential leakage or damage. Store the battery in a cool, dry place.
• Charging Port: Ensure the USB-C charging port cover is securely closed when not charging to prevent dust and water ingress.

8. Troubleshooting

If you encounter issues with your APLOS T03 flashlight, refer to the following common problems and solutions:

If the problem persists after attempting these solutions, please contact APLOS customer support for further assistance.

9. Specifications

10. Warranty and Support

APLOS products are manufactured to high-quality standards. For warranty information, product support, or service inquiries, please refer to the warranty card included in your product packaging or visit the official APLOS website. Please have your product model (T03) and purchase date available when contacting support.