Introduction
This manual provides essential information for the safe and efficient installation, operation, and maintenance of your FAME SUPERDUCHA QUATTRO Electric Shower. Please read all instructions carefully before use and retain this manual for future reference.
Safety Information
Adherence to these safety guidelines is crucial to prevent electrical shock, injury, or damage to the product. This electric shower is designed with insulation and surge protection, meeting international safety standards. The body is constructed from high-quality polypropylene for heat resistance and durability.
- Electrical Installation: Requires a dedicated 40 Amp circuit breaker and 10 AWG wiring. The heater must be installed directly to the electrical distribution protection box. Do not use extension cords or plugs.
- Professional Installation: Installation should be performed by a qualified electrician in accordance with local electrical codes and regulations.
- Water Pressure: Ensure adequate water pressure for proper operation. Refer to the specifications section for flow rate requirements.
- Temperature Settings: Use the temperature selector carefully. Always test water temperature before stepping into the shower.
- Maintenance: Disconnect power before performing any maintenance or cleaning.
Package Contents
Verify that all components are present and undamaged upon unpacking.
- FAME SUPERDUCHA QUATTRO Electric Shower Head
- 5.2 foot (1.60 cm) Hand Hose with Bidet and Support
- Cable Cover
- Wire Connector
- 1/2" Standard Thread
Image: Included components of the FAME SUPERDUCHA QUATTRO electric shower.
Specifications
| Brand | FAME |
| Model | SUPERDUCHA QUATTRO (10310) |
| Voltage | 110 Volts (AC) |
| Rated Power | 4400W (also 2000W, 2400W for lower settings) |
| Rated Frequency | 50/60Hz |
| Product Dimensions (W x H) | 5.51" x 6.29" (14.5 cm x 15 cm) |
| Item Weight | 1.28 pounds (0.58 kg) |
| Material | Polypropylene, Copper, Copper and Silver alloys |
| Maximum Flow Rate | 2.5 Gallons Per Minute |
| Mounting Type | Wall |
Image: Product dimensions of the FAME SUPERDUCHA QUATTRO electric shower.
Setup and Installation
Proper installation is critical for safety and performance. It is highly recommended that a qualified professional performs the installation.
- Electrical Preparation: Ensure a dedicated 40 Amp circuit breaker and 10 AWG wiring are in place. The electric shower must be connected directly to the electrical distribution protection box. Do not use plugs or extension cords.
- Water Supply: Connect the shower to your water supply. The minimum height for the water supply tank is 1.0 meters (39.37 inches). The maximum height from the floor to the shower should be 2.10 meters.
- Mounting: Securely mount the shower head to the wall at the desired height.
- Electrical Connection: Connect the electrical cables as follows: White for Neutral, Blue for Line, and Green for Ground pole. Use the provided wire connector and cable cover for a secure and insulated connection.
- Water Flow Test: Before turning on the electricity, allow water to flow through the shower for a few minutes to purge any air from the system.
- Final Check: Inspect all connections for leaks and ensure all electrical connections are secure and insulated.
Image: Electrical connection diagram for the electric shower.
Operating Instructions
The FAME SUPERDUCHA QUATTRO electric shower provides instant hot water with multiple temperature settings.
- Turn on Water: Open the faucet to allow water to flow through the shower head.
- Select Temperature: Use the selector on the shower head to choose your desired temperature level: Cold, Warm, Hot, or Super Hot.
- Instant Heat: The water will heat instantly as it passes through the unit.
- Adjust Flow: Adjust the water flow to achieve the desired temperature and pressure. Note that higher flow rates may result in cooler water, especially at lower temperature settings.
Image: Key operational features and safety warnings.
Image: FAME SUPERDUCHA QUATTRO electric shower in operation.
Maintenance
Regular maintenance ensures optimal performance and extends the life of your electric shower.
- Power Disconnection: Always turn off the main electrical power to the shower before performing any maintenance.
- Cleaning: Clean the exterior of the shower with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Shower Head Nozzles: Periodically check and clean the shower head nozzles to remove any mineral deposits that may affect water flow. Use a soft brush or a descaling solution if necessary.
- Filter (if applicable): If your model includes a water filter, refer to the specific instructions for cleaning or replacing it.
Troubleshooting
If you encounter issues with your electric shower, refer to the following common troubleshooting steps. For complex problems, contact a qualified technician.
- No Hot Water:
- Check if the circuit breaker is tripped. Reset if necessary.
- Ensure the water supply is on and flowing adequately.
- Verify the temperature selector is not set to 'Cold'.
- Water Not Hot Enough:
- Reduce the water flow rate. Higher flow rates can decrease water temperature.
- Ensure the temperature selector is set to a higher heat level.
- Check for proper electrical connection and voltage.
- Low Water Pressure:
- Check the main water supply valve.
- Clean the shower head nozzles for mineral buildup.
- Water Leaks:
- Turn off the water supply and power immediately.
- Check all connections for tightness.
- Inspect seals and gaskets for damage.
Warranty
The FAME SUPERDUCHA QUATTRO Electric Shower comes with a 1-Year Warranty from the date of purchase. This warranty covers manufacturing defects under normal use. Please retain your proof of purchase for warranty claims. The warranty does not cover damage resulting from improper installation, misuse, neglect, or unauthorized repairs.
Image: Product packaging indicating a 1-year warranty.
Support
For further assistance, technical support, or warranty inquiries, please refer to the contact information provided with your purchase or visit the official FAME website. Always provide your product model number (10310) and proof of purchase when contacting support.
