Karella 8305.03_UK

Karella Fighter Soft Tip Darts 90% 18g Instruction Manual

Model: 8305.03_UK

Introduction

This manual provides essential information for the proper setup, operation, and maintenance of your Karella Fighter Soft Tip Darts. Please read these instructions carefully to ensure optimal performance and longevity of your darts.

Setup

Your Karella Fighter Soft Tip Darts are designed for easy assembly. Each dart consists of a barrel, shaft, and flight. The soft tip is pre-attached to the barrel.

  1. Attach the Shaft: Carefully screw the shaft into the threaded end of the dart barrel. Ensure it is tightened securely but do not overtighten, as this can damage the threads.
  2. Insert the Flight: Gently slide the flight into the slots at the end of the shaft. Ensure the flight is fully seated and aligned properly for stable flight.

The image below illustrates an assembled dart.

Assembled Karella Fighter Soft Tip Dart
An assembled Karella Fighter Soft Tip Dart, showing the barrel, shaft, and flight.

Another view of the assembled dart:

Side view of an assembled Karella Fighter Soft Tip Dart
Side view of an assembled Karella Fighter Soft Tip Dart, highlighting its components.

Operating

Karella Fighter Soft Tip Darts are designed for use with electronic dartboards. Always ensure you are using the correct type of dart for your dartboard to prevent damage to both the dart and the board.

Throwing Technique

Hold the dart comfortably, typically gripping the barrel. Aim for the desired segment on the dartboard. A smooth, consistent throwing motion from the shoulder is recommended for accuracy. Release the dart cleanly without flicking the wrist excessively.

Karella Fighter Soft Tip Dart embedded in an electronic dartboard
A Karella Fighter Soft Tip Dart successfully embedded in an electronic dartboard.

Maintenance

Regular maintenance will extend the life of your Karella Fighter Soft Tip Darts.

  • Cleaning: Wipe the dart barrels with a soft, dry cloth after use to remove any residue or moisture.
  • Inspect Components: Periodically check the shafts for cracks or bends, and the flights for tears or damage. Replace any worn or damaged components promptly.
  • Soft Tips: The soft tips are designed to be replaceable. If a tip becomes bent, broken, or excessively worn, unscrew it from the barrel and replace it with a new soft tip.
  • Storage: Store your darts in a dart case or a protective container to prevent damage to the flights and tips when not in use.

Troubleshooting

  • Darts not sticking to the board:
    • Check if the soft tip is worn or damaged. Replace if necessary.
    • Ensure the dartboard segments are clean and free of debris.
    • Review your throwing technique for consistency and force.
  • Flights falling off frequently:
    • Ensure the flights are fully inserted into the shaft slots.
    • Inspect the shaft for damage or widening of the slots. Replace the shaft if damaged.
    • Consider using flight protectors or O-rings if shafts are compatible, to secure flights more firmly.
  • Shafts breaking:
    • Shafts can break due to impact. Replace broken shafts immediately.
    • Ensure darts are not hitting hard surfaces repeatedly.

Specifications

FeatureDetail
BrandKarella
Model Number8305.03_UK
Material90% Tungsten
Weight18 grams
Product Dimensions (L x W x H)13 x 3 x 21 cm
ManufacturerKarella
Batteries IncludedNo

Detailed barrel specifications are provided below:

Karella Fighter Dart Barrel Specifications
Image detailing the barrel length (48mm), diameter (6.4mm), 90% Tungsten material, and 18g weight.

Warranty and Support

For warranty information or technical support, please refer to the retailer where you purchased your Karella Fighter Soft Tip Darts or visit the official Karella website. Keep your proof of purchase for any warranty claims.

© 2023 Karella. All rights reserved.