Ashland HX181046
Ashland 45ct. Warm White LED Iridescent Clip Lights User Manual
1. Product Overview
The Ashland 45ct. Warm White LED Iridescent Clip Lights are designed to enhance indoor decor. This set features 45 warm white LED lights on a silver wire, equipped with 16 iridescent clips. These clips allow for the display of photographs, greeting cards, or other lightweight decorative items. The lights operate on a battery box with a built-in timer function.

Image 1.1: The Ashland 45ct. Warm White LED Iridescent Clip Lights in use, showcasing displayed photographs.
2. Safety Information
- Indoor Use Only: This product is designed exclusively for indoor environments. Do not use outdoors or expose to moisture.
- Battery Safety: Use only the specified battery type (3 x AA). Do not mix old and new batteries, or different types of batteries. Remove batteries if the product is not used for an extended period. Dispose of batteries properly.
- Electrical Safety: Do not attempt to modify or repair the light string. Keep away from heat sources and open flames.
- Choking Hazard: Keep small parts, such as batteries, out of reach of children.
3. Package Contents
Verify that all components are present in the package:
- 1 set of Ashland 45ct. Warm White LED Iridescent Clip Lights
- Integrated battery box
Note: 3 x AA batteries are required and are not included in the package.

Image 3.1: The retail packaging for the Ashland 45ct. Warm White LED Iridescent Clip Lights.
4. Setup Instructions
- Install Batteries: Locate the battery compartment on the integrated battery box. Open the compartment cover and insert 3 new AA batteries, ensuring correct polarity (+/-). Close the cover securely.
- Uncoil Lights: Carefully uncoil the light string, ensuring the wire does not tangle or kink.
- Position Lights: Hang the light string in your desired indoor location. The 14.5 ft (4.4 m) length provides flexibility for various arrangements.
- Attach Items: Use the 16 iridescent clips to secure photographs, artwork, or other lightweight decorative items along the light string.

Image 4.1: The clip lights arranged on a wall, holding various photographs.

Image 4.2: A detailed view of an iridescent clip attached to the light string.
5. Operating Instructions
The Ashland Clip Lights feature a simple on/off switch and a built-in timer function located on the battery box.
- Power On/Off: Locate the switch on the battery box. Slide the switch to the 'ON' position to illuminate the lights. Slide to 'OFF' to turn them off.
- Timer Function: When the lights are switched 'ON', they will automatically activate the 6-hour on, 18-hour off timer cycle. The lights will remain on for 6 hours, then turn off for 18 hours, and repeat this cycle daily. To reset the timer, switch the lights 'OFF' and then 'ON' again at your desired start time.
6. Maintenance
- Cleaning: To clean the light string and clips, gently wipe with a soft, dry cloth. Do not use liquid cleaners or immerse any part of the product in water.
- Battery Replacement: When the lights dim or cease to function, replace all three AA batteries with new ones. Refer to Section 4 for battery installation instructions.
- Storage: When not in use, carefully coil the light string and store it in a cool, dry place, away from direct sunlight and moisture. Remove batteries before long-term storage.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Lights do not turn on. | Batteries are dead or incorrectly installed. | Replace batteries with new AA batteries, ensuring correct polarity. |
| Lights are dim. | Batteries are low. | Replace batteries with new AA batteries. |
| Timer function is not working as expected. | Timer needs to be reset. | Switch the lights 'OFF' and then 'ON' again at the desired time for the 6-hour cycle to begin. |
| Some lights are not working. | Individual LED failure (rare). | LEDs are not user-replaceable. If multiple lights fail, consider product replacement. |
8. Specifications
- Brand: Ashland
- Model Number: HX181046
- Light Type: LED
- Light Color: Warm White
- Number of Lights: 45
- Number of Clips: 16
- Wire Color: Silver
- Total Length: 14.5 ft (4.4 m)
- Power Source: 3 x AA Batteries (not included)
- Timer: 6 hours ON / 18 hours OFF
- Usage: Indoor Only
- Material: Plastic
- Product Dimensions: 5.25 x 8.2 x 1.25 inches (packaging)
- Item Weight: 1.44 pounds
- UPC: 195158526493
9. Warranty and Support
For information regarding warranty coverage or product support, please refer to the retailer's return policy or contact Ashland customer service through their official website or the point of purchase. Please retain your proof of purchase for any warranty claims.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.
