1. Introduction
This manual provides essential information for the assembly, operation, and maintenance of your HEXBUG BATTLEBOTS Arena featuring Bite Force and Blacksmith. This product is designed to replicate the excitement of BattleBots combat, allowing users to control two iconic robots within a scaled arena.
Image 1.1: The HEXBUG BATTLEBOTS Arena set, showcasing the assembled arena with Bite Force and Blacksmith robots, alongside the product packaging.
2. What's in the Box
Verify that all components listed below are present in your package:
- 1 HEXBUG BATTLEBOTS Arena (requires assembly)
- 1 HEXBUG BATTLEBOT Bite Force robot
- 1 HEXBUG BATTLEBOT Blacksmith robot
- 2 Remote Controls
- Instruction Manual (this document)
Note: 10 AAA batteries are required for operation (not included).
Image 2.1: Front view of the product packaging, showing the arena and robots.
Image 2.2: Back view of the product packaging, illustrating the various components and features included in the set.
3. Setup
3.1 Arena Assembly
- Unpack all components from the box.
- Interlock the plastic floor tiles to form the base of the arena. Ensure they are securely connected.
- Attach the transparent wall panels around the perimeter of the floor tiles. These panels slide into designated slots.
- Position the interactive hammers in their designated corners of the arena. These are typically placed at the red and blue zones.
3.2 Battery Installation
Each BattleBot and remote control requires batteries for operation. A total of 10 AAA batteries are needed (not included).
- For BattleBots (Bite Force and Blacksmith): Locate the battery compartment on the underside of each robot. Use a small Phillips head screwdriver to open the compartment. Insert the required AAA batteries, ensuring correct polarity (+/-). Close the compartment and secure with the screw.
- For Remote Controls: Locate the battery compartment on the back of each remote control. Open the compartment and insert the required AAA batteries, observing correct polarity. Close the compartment.
Image 3.1: The fully assembled BattleBots Arena, ready for combat.
4. Operating Instructions
4.1 Pairing Remote Controls
Each robot must be paired with its corresponding remote control before use. Ensure both the robot and remote have fresh batteries installed.
- Turn on the BattleBot by sliding the power switch to the 'ON' position.
- Turn on the remote control.
- The robot and remote should automatically pair. If not, refer to the troubleshooting section.
Image 4.1: Example of a HEXBUG remote control.
4.2 Basic Movement and Combat
Use the joysticks or directional buttons on the remote control to maneuver your BattleBot within the arena. Each robot has unique offensive and defensive capabilities:
- Bite Force: Features a powerful vertical spinning weapon and front wedge design. Use its speed and wedge to get under opponents and activate the spinner for maximum damage.
- Blacksmith: Equipped with a devastating hammer weapon. Maneuver Blacksmith to strike opponents with its hammer, aiming to disable or dislodge their armor.
Image 4.2: Bite Force (left) and Blacksmith (right) BattleBots.
4.3 Interactive Arena Features
The arena includes interactive hammers. Drive your BattleBot into the activation zones to trigger these hammers, which can impact your opponent's robot.
5. Maintenance
5.1 Battery Replacement
Due to the nature of remote-controlled combat, batteries may deplete quickly. Replace batteries in both robots and remote controls when performance diminishes. Always use fresh AAA batteries and ensure correct polarity.
5.2 Cleaning
Wipe down the arena and robots with a dry or slightly damp cloth. Do not submerge any electronic components in water. Avoid using harsh chemicals or abrasive cleaners.
5.3 Storage
When not in use for extended periods, remove all batteries from the robots and remote controls to prevent leakage. Store the product in a cool, dry place away from direct sunlight.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Robot does not move or respond to remote. | Dead or low batteries; Robot/remote not powered on; Pairing issue. | Replace batteries in both robot and remote. Ensure power switches are ON. Re-attempt pairing by turning both devices off and then on again. |
| Robot moves slowly or erratically. | Low batteries. | Replace batteries with fresh ones. |
| Robot weapon (spinner/hammer) does not activate. | Low batteries; Mechanical obstruction. | Replace batteries. Check for any debris or damage obstructing the weapon mechanism. |
| Remote control does not function. | Dead or low batteries; Remote not powered on. | Replace batteries in the remote. Ensure the power switch is ON. |
7. Specifications
- Product Dimensions: 26.1 x 3.82 x 14.02 inches
- Item Weight: 3.77 pounds
- Model Number: 6069044
- Manufacturer Recommended Age: 8 - 13 years
- Batteries: 10 AAA batteries required (not included)
- Release Date: February 17, 2023
- Manufacturer: Spin Master
8. Safety Information
- WARNING: CHOKING HAZARD – Small parts. Not for children under 3 years.
- Adult supervision is recommended during play.
- Do not modify the robots or arena components.
- Ensure the arena walls are properly installed before beginning play to contain robots.
- Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
9. Warranty and Support
For information regarding warranty, replacement parts, or customer support, please refer to the manufacturer's official website or contact their customer service department. Specific warranty details may vary by region and retailer.
