HMHAMA Replacement Parts Kit for 360 S5 S7 Robot Vacuum Cleaner

Introduction

This manual provides instructions for the installation, maintenance, and troubleshooting of the HMHAMA Replacement Parts Kit for 360 S5 and S7 Robot Vacuum Cleaners. This kit is designed to help maintain the optimal performance of your robot vacuum by replacing worn components.

Package Contents

The HMHAMA Replacement Parts Kit (set1) includes the following items:

• 1 x Main Roller Brush
• 2 x Side Brushes
• 2 x HEPA Filters

Image: Complete HMHAMA Replacement Parts Kit (set1).

Compatibility

This replacement parts kit is compatible with the following robot vacuum cleaner models:

• 360 S5 Robot Vacuum Cleaner
• 360 S7 Robot Vacuum Cleaner

Installation

Before beginning any installation, ensure your robot vacuum cleaner is powered off and disconnected from its charging base.

1. Main Roller Brush Installation

1. Turn the robot vacuum cleaner upside down.
2. Locate the brush guard cover, usually secured by two tabs or screws. Open or remove the cover.
3. Remove the old main roller brush from its compartment.
4. Important for 360 S7 users: Some 360 S7 models may require you to remove the end caps from your original main roller brush and attach them to the new HMHAMA main roller brush for proper fitment. Carefully detach the end caps from the old brush and snap them onto the new brush.
5. Insert the new main roller brush into the compartment, ensuring the ends align with the slots.
6. Close or re-secure the brush guard cover.

Image: Main Roller Brush.

Image: Detail of Main Roller Brush end cap.

2. Side Brush Installation

1. Turn the robot vacuum cleaner upside down.
2. Locate the side brushes. Each brush is typically held by a single screw.
3. Use a screwdriver to remove the screw and detach the old side brush.
4. Place a new side brush into position, aligning the hole with the screw post.
5. Secure the new side brush with the screw. Repeat for the other side brush if replacing both.

Image: Side Brushes.

3. HEPA Filter Installation

1. Open the top cover of your robot vacuum cleaner.
2. Remove the dustbin from the vacuum.
3. Locate the filter compartment within the dustbin. Remove the old HEPA filter.
4. Insert the new HEPA filter into the dustbin, ensuring it is seated correctly and securely.
5. Reinsert the dustbin into the robot vacuum cleaner and close the top cover.

Image: HEPA Filters.

Maintenance

Regular cleaning and timely replacement of parts are crucial for maintaining your robot vacuum's suction power and extending its lifespan.

Cleaning Instructions

• Main Roller Brush: Remove hair and debris tangled around the brush and its ends. Use the cleaning tool often provided with your vacuum.
• Side Brushes: Check for tangled hair or debris. If bent, soak in warm water for a few minutes to help them regain shape.
• HEPA Filters: Tap the filter gently over a trash can to remove dust. Do not wash HEPA filters with water unless explicitly stated by the vacuum manufacturer, as this can damage the filter material.

Recommended Replacement Frequency

• Side Brushes and HEPA Filters: Replace every 2-3 months.
• Main Roller Brush: Replace every 6 months.

Note: Replacement frequency may vary based on usage and environment (e.g., presence of pets).

Troubleshooting

• Main Roller Brush Does Not Fit or Causes Noise:

  If the new main roller brush does not fit correctly, especially for 360 S7 models, ensure you have transferred the original end caps from your old brush to the new one. The new brush's end caps might differ slightly and prevent proper seating or rotation.

• Vacuum Reports 'Dustbin Has Been Removed!' After Filter Replacement:

  Ensure the new HEPA filter is correctly and fully seated within the dustbin. A loose or improperly installed filter can prevent the dustbin from being recognized by the vacuum. Verify that the filter's dimensions match the original filter precisely to ensure proper contact with the vacuum's sensors.

Specifications

Warranty and Support

HMHAMA is committed to providing reliable products. If you encounter any issues or have questions regarding this replacement parts kit, please contact your retailer or the HMHAMA customer service team for assistance. Please refer to your purchase documentation for specific warranty details.