TransOurDream Genuine Transfer Sheet JP-2-YH-5 Instruction Manual

Introduction

Thank you for choosing the TransOurDream Genuine Transfer Sheet JP-2-YH-5. This product allows you to create personalized designs on white or light-colored fabrics using an inkjet or laser printer. Please read this manual carefully before use to ensure proper application and optimal results.

Safety Information

When using an iron, it becomes very hot. Please exercise extreme caution to prevent burns or fires. Do not allow children to handle the iron or transfer sheets unsupervised.

Package Contents

• T-shirt Transfer Sheets (A4 size): 5 sheets
• Silicone Sheet (A3 size): 1 sheet
• Instruction Manual: 1 sheet

Note: The base color of this product is semi-transparent. It is not suitable for black or dark-colored fabrics as the underlying color will show through.

Compatible Printers & Fabrics

This transfer paper is compatible with both inkjet printers (dye and pigment inks) and laser printers.

It is designed for use with white and light-colored fabrics. The transfer sheet allows for normal image printing, ensuring colors do not fade or peel easily. It offers simple application, long-lasting results, and good wash resistance, allowing for free printing, cutting, and creation of decorative T-shirts.

Setup

1. Printing Your Design

Print your desired design onto the transfer sheet using an inkjet or laser printer. Ensure the image is printed in its normal orientation (not mirrored) as this sheet is for normal image printing.

Illustration of the print, cut, and iron steps.

2. Cutting the Design

After printing, carefully cut out your design from the transfer sheet. Leave a small margin around the image if desired, or cut precisely along the edges.

Operating Instructions

1. Fabric Preparation

Ensure your fabric (T-shirt, bag, etc.) is clean, dry, and wrinkle-free. Iron the fabric briefly to remove any creases and moisture.

2. Transfer Process

Place the cut-out design onto the desired area of the fabric with the printed side facing up. Cover the design with the provided silicone sheet.

Set your iron to a high temperature (approximately 180°C). For heat presses, set to 170°C for 120-140 seconds. For Easy Presses, set to 170°C for 10-15 seconds. Apply firm, even pressure with the iron over the entire design, moving it slowly for about 5 seconds per section. Repeat this process 5-6 times to ensure complete transfer.

Visual guide for the transfer process.

3. Peeling the Backing

Once the fabric has completely cooled, slowly and carefully peel off the silicone sheet from one corner. If the transfer is not complete or the sheet is difficult to peel, reapply the iron with pressure for a few more seconds.

Finishing

After peeling, your custom T-shirt is complete. The design should be firmly adhered to the fabric with a soft finish.

Example of finished T-shirts with custom designs.

Maintenance

For best results and longevity of the transfer, wash the garment in cold water. It is recommended to use a washing machine. Do not use a dryer; instead, reshape the garment and air dry naturally.

Specifications