E-flite Eratix 3D FF Flat Foamy 860mm BNF Basic with AS3X and SAFE Select

1. Introduction

This manual provides essential information for the safe and effective operation of your E-flite Eratix 3D FF Flat Foamy 860mm RC airplane. The Eratix 3D FF is designed for both sport flying and advanced 3D aerobatics, featuring a specially tuned brushless motor, a 15-amp Spektrum Avian Smart ESC, and a Spektrum AR630 receiver with AS3X and SAFE Select technologies. Its design allows for fast and easy assembly without the need for glue or tape.

Image: The E-flite Eratix 3D FF Flat Foamy 860mm RC airplane, showcasing its red and grey color scheme and flat foam construction.

2. Safety Information

WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the product or other property. This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. The product manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.

3. What's in the Box

Your E-flite Eratix 3D FF Flat Foamy 860mm BNF Basic package includes:

• Eratix 3D FF (Flat Foamy) 860mm BNF Basic with AS3X and SAFE Select

4. Needed to Complete

To operate your Eratix 3D FF, you will need the following items, which are not included in the box:

• Compatible Spektrum DSMX/DSM2 aircraft transmitter (6+ channel recommended)
• 3S 600–850mAh LiPo flight battery
• Compatible LiPo charger

Image: Visual representation of the additional components required: a battery, a charger, and a transmitter.

5. Setup and Assembly

The Eratix 3D FF is designed for quick and straightforward assembly, requiring no glue or tape. Follow these general steps:

1. Unpack Components: Carefully remove all components from the packaging.
2. Wing Installation: Attach the wings securely to the fuselage. Ensure all connections are firm.
3. Landing Gear: Install the landing gear if desired for ground operations.
4. Battery Installation: Securely install your charged 3S LiPo flight battery in the designated compartment.
5. Binding: Bind the Spektrum AR630 receiver to your compatible DSMX/DSM2 transmitter. Refer to your transmitter's manual for specific binding procedures.
6. Control Surface Check: Verify that all control surfaces (ailerons, elevator, rudder) move freely and in the correct direction relative to your stick inputs. Adjust linkages if necessary.
7. AS3X and SAFE Select Setup: The AS3X and SAFE Select technologies are pre-configured. Ensure your transmitter is set up to activate SAFE Select if you wish to use it. Consult the full user manual for detailed instructions on SAFE Select activation and flight mode switching.

Image: The Eratix 3D FF in dynamic flight, demonstrating its maneuverability.

Image: A side profile of the Eratix 3D FF as it flies, highlighting its flat foam design.

6. Operating Instructions

The Eratix 3D FF is a Skill Level 2 aircraft, meaning some experience is required for optimal enjoyment and safety. It is suitable for intermediate pilots who have experience with