1. Product Overview
This manual provides instructions for the GoPro HERO10 Black action camera. The GoPro HERO10 Black is a high-performance, waterproof action camera designed to capture stunning 5.3K video and 23MP photos. It features the powerful GP2 processor, HyperSmooth 4.0 stabilization, and dual screens for versatile shooting.
What's in the Box
- GoPro HERO10 Black Camera
- Rechargeable Li-Ion Battery
- SanDisk Extreme Pro 64GB microSDXC Card
- USB-C Cable
- Mounting Buckle + Thumb Screw
- Curved Adhesive Mount
- Camera Case
- 6AVE Electronics Microfiber Cloth
2. Initial Setup
2.1 Charging the Battery
- Open the side door of the camera.
- Insert the included rechargeable battery.
- Connect the camera to a USB power source using the provided USB-C cable. The camera's status lights will indicate charging.
2.2 Inserting the microSD Card
- With the side door open, locate the microSD card slot.
- Insert the SanDisk Extreme Pro 64GB microSDXC card with the label facing the front of the camera until it clicks into place.
2.3 Powering On/Off
- To Power On: Press and hold the Mode button (side of the camera) for approximately three seconds.
- To Power Off: Press and hold the Mode button for approximately three seconds until the camera powers down.
2.4 Initial Settings
Upon first power-on, follow the on-screen prompts to select your language, set the date and time, and accept the terms of use.
3. Operating the Camera
3.1 Basic Controls
- Mode Button: Located on the side. Short press to cycle through video, photo, and time-lapse modes. Long press to power on/off.
- Shutter Button: Located on the top. Press to start/stop recording video or take a photo.
3.2 Using the Touchscreens
The HERO10 Black features both a front LCD screen for framing and a rear touchscreen for navigation and settings adjustments. Swipe and tap on the rear screen to access menus, change settings, and review footage.
3.3 Video Modes and Settings
The camera offers various video resolutions and frame rates, including:
- 5.3K at 60 frames per second (fps)
- 4K at 120 fps
- 2.7K at 240 fps (for 8x slow-motion)
Access video settings via the rear touchscreen to adjust resolution, frame rate, field of view, and activate HyperSmooth 4.0 stabilization.
3.4 Photo Modes and Settings
Capture high-resolution 23MP photos. Available photo modes include:
- Standard Photo: For single shots.
- LiveBurst: Records 1.5 seconds before and after your shot, allowing you to choose the best frame or share as a short video.
- RAW Photo Mode: For advanced editing capabilities.
3.5 Advanced Features
- HyperSmooth 4.0: Advanced in-camera video stabilization for smooth footage.
- Voice Control: Operate your camera hands-free with voice commands.
- Webcam Mode & Live Streaming: Connect your GoPro to a computer for use as a webcam or stream directly in 1080p HD.
- Waterproof Design: The camera is waterproof up to 33 feet (10 meters) without additional housing. Ensure all doors are securely closed before exposing to water.
4. Maintenance
4.1 Cleaning the Camera
- Use the included 6AVE Electronics microfiber cloth to clean the lens and screens.
- For stubborn dirt, use a soft, damp cloth. Avoid abrasive materials or chemical cleaners.
- After use in saltwater, rinse the camera with fresh water and dry thoroughly.
4.2 Battery Care
- Store batteries in a cool, dry place.
- Avoid fully discharging batteries for extended periods.
- If a battery shows signs of swelling or damage, discontinue use immediately.
4.3 Firmware Updates
Regularly check for and install firmware updates via the GoPro Quik app or the GoPro website to ensure optimal performance and access to new features.
5. Troubleshooting
5.1 Common Issues and Solutions
| Issue | Possible Solution |
|---|---|
| Camera not powering on | Ensure the battery is charged and correctly inserted. Try a different battery if available. |
| Camera freezes or becomes unresponsive | Remove and reinsert the battery to perform a hard reset. Ensure firmware is up to date. |
| Overheating during use | Reduce video resolution/frame rate. Avoid direct sunlight. Ensure adequate airflow around the camera. |
| Poor video/photo quality | Clean the lens. Ensure proper lighting. Check camera settings (resolution, stabilization). |
| Battery not holding charge | Ensure you are using a compatible charger and cable. Batteries degrade over time; consider replacing if significantly old or damaged. |
5.2 Resetting the Camera
If issues persist, a factory reset may resolve them. Navigate to the camera's settings menu and select the option to reset to factory defaults. Warning: This will erase all custom settings.
6. Specifications
| Feature | Detail |
|---|---|
| Model Number | CHDHX-101 |
| Processor | GP2 Chip |
| Video Resolution | Up to 5.3K60, 4K120, 2.7K240 |
| Photo Resolution | 23MP |
| Stabilization | HyperSmooth 4.0 |
| Waterproof Depth | 33 ft (10 m) without housing |
| Displays | Front LCD, Rear Touchscreen |
| Connectivity | USB-C, Wi-Fi, Bluetooth |
| Battery Capacity | 1720mAh |
| Dimensions | 1.3 x 2.8 x 2.2 inches |
| Weight | 1.1 pounds |
7. Warranty and Support
7.1 Amazon Renewed Guarantee
This product is part of the Amazon Renewed program. It has been professionally inspected and tested to work and look like new. If you are not satisfied with your purchase, renewed products are eligible for replacement or refund under the Amazon Renewed Guarantee within 90 days of receipt.
7.2 Product Support
For additional support, troubleshooting guides, or to access the latest firmware, please visit the official GoPro support website. You can also refer to the GoPro Quik app for camera management and assistance.
8. Official Product Videos
No official product videos from the seller were available for embedding in this manual.
