HARIO XRCP-1

HARIO XRCP-1 Single Serving Heat Resistant Glass Rice Cooker Instruction Manual

Model: XRCP-1

Introduction

The HARIO XRCP-1 is a compact, heat-resistant glass rice cooker designed for preparing single servings of rice quickly and efficiently in a microwave. Its transparent borosilicate glass construction allows for easy monitoring of the cooking process. This manual provides essential instructions for the safe and effective use of your HARIO XRCP-1 rice cooker.

HARIO XRCP-1 glass rice cooker with lid

Image: The HARIO XRCP-1 glass rice cooker, showing its transparent body and lid.

Setup

  1. Unpacking: Carefully remove all components from the packaging. Ensure you have the main glass pot and the glass lid with its silicone ring.
  2. Initial Cleaning: Before first use, wash all parts (glass pot, lid, and silicone ring) with warm soapy water. Rinse thoroughly and dry completely.
  3. Assembly: Place the silicone ring securely around the rim of the glass lid. Ensure it is fitted correctly to create a proper seal.
Empty HARIO XRCP-1 glass rice cooker with lid

Image: The HARIO XRCP-1 rice cooker empty, ready for use.

Operating Instructions

Follow these steps to cook rice using your HARIO XRCP-1 rice cooker:

  1. Measure Rice: Add 0.5 to 1 serving (0.5 to 1 cup) of uncooked rice to the glass pot.
  2. Rinse Rice: Rinse the rice thoroughly under cold water until the water runs clear. Drain well.
  3. Add Water: For 1 serving of rice, add water up to the upper line marked on the pot. For 0.5 serving, add water up to the lower line. Adjust water quantity based on desired rice texture.
Pouring water into the HARIO XRCP-1 rice cooker with rice

Image: A hand pouring water into the HARIO XRCP-1 rice cooker containing uncooked rice.

  1. Soak Rice: For best results, allow the rice to soak in the water for at least 30 minutes, or longer if possible, before cooking. This helps ensure even cooking.
  2. Place Lid: Place the glass lid securely on the pot.
  3. Microwave Cooking: Place the rice cooker in your microwave. For 1 serving of rice, heat at 600W for 10 minutes. Cooking times may vary depending on your microwave's power and the amount of rice.
Placing HARIO XRCP-1 rice cooker into a microwave

Image: A person carefully placing the HARIO XRCP-1 rice cooker into a microwave oven.

HARIO XRCP-1 rice cooker inside a microwave during cooking

Image: The HARIO XRCP-1 rice cooker inside a microwave, showing the cooking process.

  1. Resting Time: After microwaving, carefully remove the hot rice cooker from the microwave using oven mitts. Let it rest, with the lid on, for 10-15 minutes. This allows the rice to steam and become fluffy.
  2. Serve: Fluff the rice with a fork or spoon and serve immediately.
Cooked rice in HARIO XRCP-1 rice cooker on a wooden table

Image: Freshly cooked rice in the HARIO XRCP-1 rice cooker, ready to be served.

Maintenance and Cleaning

Proper care will extend the life of your HARIO XRCP-1 rice cooker:

  • Washing: All glass parts and the silicone ring are dishwasher safe. For best results and to prolong the life of the silicone, hand washing with warm soapy water is recommended.
  • Drying: Ensure all parts are completely dry before storing to prevent water spots or odors.
  • Stains: For stubborn food residue, soak the glass pot in warm soapy water before cleaning. Avoid abrasive cleaners or scouring pads that could scratch the glass.
  • Silicone Ring: Periodically remove the silicone ring from the lid for thorough cleaning to prevent food buildup. Ensure it is re-seated correctly before next use.

Troubleshooting

ProblemPossible CauseSolution
Rice is unevenly cooked or hard in the center.Insufficient water; insufficient soaking time; microwave power too high/low.Ensure correct water level. Increase soaking time before cooking. Adjust microwave power or cooking duration.
Water boils over or splashes in the microwave.Too much water; microwave power too high; silicone ring not seated correctly or causing excessive pressure.Reduce water slightly. Lower microwave power or cooking duration. Ensure silicone ring is properly fitted. Some users find removing the silicone ring helps prevent boil-overs.
Lid silicone part feels weak or damaged.Wear and tear over time.Inspect the silicone ring for damage. Replacement parts may be available from HARIO's official website or authorized retailers.

Specifications

  • Model Number: XRCP-1
  • Brand: HARIO
  • Material: Borosilicate Glass, Silicone Rubber
  • Color: Clear
  • Capacity: 250 Milliliters (0.3 Quarts)
  • Product Dimensions (D x W x H): 6.3" x 7.87" x 5.63"
  • Item Weight: 1.1 Kilograms
  • Is Oven Safe: No
  • Is Suitable For Stovetop: Yes

Warranty and Support

For specific warranty information, please refer to the documentation included with your purchase or visit the official HARIO website. For product support, inquiries, or to purchase replacement parts, please contact HARIO customer service through their official channels.

HARIO Official Website: https://www.hario.jp/

© 2026 HARIO. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.