Nemesis NA-6.5M

Nemesis NA-6.5M 6.5 Inch 4 Ohm Midrange Car Audio Speaker User Manual

1. Introduction

This manual provides comprehensive instructions for the installation, operation, and maintenance of your Nemesis NA-6.5M 6.5 Inch 4 Ohm Midrange Car Audio Speaker. Please read this manual thoroughly before attempting installation or use to ensure proper function and longevity of your product. Retain this manual for future reference.

Nemesis NA-6.5M 6.5 Inch Midrange Car Audio Speaker

Figure 1: Nemesis NA-6.5M 6.5 Inch Midrange Car Audio Speaker. This image shows a close-up view of the speaker, highlighting its black paper cone, cloth edge, and silver bullet phase plug. The sturdy frame and connection terminals are also visible.

2. Product Features

The Nemesis NA-6.5M speaker is engineered to deliver clear and powerful midrange audio in your vehicle. Key features include:

  • Speaker Type: 6.5 Inch Midrange Speaker
  • Power Handling: 360 Watts Maximum / 180 Watts RMS
  • Frequency Response: 130 Hz – 20 KHz
  • Sensitivity: 93 dB
  • Impedance: 4 Ohm
  • Cone Material: Paper Cone with Cloth Edge
  • Magnet: 28 Oz Magnet with Rubber Magnet Boot
  • Voice Coil: 1.5 KSV Voice Coil
  • Frame: Stamped Steel Frame (inferred from video)
  • Phase Plug: Bullet Phase Plug (inferred from image/video)

3. Setup & Installation

Proper installation is crucial for optimal performance and safety. If you are unsure about any steps, it is recommended to seek professional installation.

3.1 Safety Precautions

  • Disconnect the vehicle's battery before starting any electrical work.
  • Wear appropriate safety gear, including eye protection.
  • Ensure all wiring is correctly routed and secured to prevent damage or short circuits.
  • Verify speaker impedance matches your amplifier's capabilities (this speaker is 4 Ohm).

3.2 Mounting

  1. Choose a suitable mounting location in your vehicle. The NA-6.5M's relatively small mounting depth (approximately 4 inches) allows for flexible placement.
  2. Carefully mark the mounting holes using the speaker as a template.
  3. Cut the speaker opening if necessary, ensuring it matches the speaker's diameter (6.5 inches).
  4. Drill pilot holes for the mounting screws.
  5. Secure the speaker using appropriate screws, ensuring a snug fit without overtightening.

3.3 Wiring

  1. Connect the speaker wires from your amplifier to the speaker terminals. Ensure correct polarity (positive to positive, negative to negative).
  2. Use high-quality speaker wire of adequate gauge for your system.
  3. Insulate all connections to prevent short circuits.
  4. Once all connections are made, reconnect the vehicle's battery.

3.4 Installation Demonstration Video

Video 1: This video demonstrates the features and sound quality of a 6.5-inch midrange car audio speaker, highlighting its construction, power handling, and sound reproduction capabilities. It showcases the speaker's cone movement, stamped steel frame, voice coil, and bullet phase plug, providing visual context for installation and performance.

4. Operating Instructions

Once installed, your Nemesis NA-6.5M speakers are ready for use. Follow these general guidelines for optimal audio experience:

  • Initial Power-Up: Start with the amplifier gain set to its lowest level. Gradually increase the volume to a comfortable listening level.
  • Audio Source: Use high-quality audio sources (e.g., uncompressed digital files) for the best sound reproduction.
  • Equalization: Adjust your head unit's or amplifier's equalizer settings to fine-tune the sound to your preference. Avoid excessive boosting of frequencies, which can lead to distortion.
  • Volume Levels: While the speakers are designed for high power, prolonged listening at maximum volume can cause listener fatigue and potential speaker damage. Listen responsibly.
  • Break-in Period: Allow a short break-in period (typically 10-20 hours of normal use) for the speaker components to loosen up and achieve their full sound potential.

5. Maintenance

Regular maintenance helps preserve the performance and appearance of your speakers.

  • Cleaning: Use a soft, dry cloth to gently wipe down the speaker cones and surrounds. Avoid using harsh chemicals or abrasive materials.
  • Inspection: Periodically check speaker connections for tightness and ensure no wires are frayed or exposed.
  • Environmental Factors: Protect speakers from extreme temperatures, direct sunlight, and excessive moisture.

6. Troubleshooting

If you encounter issues with your Nemesis NA-6.5M speakers, refer to the following common problems and solutions:

ProblemPossible CauseSolution
No SoundLoose or incorrect wiring; amplifier off or faulty; head unit issue.Check all speaker and amplifier connections. Ensure amplifier is powered on and functioning. Verify head unit output.
Distorted SoundAmplifier gain too high; damaged speaker; incorrect equalization settings.Reduce amplifier gain. Check speaker cone for physical damage. Adjust equalizer settings to neutral or slightly boosted.
Weak or Muffled SoundIncorrect speaker polarity; low power input; poor audio source quality.Verify speaker wire polarity. Ensure amplifier is providing adequate power. Use higher quality audio files.
Intermittent SoundLoose connections; faulty wiring; amplifier overheating.Check and secure all connections. Inspect wiring for damage. Ensure amplifier has proper ventilation.

If the problem persists after attempting these solutions, contact customer support or a qualified car audio technician.

7. Specifications

Detailed technical specifications for the Nemesis NA-6.5M 6.5 Inch 4 Ohm Midrange Car Audio Speaker:

SpecificationValue
Model NameNA-6.5M
Speaker TypeMidrange
Recommended UsesCar Audio
Compatible DevicesSmartphone, Tablet, MP3 Player, Desktop, Television, Projector, Laptop (via car audio system)
Speaker Size6.5 Inches
Maximum Output Power360 Watts
RMS Power180 Watts (from description)
Frequency Response130 Hz – 20 KHz
Sensitivity93 dB
Impedance4 Ohm
Magnet Weight28 Oz
Voice Coil1.5 KSV
Product Dimensions4"D x 17"W x 4"H (Package Dimensions) / 17 x 9 x 4 inches (Product Dimensions)
Item Weight9.99 Pounds / 159.84 Ounces
Connectivity TechnologyWired
Mounting TypeCar Mount
UPC764488483976

8. Warranty & Support

Your Nemesis NA-6.5M speaker comes with a Limited Warranty. For specific details regarding warranty coverage and duration, please refer to the manufacturer's official website or the terms provided at the point of purchase. Warranty policies are generally subject to Amazon's policies.

For technical assistance, troubleshooting beyond this manual, or warranty claims, please contact Nemesis customer support through their official channels or the retailer from whom the product was purchased.

Related Documents - NA-6.5M

Preview Panasonic Washing Machine Service Manual
Comprehensive service manual for Panasonic fully automatic washing machines (household use). Includes safety precautions, part names, specifications, technical descriptions, installation guides, and troubleshooting tips.
Preview Panasonic Fully Automatic Washing Machine Operating & Installation Instructions
Comprehensive guide for Panasonic Fully Automatic Washing Machines (Models NA-F75S7, NA-F70S7, NA-F65S7, NA-F75V7, NA-F70V7, NA-F65V7, NA-F62V7, NA-F70X7, NA-F65X7, NA-F62X7). Includes safety, installation, operation, maintenance, and troubleshooting instructions.
Preview Legrand ON-Q Plastic Enclosure Installation Instructions
Comprehensive installation guide for Legrand ON-Q plastic enclosures, detailing physical installation, power connection, trim ring assembly, door locking, and safety precautions. Includes model numbers and replacement kit information.
Preview B&G Nemesis Quick Guide - Operation and Features
A concise guide to operating the B&G Nemesis multifunction display, covering system startup, screen locking, dashboard management, and system settings.
Preview Panasonic Washer Dryer Operating and Installation Instructions
Comprehensive guide for Panasonic Washer Dryer models NA-S056FR1, NA-S106FR1, NA-S96FR1, NA-S106FC1, NA-S956FC1, NA-S96FC1, covering operation, installation, safety, and maintenance.
Preview Lincoln Electric NA-5 Automatic Welding Systems Service Manual
This service manual provides comprehensive instructions for the installation, operation, and maintenance of the Lincoln Electric NA-5 Automatic Welding Systems. It includes detailed safety precautions, technical specifications, wiring diagrams, and troubleshooting guides for various models.