1. Introduction
This manual provides essential information for the safe and efficient use of your IKRA 20V 2.0Ah Lithium-Ion Battery, Type LI 22. This high-quality lithium-ion battery is designed to perfectly fit all IKRA 20V cordless garden tools. It features an LED display to indicate the remaining battery power at all times. Please read this manual thoroughly before first use and keep it for future reference.
Figure 1: IKRA 20V 2.0Ah Lithium-Ion Battery, Model LI 22.
2. Safety Information
Always observe the following safety precautions to prevent injury and damage to the battery or tool.
- Read Instructions: Always read the instruction manual for both the battery and the tool before use.
- Charging: Only use the original IKRA charger designed for this battery. Do not attempt to charge damaged batteries. Charge in a well-ventilated area, away from flammable materials.
- Handling: Do not short-circuit the battery terminals. Avoid dropping the battery or subjecting it to strong impacts. Do not open, disassemble, or modify the battery.
- Temperature: Do not expose the battery to extreme temperatures (above 50°C / 122°F or below -10°C / 14°F) or direct sunlight. Store in a cool, dry place.
- Moisture: Keep the battery dry. Do not expose it to water or rain.
- Disposal: Dispose of batteries responsibly according to local regulations. Do not dispose of batteries in household waste or by incineration.
- Children: Keep batteries out of reach of children.
3. Setup
3.1 Initial Charging
Before first use, fully charge the battery. The IKRA fast charger can fully recharge a battery in approximately 60 minutes.
- Connect the charger to a suitable power outlet.
- Insert the battery into the charger, ensuring it clicks securely into place.
- Monitor the charging indicator lights on the charger (refer to your charger's manual for specific light patterns).
- Once fully charged, remove the battery from the charger.
Figure 2: IKRA 20V Battery and compatible charger (charger sold separately).
3.2 Inserting the Battery into a Tool
The IKRA LI 22 battery is compatible with a wide range of IKRA 20V ONE-FOR-ALL cordless garden tools. These include, but are not limited to: IART 2025, IART 2030F, IAHS 20-1, ICPH 2040, ICPH 2050, ICC 2/2035, ICPS 2020, IAMH 20, ICB 20, ICBV 2/20, IALS 2-20, ICHM 20, ICM 2033, ICM 2/2037, IASM 20.
- Ensure the tool is switched off and disconnected from any power source (if applicable).
- Align the battery with the battery compartment on the tool.
- Slide the battery firmly into the compartment until it clicks into place, indicating it is securely locked.
Figure 3: Inserting the battery into an IKRA cordless tool.
Figure 4: The battery fits various IKRA 20V tools, including lawnmowers.
4. Operating the Battery
4.1 Checking Battery Charge Level
The battery is equipped with an LED indicator to show the current charge level. Press the small button next to the LEDs to activate the display.
- 4 LEDs lit: Full charge (75-100%)
- 3 LEDs lit: Good charge (50-75%)
- 2 LEDs lit: Low charge (25-50%)
- 1 LED lit: Very low charge (0-25%), recharge soon
- No LEDs lit: Battery empty or faulty
Figure 5: Checking the battery charge level using the LED indicator.
4.2 Removing the Battery from a Tool
- Ensure the tool is switched off.
- Locate the battery release button(s) on the battery or tool.
- Press and hold the release button(s) while sliding the battery out of the compartment.
Figure 6: Pressing the release button to remove the battery.
5. Maintenance and Storage
5.1 Cleaning
Keep the battery clean and free from dirt, dust, and moisture. Use a soft, dry cloth to wipe the battery. Do not use cleaning agents or solvents.
5.2 Storage
- Store the battery in a cool, dry place, away from direct sunlight and extreme temperatures.
- For long-term storage, it is recommended to store the battery with a partial charge (around 50-75%) rather than fully charged or completely empty.
- If storing for extended periods, recharge the battery every 3-6 months to maintain its health.
- Store the battery separately from the tool.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Battery not charging. | Charger not plugged in; faulty charger; battery too hot/cold; damaged battery. | Ensure charger is properly connected. Try another outlet. Allow battery to reach room temperature. If damaged, replace battery. |
| Tool not operating with battery. | Battery not fully inserted; battery discharged; faulty battery; faulty tool. | Ensure battery is securely clicked into place. Check battery charge level and recharge if necessary. Test battery in another compatible tool if available. If tool is faulty, refer to tool's manual. |
| LED indicators not working. | Button not pressed firmly; battery completely discharged; internal fault. | Press the button firmly. Attempt to charge the battery. If still unresponsive, the battery may be faulty. |
If problems persist, please contact IKRA customer support.
7. Specifications
| Feature | Detail |
|---|---|
| Model Name | IKRA 20V 2.0Ah Lithium-Ion Type LI 22 |
| Model Number | 15130060-AZ |
| Battery Type | Lithium-Ion |
| Voltage | 20V |
| Capacity | 2.0 Ah |
| Energy | 40 Wh |
| Weight | 360 Grams |
| Dimensions (L x W x H) | 12.5 x 8.4 x 5.5 cm |
| Approx. Charging Time (with fast charger) | 60 minutes |
| Compatibility | IKRA 20V ONE-FOR-ALL System Tools |
8. Warranty and Support
For warranty information, please refer to the documentation provided with your original product purchase or visit the official IKRA website. Keep your proof of purchase for any warranty claims.
For further assistance or technical support, please contact IKRA customer service. You can find more information and contact details on the official IKRA brand store:
