Introduction
Thank you for purchasing the Accutime Kids Disney Lilo and Stitch Digital LED Quartz Wrist Watch. This manual provides essential information for the proper setup, operation, and maintenance of your new watch. Please read this manual thoroughly before use to ensure optimal performance and longevity of the product.
This watch is designed for children aged 3 years and older, featuring an easy-to-read digital display and a fun Lilo & Stitch design.
Product Overview
Figure 1: Front view of the Lilo and Stitch Digital Watch, displaying the time and featuring a decorative leaf charm.
Figure 2: Side view of the watch, highlighting the adjustment button on the right side of the watch face.
Key Features:
- Clear, easy-to-read LCD digital display.
- Accurate Quartz movement for precise timekeeping.
- Durable, kid-friendly design with a multicolor graphic strap.
- Features popular Lilo & Stitch characters and a hanging charm.
- Includes a pre-installed watch battery.
Setup
Initial Setup:
- Unboxing: Carefully remove the watch from its packaging. Ensure all components are present.
- Battery Activation: The watch comes with a pre-installed battery. If the display is not active, gently press the button on the side of the watch face to activate the display.
Setting the Time:
The watch features a single button for time adjustment. Follow these steps to set the correct time:
- Display Activation: Press the button once to display the current time.
- Enter Setting Mode: Press and hold the button for approximately 3 seconds until the hour digits begin to flash.
- Adjust Hour: While the hour digits are flashing, press the button repeatedly to advance the hour. The time cycles through AM/PM.
- Set Minutes: After setting the hour, press and hold the button again for approximately 3 seconds until the minute digits begin to flash.
- Adjust Minutes: While the minute digits are flashing, press the button repeatedly to advance the minutes.
- Exit Setting Mode: Once the minutes are set, press and hold the button for approximately 3 seconds until the digits stop flashing. The time is now set.
Figure 3: Rear view of the watch, indicating the battery type and model number (LAS4033AZ).
Operating Instructions
Checking the Time:
Simply press the side button once to illuminate the LED display and show the current time. The display will automatically turn off after a few seconds to conserve battery life.
Wearing the Watch:
Adjust the strap to fit comfortably around the wrist. Ensure it is snug but not too tight to allow for proper circulation.
Figure 4: Example of the watch being worn on a child's wrist.
Maintenance
Cleaning:
- Wipe the watch face and strap with a soft, dry cloth.
- For stubborn dirt, a slightly damp cloth can be used, but ensure no water enters the watch mechanism.
Battery Replacement:
The watch uses a CR2032 (3V) Japan battery. When the display becomes dim or stops working, it's time to replace the battery. Battery replacement should ideally be performed by a qualified technician to avoid damaging the watch or compromising its internal components.
Note: Improper battery replacement can void the warranty.
Storage:
When not in use, store the watch in a cool, dry place away from direct sunlight and extreme temperatures.
Water Resistance:
This watch is NOT water resistant. Avoid exposure to water, including showering, swimming, or heavy rain, as this will damage the watch and void the warranty.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Display is blank or dim. | Battery is low or depleted. | Replace the battery (CR2032 3V). |
| Time is incorrect. | Time needs to be reset. | Follow the "Setting the Time" instructions in the Setup section. |
| Watch not responding to button presses. | Battery issue or internal malfunction. | Replace battery. If problem persists, contact customer support. |
| Moisture inside the watch. | Exposure to water. | This watch is not water resistant. Discontinue use and contact customer support. Water damage is not covered under warranty. |
Specifications
- Model Number: LAS4033AZ
- Display Type: Digital LED
- Movement: Quartz
- Battery Type: 1 x CR2032 (3V) Japan Battery
- Case Material: Plastic Caseback
- Strap Material: Silicone/Plastic
- Recommended Age: 3+ years
- Water Resistance: Not Water Resistant
- Package Dimensions: 3.11 x 3.07 x 3.03 inches
- Item Weight: 3.84 ounces
- Manufacturer: Accutime Watch Corp.
Warranty Information
This Accutime Kids Disney Lilo and Stitch Digital LED Quartz Wrist Watch comes with a One Year Warranty from Accutime Watch. This warranty covers manufacturing defects under normal use.
The warranty does not cover:
- Damage caused by improper use or neglect.
- Damage caused by exposure to water or moisture.
- Normal wear and tear.
- Battery replacement (though a battery is included upon purchase).
- Unauthorized repairs or modifications.
Please retain your proof of purchase for warranty claims.
Customer Support
For any questions, concerns, or warranty claims regarding your Accutime Kids Disney Lilo and Stitch Digital LED Quartz Wrist Watch, please contact Accutime Watch Corp. customer service.
Manufacturer: Accutime Watch Corp.
For the most up-to-date contact information, please visit the official Accutime website or refer to the packaging.
You can also visit the Accutime Store on Amazon for more information.