Bitvae Water Flosser and Electric Toothbrush Combo User Manual

Important Safety Information

For safe and proper use of your Bitvae Water Flosser and Electric Toothbrush Combo, please observe the following guidelines:

• Keep the device away from water and wet hands during charging or when not in use to prevent electrical hazards.
• Ensure the device is kept out of reach of children.
• If you have any pre-existing medical conditions, particularly related to oral health, consult a healthcare provider before using this device.
• Do not attempt to disassemble or repair the device yourself. Refer to qualified service personnel for any maintenance or repairs.
• Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition. This product is for oral hygiene purposes only.

Setup Guide

Follow these steps to set up your Bitvae Water Flosser and Electric Toothbrush Combo for first use:

Water Flosser Setup

1. Fill the Water Reservoir:

   Open the water reservoir cap. You can either remove the reservoir completely or fill it directly through the side opening. Fill with lukewarm water for comfort.

   

   Image: Two convenient methods for filling the water flosser reservoir.
2. Attach the Nozzle:

   Press the pop-up knob on the top of the flosser unit to release the nozzle slot. Insert your desired flosser tip until it clicks securely into place.

3. Select Mode and Intensity:

   The water flosser features 3 modes and 5 adjustable intensities. Press the mode button to cycle through Clean, Massage, and Jet modes. Use the intensity buttons to adjust the water pressure from light to high (1-5). If you are new to water flossing, start with the lowest intensity setting to allow your gums to adjust.

   

   Image: Water flosser control panel with mode and intensity selections.

Electric Toothbrush Setup

1. Attach the Brush Head:

   Align the brush head with the metal shaft on the toothbrush handle and push down firmly until it locks into place.

2. Initial Charge:

   Before first use, fully charge the electric toothbrush for approximately 4 hours. A full charge provides up to 30 days of use.

Operating Instructions

Using the Water Flosser

1. Position the Nozzle:

   Lean over a sink. Place the flosser nozzle into your mouth, directing it at a 90-degree angle towards your gumline. Ensure your lips are slightly closed around the nozzle to prevent splashing, but allow water to drain into the sink.

2. Activate and Clean:

   Press the power button to turn on the water flosser. Guide the water stream along your gumline, pausing briefly between teeth. The 360-degree rotatable nozzle allows for easy access to all areas of your mouth.

   

   Image: The water flosser nozzle offers 360-degree rotation for comprehensive cleaning.

3. Water Pressure:

   The water flosser provides strong water pressure ranging from 50-120 PSI for a deep clean, protecting your gums and removing up to 7X more stains than manual brushing.

   

   Image: The water flosser delivers powerful pressure for effective cleaning.

Using the Electric Toothbrush

1. Apply Toothpaste:

   Apply a small amount of toothpaste to the brush head.

2. Select Brushing Mode:

   The toothbrush offers 5 personalized cleaning modes: White (removes surface stains), Clean (daily cleaning), Soft (gentle massage for gums), Polish (brightens and polishes tooth surface), and Gum Care (gently cleans for sensitive gums). Select your preferred mode by pressing the mode button.

   

   Image: Choose from 5 personalized brushing modes for your specific oral care needs.

3. Brush Your Teeth:

   Place the brush head against your teeth at a slight angle towards the gumline. Move the brush slowly across each tooth. The toothbrush delivers 40,000 strokes per minute for effective cleaning.

4. Smart Timer:

   The toothbrush features a smart timed reminder. It will pause every 30 seconds to indicate when to move to a different quadrant of your mouth, and automatically shut off after 2 minutes, signaling the completion of the recommended brushing time.

   

   Image: Smart Timed Reminder for optimal brushing duration.

Maintenance

Proper maintenance ensures the longevity and effectiveness of your oral care combo:

• Cleaning the Water Flosser: After each use, empty any remaining water from the reservoir. Rinse the reservoir and the flosser tip thoroughly with clean water. Allow all components to air dry before reassembling.
• Replacing Nozzles: For optimal performance and hygiene, replace the water flosser nozzles every 3 months. The kit includes 4 replacement nozzles.
• Replacing Brush Heads: Replace the electric toothbrush brush head every 3 months. The W-shaped bristles are designed to adapt to the shape of your teeth for effective cleaning. The kit includes 4 replacement brush heads.


Image: W-shaped bristles for effective cleaning and an indicator for replacement.

• Charging: The portable cordless water flosser and sonic toothbrush combo have a long battery life (up to 40 days for the flosser, 30 days for the toothbrush). Recharge when the battery indicator is low.
• Waterproof Design: Both devices are IPX7 waterproof, allowing for safe use during showers and easy rinsing under running water.


Image: Both devices are IPX7 waterproof for convenient use and cleaning.

Troubleshooting

If you encounter any issues with your Bitvae Water Flosser and Electric Toothbrush Combo, please refer to the following common solutions:

• No Power/Device Not Turning On: Ensure the device is fully charged. Connect it to the charger and allow sufficient time for charging. Check the charging cable and adapter for any damage.
• Weak Water Pressure (Water Flosser): Ensure the water reservoir is adequately filled. Check if the nozzle is securely attached and not clogged. Clean the nozzle if necessary.
• Water Leakage (Water Flosser): Verify that the water reservoir is correctly seated and sealed. Ensure the nozzle is properly inserted.
• Toothbrush Not Vibrating Strongly: Ensure the brush head is correctly attached. Fully charge the toothbrush.
• Unusual Noise: If either device makes an unusual noise, stop use immediately and contact customer support.
• For persistent issues not covered here, please refer to the official user guide PDF or contact Bitvae customer support.

Specifications

Warranty and Support

The Bitvae Water Flosser and Electric Toothbrush Combo comes with a 2-Year Warranty, ensuring peace of mind regarding your purchase.

For detailed information, support, or warranty claims, please refer to the official user guide or contact Bitvae customer service:

• Official User Guide (PDF): Download User Guide
• Manufacturer: Bitvae
• For further assistance, visit the Bitvae Store on Amazon.