Wenko Classic Shower Bar with Hand Shower Holder - 70 cm, Black

1. Introduction

The Wenko Classic Shower Bar in black offers a practical and stylish solution for your bathroom. Crafted from high-quality stainless steel, it features an integrated, adjustable holder for your hand shower, allowing you to position it at your desired height for a comfortable showering experience. Its modern matte black finish complements various bathroom styles, from classic to industrial-chic.

2. Package Contents

Please verify that all components are present before beginning installation:

• 1 x Wenko Classic Shower Bar (70 cm, Black, Stainless Steel)
• 1 x Integrated Adjustable Hand Shower Holder
• Mounting Screws and Dowels

3. Safety Instructions

Please read and understand these safety instructions before installation and use:

• Always wear appropriate safety gear (e.g., eye protection) during installation.
• Ensure the mounting surface is suitable and can support the weight of the shower bar and any attached accessories.
• Do not hang or apply excessive weight to the shower bar, as this may cause damage or injury.
• Keep small parts out of reach of children to prevent choking hazards.

4. Setup and Installation

The shower bar is designed for secure wall mounting. Follow these steps for installation:

1. Mark Drilling Points: Position the shower bar on the wall at the desired height. Mark the locations for the two wall brackets. One bracket is fixed, while the other is movable to accommodate existing drill holes or cover them.
2. Drill Holes: Using an appropriate drill bit for your wall type, drill holes at the marked points. Insert the provided dowels into the drilled holes.
3. Mount Brackets: Secure the wall brackets to the wall using the provided screws. Ensure they are tightened firmly but do not overtighten.
4. Attach Shower Bar: Slide the shower bar into the mounted brackets. Secure it in place according to the bracket design, typically by tightening a small set screw on each bracket.
5. Adjust Hand Shower Holder: The hand shower holder can be adjusted along the bar. Loosen the holder, slide it to the desired height, and then tighten it to secure your hand shower.

5. Operating Instructions

Using the Wenko Classic Shower Bar is straightforward:

• Adjusting Hand Shower Height: To change the height of your hand shower, gently loosen the adjustable holder. Slide it up or down the shower bar to your preferred position. Once at the desired height, tighten the holder to secure the hand shower firmly in place.
• Hand Shower Angle: The holder also allows for minor angle adjustments of the hand shower for optimal spray direction.

6. Maintenance

To ensure the longevity and appearance of your shower bar, follow these maintenance guidelines:

• Cleaning: Clean the shower bar regularly with a soft, damp cloth. For stubborn marks, use a mild, non-abrasive cleaning solution specifically designed for stainless steel or bathroom fixtures.
• Avoid Harsh Chemicals: Do not use abrasive cleaners, scouring pads, or harsh chemical detergents, as these can damage the matte black finish and the stainless steel surface.
• Drying: After cleaning, wipe the shower bar dry with a clean, soft cloth to prevent water spots and maintain its finish.

7. Troubleshooting

If you encounter any issues with your shower bar, refer to the following common problems and solutions:

• Hand Shower Holder Slips: Ensure the adjustable holder is tightened sufficiently. If it continues to slip, check for any debris or wear on the internal mechanism that might prevent a secure grip.
• Shower Bar Feels Loose: Verify that the wall mounting screws are securely fastened. If necessary, re-tighten them. Avoid overtightening, which can damage the wall or the brackets.
• Difficulty Adjusting Holder: If the holder is stiff, ensure it is fully loosened before attempting to slide it. A small amount of silicone spray (avoiding contact with the finish) might help if friction is an issue.

8. Specifications

9. Warranty and Support

This Wenko product is covered by a 3-year warranty from the date of purchase. The warranty covers all material and manufacturing defects that impair the product's function. Damages resulting from improper use, incorrect installation, or natural wear and tear are excluded. This warranty does not limit your statutory warranty rights.

To make a warranty claim, please send the item along with your proof of purchase, adequately stamped and protected for transport, to the following address:

For support inquiries, you may also contact via email: service@wenko.de