Product Overview
The DT Systems D.O.G. Director 700 is a remote dog training e-collar system designed for effective and humane training. It features a 700-yard range, 10 levels of stimulation, and alternative training modes including vibration and tone. The system is built for durability and ease of use in various training environments.
Figure 1: DT Systems DD700 D.O.G. Director 700 E-Collar System, showing the remote transmitter and the collar receiver.
Figure 2: Diagram illustrating the key features of the DD700 system, including the RapiDial knob, buttons, and waterproof design.
Setup and Initial Use
Before using your DD700 system, ensure all components are properly prepared and charged.
Package Contents:
- Transmitter with Compact Antenna and Lanyard
- Collar Receiver with Rechargeable Li-Poly Battery (installed)
- Battery Charger
- Test Light
- Manuals
Charging the Collar Receiver:
- Connect the battery charger to the collar receiver's charging port.
- Plug the charger into a standard electrical outlet.
- Allow 2-3 hours for a full charge. The SmartLED Battery Charge Status indicator will provide charging status.
Figure 3: The DD700 collar receiver, which is waterproof and contains the rechargeable battery.
Transmitter Battery Installation:
The transmitter uses an easily replaceable 9V battery (not included). Refer to the transmitter's battery compartment for installation instructions.
Figure 4: The DD700 remote transmitter, showing the control buttons and antenna.
Turning On/Off the System:
Both the transmitter and the collar receiver feature a waterproof magnetic On/Off switch. To activate, align the magnetic points as indicated in the manual or on the device. Repeat to turn off.
Fitting the Collar:
The collar is adjustable to fit neck sizes from 7 to 22 inches. Ensure the contact points on the receiver make proper contact with your dog's skin. The collar should be snug enough not to move around, but loose enough to allow two fingers to fit comfortably under the strap.
Operating the DD700 System
The DD700 system offers various training modes and adjustable settings for effective dog training.
Transmitter Controls:
Figure 5: Proper grip of the DD700 remote transmitter, showing accessibility of control buttons.
- RapiDial Posi-Lock Selector Knob: This knob allows you to select one of 10 stimulation levels. Rotate the knob to increase or decrease the intensity.
- "N" Button (Nick Stimulation): Delivers a quick, split-second stimulation.
- "C" Button (Continuous Stimulation): Delivers continuous stimulation for up to 8 seconds, or until the button is released.
- "J" Button (Jump Feature): A user-programmable one-touch option to instantly switch to a pre-set higher or lower stimulation level (from 1-10).
- "V/T" Button (Vibration Assist / Beeping Tone): Activates either a gentle vibration or an audible beep, depending on the selected mode. This serves as a no-stimulation alternative.
Training Modes:
- Stimulation: Use Nick or Continuous stimulation at appropriate levels for correction. Start with the lowest effective level.
- Vibration Assist: Provides a tactile cue without electrical stimulation, ideal for sensitive dogs or as an initial warning.
- Beeping Tone: Emits an audible sound, useful for recall or as a warning signal.
The DD700 system utilizes MAXX-Range 360 technology, providing a reliable 700-yard range for effective control in various terrains.
Maintenance
Proper maintenance ensures the longevity and optimal performance of your DD700 system.
Cleaning:
Both the transmitter and collar receiver are 100% waterproof. After use, especially in wet or muddy conditions, wipe down the units with a damp cloth. Ensure contact points on the collar are clean and free of debris.
Battery Care:
- Regularly charge the collar receiver's Li-Poly battery. Avoid completely draining the battery before recharging.
- Replace the 9V battery in the transmitter as needed.
- Store the units in a cool, dry place when not in use.
Troubleshooting
If you encounter issues with your DD700 system, refer to the following common troubleshooting steps:
| Problem | Possible Cause | Solution |
|---|---|---|
| Collar not responding to transmitter. | Low battery in collar or transmitter; Out of range; Collar not turned on. | Charge collar battery; Replace transmitter battery; Ensure both units are turned on and within range. |
| Stimulation not felt by dog. | Collar too loose; Contact points not touching skin; Stimulation level too low. | Adjust collar for snug fit; Ensure contact points are clean and making good contact; Increase stimulation level gradually. |
| Transmitter not powering on. | Dead 9V battery; Magnetic switch not activated correctly. | Replace 9V battery; Re-engage magnetic switch. |
For further assistance, please contact DT Systems customer support.
Specifications
| Feature | Detail |
|---|---|
| Model Name | DD700 |
| Brand | DT Systems |
| Range | 700 Yards (MAXX-Range 360 Technology) |
| Stimulation Levels | 10 (Nick and Continuous) |
| Alternative Modes | Vibration Assist, Beeping Tone |
| Waterproof | 100% (Transmitter and Collar) |
| Collar Adjustment | 7 to 22 inches |
| Collar Battery | Rechargeable Li-Poly |
| Collar Charge Time | 2-3 hours (Quick Charge) |
| Transmitter Battery | 9V (not included, replaceable) |
| Item Weight | 8 Ounces |
| Material | Plastic |
| Color | Black |
| Target Species | Dog |
Figure 6: Visual summary of the DD700's key specifications, including range, stimulation levels, and battery information.
Warranty and Support
The DT Systems DD700 D.O.G. Director 700 comes with a Limited Lifetime Warranty. For detailed warranty information, please refer to the warranty card included with your product or visit the official DT Systems website.
For technical support, troubleshooting assistance, or inquiries regarding your product, please contact DT Systems customer service directly. Contact information can typically be found on the manufacturer's website or in the product packaging.
