1. Introduction
This manual provides essential information for the safe and effective use of Renata 394 SR936SW Silver Oxide Watch Batteries. These high-quality, Swiss-made batteries are designed for reliable performance in various small electronic devices, particularly watches.
What's in the Box
- Renata 394 SR936SW Silver Oxide Batteries (2 Count)
Image: A blister pack containing two Renata 394 SR936SW silver oxide batteries, ready for use.
2. Setup & Installation
Installing the Renata 394 SR936SW battery requires careful handling to avoid damage to the battery or the device. It is recommended to consult your device's specific instruction manual for detailed battery replacement procedures. Always ensure the device is powered off before attempting battery replacement.
General Installation Steps (for watches):
- Prepare Your Workspace: Work on a clean, well-lit surface to prevent loss of small components.
- Open the Watch Case: Carefully open the back of your watch using appropriate watch tools.
- Locate the Old Battery: Identify the existing battery and its retaining clip or mechanism.
- Remove the Old Battery: Gently release any clips or levers holding the battery in place. Use non-metallic tweezers or a plastic tool to avoid short-circuiting the battery. Note the orientation of the old battery (positive (+) side up or down).
- Insert the New Battery: Place the new Renata 394 SR936SW battery into the compartment with the correct orientation. Ensure it sits securely.
- Secure the Battery: Re-engage any retaining clips or levers to hold the new battery firmly.
- Close the Watch Case: Carefully close and secure the watch back.
Image: A close-up view of a watch movement with a Renata 394 SR936SW battery correctly positioned within its compartment.
Image: A detailed shot showing a Renata 394 SR936SW battery being carefully placed into a watch's battery slot, highlighting the precise fit.
3. Operating Instructions
Once the Renata 394 SR936SW battery is correctly installed, your device should resume normal operation. For watches, the hands should begin to move, and any digital displays should activate. If the device does not power on, refer to the Troubleshooting section.
These batteries provide a stable 1.55V output, ensuring consistent performance for compatible devices. They are designed for high capacity retention and low self-discharge, offering a long shelf life and reliable power over time.
4. Maintenance & Storage
Storage:
- Store unused batteries in their original packaging at room temperature (20-25°C / 68-77°F) in a dry place.
- Avoid extreme temperatures and direct sunlight.
- Keep batteries away from children and pets.
Handling:
- Do not short-circuit, recharge, or dispose of batteries in fire.
- Do not mix old and new batteries, or different types of batteries.
- If a battery leaks, avoid contact with skin and eyes. Rinse immediately with water and seek medical attention if irritation persists.
Disposal:
Dispose of used batteries according to local regulations. Many communities offer battery recycling programs.
5. Troubleshooting
Device Not Powering On After Battery Replacement:
- Check Battery Orientation: Ensure the battery is inserted with the correct positive (+) and negative (-) polarity.
- Secure Connection: Verify that the battery is firmly seated in its compartment and any retaining clips are properly engaged.
- Inspect for Debris: Check the battery contacts and compartment for any dust, dirt, or corrosion that might impede electrical contact. Clean gently with a dry, soft cloth if necessary.
- Verify Battery Functionality: If possible, test the new battery with a battery tester to ensure it is not depleted or faulty.
- Consult Device Manual: Refer to your device's specific instruction manual for any unique battery replacement steps or troubleshooting tips.
If issues persist, it may indicate a problem with the device itself rather than the battery. Seek professional repair if needed.
6. Specifications
| Feature | Detail |
|---|---|
| Model Number | 394 / SR936SW |
| Battery Type | Silver Oxide |
| Nominal Voltage | 1.55V |
| Nominal Capacity | 80 mAh |
| Chemistry | 0% Mercury |
| Key Features | Superior Leakage Resistance, High Capacity Retention, Low Self-Discharge, Swiss Quality |
| Recommended Uses | Watches, Toys, Cameras, Calculators, Car Security Alarms, Keyless Car Remotes, Organizers, Computer Equipment (Memory Backup Battery) CMOS |
Image: A Renata 394 SR936SW silver oxide battery shown alongside a graphic detailing its voltage, capacity, diameter, height, and IEC equivalent.
7. Warranty & Support
Renata batteries are manufactured with Swiss quality standards, ensuring consistent performance. For specific warranty information or technical support, please refer to the official Renata website or contact your retailer.
Manufacturer: Renata Batteries
Date First Available: August 19, 2014
Official Product Video:
Video: An official promotional video from Renata, titled "Renata Batteries - The Swiss Power Source," showcasing the brand's commitment to quality and precision in battery manufacturing.