1. Introduction
The OLIGHT SROD-7 is a magnetic remote pressure switch designed to provide quick and convenient control for compatible Olight flashlights. This accessory allows users to operate their flashlight without adjusting their grip, enhancing tactical efficiency and ease of use.
Compatibility Note: The SROD-7 switch is compatible with the following Olight flashlight models: Odin S, Odin GL M, Odin GL Mini, Warrior 3, Warrior X 3, Warrior X 4, Warrior 3S, and Javelot Pro 2. It is not compatible with the original Odin and Odin Mini models.
Figure 1: The OLIGHT SROD-7 Magnetic Remote Pressure Switch, showing the magnetic connector and the dual-button pressure pad.
2. Package Contents
- SROD-7 Magnetic Remote Switch ×1
3. Setup and Installation
Follow these steps to properly install your SROD-7 Magnetic Remote Pressure Switch:
- Attach Magnetic Connector: Securely connect the magnetic end of the SROD-7 switch to the tail switch of your compatible Olight flashlight. Ensure a firm magnetic connection.
- Mount Pressure Pad: The pressure pad can be mounted to a Picatinny rail system. The SROD-7 pressure switch mount occupies approximately 10 rail slots (3.75 inches). Slide the pressure pad onto the desired rail section until it clicks into place. Ensure it is positioned for comfortable and intuitive access.
- Cable Management: Route the cable to prevent snagging or interference with other equipment. Use cable ties or clips (not included) if necessary to secure the cable along your setup.
Figure 2: An illustration of various Olight flashlight models compatible with the SROD-7 switch, including Odin GL M, Odin GL Mini, Odin S, Javelot Pro 2, Warrior 3, and Warrior X 3. A note indicates incompatibility with Odin and Odin Mini.
Figure 3: A diagram showing the SROD-7 pressure switch mount, indicating it takes up 10 rail slots (3.75 inches).
4. Operating Instructions
The SROD-7 remote pressure switch provides intuitive control over your connected Olight flashlight. It features a dual-button design for versatile operation.
- Momentary Activation: Press and hold the larger, main button on the pressure pad for momentary activation of the flashlight. Release the button to turn the light off.
- Constant On/Off: A quick press of the smaller, secondary button will toggle the flashlight between constant on and off.
- Mode Selection: The switch is designed to output two-level white light. Depending on your flashlight model, the pressure switch may allow cycling between high and low output levels. Refer to your specific flashlight's manual for detailed mode operation with a remote switch.
Figure 4: An extended view of the OLIGHT SROD-7 Magnetic Remote Pressure Switch, showing the full length of the cable connecting the magnetic tail cap to the pressure pad.
5. Maintenance
To ensure the longevity and reliable performance of your SROD-7 switch, follow these maintenance guidelines:
- Cleaning: Wipe the switch and cable with a clean, dry cloth to remove dirt, dust, or debris. Avoid using harsh chemicals or abrasive materials.
- Connection Check: Periodically inspect the magnetic connection point and the cable for any signs of wear or damage. Ensure the magnetic connector is free of obstructions.
- Storage: Store the switch in a cool, dry place away from direct sunlight and extreme temperatures when not in use.
6. Troubleshooting
If you encounter issues with your SROD-7 switch, consider the following:
- Switch Not Responding:
- Ensure the magnetic connector is fully seated and making proper contact with the flashlight's tail switch.
- Verify that the flashlight itself is charged and operational.
- Check for any visible damage to the cable or pressure pad.
- Intermittent Function:
- Inspect the cable for kinks, sharp bends, or damage that could affect conductivity. Improper routing can sometimes lead to intermittent issues.
- Ensure the magnetic connection is clean and free of debris that might interfere with the electrical contact.
- Incompatibility: Confirm your flashlight model is listed as compatible with the SROD-7 switch (refer to Section 1). The switch will not function with incompatible models.
7. Specifications
| Feature | Specification |
|---|---|
| Model Number | O-sROD7-BK#US-FBA |
| Brand | OLIGHT |
| Operation Mode | OFF-NONE-ON |
| Contact Type | Physical |
| Connector Type | Magnetic (USB for charging, not for data) |
| Terminal | Screw |
| Circuit Type | 2-way |
| Actuator Type | Push Button |
| Contact Material | Rubber (Potential, Not Confirmed) |
| International Protection Rating | IP65 |
| Number of Positions | 2 |
| Package Dimensions | 6.93 x 2.95 x 1.14 inches |
| Weight | 0.01 ounces |
8. Warranty and Support
OLIGHT products are designed for durability and performance. The SROD-7 Magnetic Remote Pressure Switch is covered by OLIGHT's Lifetime Warranty, ensuring peace of mind for your purchase.
For technical assistance, warranty claims, or further inquiries, please contact OLIGHT customer support through their official website or authorized retailers. Provide your product model and purchase details for efficient service.
