1. Introduction
This manual provides essential information for the safe and efficient use of your Respekta KS88.0 built-in refrigerator. Please read these instructions carefully before installation and operation, and retain them for future reference. Proper installation, operation, and maintenance are crucial for optimal performance and longevity of the appliance.
2. Safety Instructions
To prevent personal injury or damage to the appliance, observe the following safety precautions:
- Ensure the appliance is properly grounded before use.
- Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
- Keep ventilation openings clear of obstruction.
- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
- Repairs should only be carried out by qualified service personnel.
3. Product Overview
The Respekta KS88.0 is a compact built-in refrigerator designed for seamless integration into your kitchen cabinetry. It features a 134-liter capacity and an automatic defrost system for convenience.
Internal Components
The refrigerator compartment is equipped with:
- Four glass shelves for flexible storage.
- Three door racks for bottles and smaller items.
- One vegetable crisper drawer to keep produce fresh.
- An egg tray.
- An internal light (2W) for visibility.
4. Installation
This appliance is designed for built-in installation. Follow these guidelines for proper setup.
4.1 Site Preparation
- The refrigerator requires a niche with minimum dimensions of 88 cm (height) x 54 cm (width) x 55 cm (depth). Refer to the installation diagram for precise measurements.
- Ensure adequate ventilation around the appliance as indicated in the diagram.
- The power cable length is 210 cm. Ensure a power outlet is accessible within this range.
4.2 Door Reversibility
The door hinge is interchangeable, allowing the door to open from either the left or right side. Consult the detailed installation instructions provided with the appliance for steps on reversing the door.
4.3 Appliance Integration
The refrigerator uses a sliding door hinge system for integration with your cabinet door. Follow the mounting kit instructions for secure attachment.
5. Operation
Operating your Respekta KS88.0 refrigerator is straightforward.
5.1 Temperature Control
The internal temperature is controlled by a thermostat dial located inside the refrigerator compartment (refer to Figure 3.2). Rotate the dial to adjust the cooling intensity. Higher numbers typically indicate colder temperatures.
5.2 Automatic Defrost
This refrigerator features an automatic defrost system in the fresh food compartment. Frost that forms on the rear wall during operation will melt automatically when the compressor is off. The water then drains through a channel to an evaporation tray located above the compressor, where it evaporates.
5.3 Food Storage Guidelines
- Store cooked foods and dairy products on upper shelves.
- Raw meat and fish should be stored on the lowest shelf, in sealed containers, to prevent dripping onto other foods.
- Vegetables and fruits are best kept in the crisper drawer.
- Avoid placing hot food directly into the refrigerator; allow it to cool down first.
6. Maintenance and Cleaning
Regular cleaning and maintenance ensure hygienic operation and extend the life of your appliance.
6.1 Cleaning the Interior
- Always unplug the appliance before cleaning.
- Clean the interior regularly with a solution of mild detergent and warm water.
- Wipe dry thoroughly after cleaning.
- Do not use abrasive cleaners, harsh chemicals, or sharp objects for cleaning.
6.2 Cleaning the Exterior
Wipe the exterior surfaces with a soft, damp cloth. For stubborn marks, use a mild detergent. Ensure no water enters the electrical components.
6.3 Drain Hole Maintenance
Periodically check and clear the drain hole at the back of the refrigerator compartment to ensure proper water drainage from the automatic defrost system. A small cleaning tool is often supplied for this purpose.
7. Troubleshooting
Before contacting service, check the following common issues:
| Problem | Possible Cause | Solution |
|---|---|---|
| Refrigerator not cooling | No power; thermostat set too high; door not closed properly; excessive food load. | Check power supply; adjust thermostat to a colder setting; ensure door is sealed; reduce food load if overloaded. |
| Unusual noise | Appliance not level; items touching the back wall; compressor noise (normal). | Adjust leveling feet; reposition items; compressor noise is normal during operation. |
| Water on the floor | Blocked drain hole; evaporation tray overflowing. | Clear the drain hole; ensure the evaporation tray is correctly positioned and not damaged. |
8. Specifications
Detailed technical specifications for the Respekta KS88.0 built-in refrigerator:
| Feature | Specification |
|---|---|
| Brand | Respekta |
| Model Number | KS88.0 |
| Product Dimensions (H x W x D) | 87.5 x 54 x 54.5 cm |
| Weight | 29.9 kg |
| Capacity (Refrigerator) | 134 Liters |
| Annual Energy Consumption | 116 kWh/year |
| Energy Efficiency Class | F (EU Regulation 2019/2015) |
| Noise Level | 38 dB |
| Installation Type | Built-in |
| Defrost System | Automatic |
| Door Hinge | Reversible |
| Voltage | 230 Volts |
| Number of Shelves | 4 (Glass) |
| Number of Drawers | 1 (Vegetable Crisper) |
9. Warranty and Support
For warranty information, please refer to the warranty card included with your appliance or contact your retailer. In case of technical issues or if you require spare parts, please contact Respekta customer support or an authorized service center. Information regarding the availability of spare parts is currently unavailable through this document.
