Phanteks Revolt SFX 750W 80 PLUS Platinum Power Supply User Manual

1. Introduction

This manual provides essential information for the safe and efficient use of your Phanteks Revolt SFX 750W 80 PLUS Platinum power supply. This power supply is designed for small form-factor (SFX) chassis, offering high efficiency and a fully modular design for optimized cable management and system stability.

Image 1: Phanteks Revolt SFX 750W 80 PLUS Platinum Power Supply. This image shows the compact black power supply unit with its fan grille visible.

2. Safety Information

WARNING: Improper installation or use can result in serious injury or damage to your system components. Always follow these safety guidelines:

• Ensure the power supply is disconnected from the AC power outlet before installation or maintenance.
• Do not open the power supply unit. High voltages are present inside, even when disconnected.
• Install the power supply in a well-ventilated area. Do not block the fan or ventilation openings.
• Use only the modular cables provided with this power supply. Using incompatible cables can cause damage.
• Ensure proper grounding of your computer system.
• Avoid exposing the power supply to moisture or extreme temperatures.

3. Package Contents

Verify that all components are present in the package:

• Phanteks Revolt SFX 750W 80 PLUS Platinum Power Supply Unit
• AC Power Cord
• Modular Cable Set, including:
  • 1x 24-pin ATX Motherboard Cable (18+10pin to 24pin)
  • 4x 8-pin CPU/PCI-E Cables (8pin to CPU 8pin / PCI-E 8pin)
  • 3x 6-pin SATA/Molex Cables (6pin to SATA/Molex)
• Mounting Screws
• User Manual (this document)

Note: The modular cables are flat ribbon cables designed for flexibility and ease of routing in compact chassis.

4. Setup and Installation

Follow these steps to install your Phanteks Revolt SFX power supply:

1. Prepare Your Chassis: Ensure your computer chassis supports the SFX form factor. Remove any existing power supply.
2. Mount the Power Supply: Carefully slide the Phanteks Revolt SFX PSU into the designated SFX power supply bay in your chassis. Secure it using the provided mounting screws.
3. Connect Modular Cables:
   • 24-pin ATX Motherboard Cable: Connect the 18+10pin end to the power supply and the 24-pin end to your motherboard.
   • CPU Power Cables: Connect the 8-pin end(s) to the power supply and the 4+4pin or 8-pin end(s) to your motherboard's CPU power connector(s).
   • PCI-E Power Cables: Connect the 8-pin end(s) to the power supply and the 6+2pin or 8-pin end(s) to your graphics card(s).
   • SATA/Molex Cables: Connect the 6-pin end(s) to the power supply and the SATA or Molex connectors to your storage drives and other peripherals.

   Ensure all cable connections are firm and properly seated. Utilize the flexibility of the flat ribbon cables for optimal routing and airflow within your chassis.

4. Connect AC Power: Once all internal connections are made, connect the AC power cord to the power supply's AC inlet and then to a wall outlet or surge protector.
5. Power On: Flip the power switch on the back of the PSU to the 'ON' position. You can now power on your computer system.

5. Operating Instructions

The Phanteks Revolt SFX 750W power supply is designed for reliable and efficient operation.

• 80 PLUS Platinum Efficiency: This power supply is certified 80 PLUS Platinum, ensuring high energy efficiency (up to 92% at 50% system load). This reduces heat generation and operating costs.
• Silent Fan Operation: The integrated 92mm Fluid Dynamic Bearing (FDB) fan features intelligent thermal control. It operates silently and optimizes cooling performance based on load.
• 0 RPM Mode: For ultimate silence, the fan will remain off when the system load is below 30%. This is normal operation. The fan will automatically activate as the load increases.
• Protection Features: The PSU includes multiple protection circuits to safeguard your components:
  • OPP (Overpower Protection)
  • OVP (Over Voltage Protection)
  • UVP (Under Voltage Protection)
  • SCP (Short Circuit Protection)
  • OCP (Over Current Protection)
  • OTP (Over Temperature Protection)
  • No-Load Protection
  • Reset Protection

6. Maintenance

To ensure optimal performance and longevity of your power supply, consider the following maintenance tips:

• Dust Removal: Periodically clean dust from the power supply's fan grille and ventilation openings using compressed air. Ensure the PSU is powered off and disconnected from AC power before cleaning.
• Environmental Conditions: Operate the power supply within the specified temperature and humidity ranges (Operating Temp: 0 to 50°C; Operating Humidity: Up to 85% relative humidity, non-condensing).
• Cable Management: Ensure cables are routed neatly to prevent obstruction of airflow within the chassis.

7. Troubleshooting

If you encounter issues with your power supply, refer to the following common troubleshooting steps:

• No Power:
  • Check if the AC power cord is securely connected to both the PSU and the wall outlet.
  • Ensure the power switch on the back of the PSU is in the 'ON' position.
  • Verify that the wall outlet is functional by testing it with another device.
  • Confirm all modular cables (especially the 24-pin motherboard cable) are firmly seated at both the PSU and component ends.
• System Instability/Crashes:
  • Ensure your system's power requirements do not exceed the PSU's 750W capacity.
  • Check for loose cable connections, particularly to the motherboard, CPU, and graphics card.
  • Verify that the PSU's ventilation is not obstructed, leading to overheating. The built-in OTP (Over Temperature Protection) may shut down the unit if it overheats.
• Fan Not Spinning:
  • The PSU features a 0 RPM mode. The fan will not spin if the system load is below 30%. This is normal operation.
  • If the system is under significant load and the fan is still not spinning, ensure there are no obstructions to the fan blades.

If problems persist after following these steps, contact Phanteks customer support for further assistance.

8. Specifications

9. Warranty and Support

Warranty: This Phanteks Revolt SFX 750W 80 PLUS Platinum power supply is covered by a 1-year manufacturer's warranty from the date of purchase. Please retain your proof of purchase for warranty claims.

The warranty covers defects in materials and workmanship under normal use. It does not cover damage caused by improper installation, accident, abuse, misuse, natural disaster, or unauthorized modification.

Customer Support: For technical assistance, troubleshooting beyond this manual, or warranty inquiries, please visit the official Phanteks website or contact their customer support directly.

Phanteks Official Website: www.phanteks.com