1. Introduction
Thank you for choosing the AEG DPE5660M Range Hood. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your appliance. Please read these instructions carefully before using the range hood and retain them for future reference.
Image 1.1: The AEG DPE5660M Range Hood. This image displays the full view of the range hood, showcasing its grey finish and sleek design, ready for installation above a cooking area.
2. Safety Information
For your safety and to ensure correct operation, please read this manual carefully before installation and use. Keep these instructions with the appliance for future reference. The manufacturer is not responsible for any damages resulting from incorrect installation or use.
- This appliance is intended for domestic use only.
- Ensure the electrical supply matches the rating plate on the appliance.
- Do not operate the appliance with wet hands or bare feet.
- Always disconnect the appliance from the power supply before cleaning or maintenance.
- Adequate ventilation must be provided when the range hood is used at the same time as appliances burning gas or other fuels.
- The minimum distance between the hob and the lower part of the hood must be at least 65 cm (25.6 inches) for electric hobs and 75 cm (29.5 inches) for gas hobs, unless specified otherwise by the hob manufacturer.
3. Setup and Installation
The AEG DPE5660M range hood is designed for wall-mounted installation and supports both exhaust (ducting outside) and recirculation (filtering and returning air) modes. Proper installation is crucial for optimal performance and safety.
3.1 Unpacking
Carefully unpack the range hood and check for any damage. Report any damage to your retailer immediately. Ensure all components listed in the 'What's in the Box' section are present.
3.2 Mounting
The range hood is a wall-mounted canopy hood. Refer to the technical drawing for precise dimensions and minimum clearance requirements from the cooking surface.
Image 3.1: Technical drawing with dimensions and installation clearances. This diagram illustrates the precise measurements for the range hood and the recommended minimum distances from the hob for safe and effective installation.
3.3 Ventilation Mode Selection
This appliance supports both exhaust and recirculation. For exhaust mode, ducting must be connected to an external vent. For recirculation mode, charcoal filters (sold separately) must be installed to purify the air before returning it to the kitchen.
4. Operating Instructions
The AEG DPE5660M features intuitive SoftTouch push buttons for controlling its functions.
Image 4.1: Close-up of the SoftTouch control panel. This image highlights the push buttons for power, fan speed adjustment, and lighting control.
4.1 Power On/Off
Press the power button (often indicated by a circle with a vertical line) to turn the hood on or off.
4.2 Fan Speed Adjustment
The range hood offers 4 fan speeds. Use the '+' and '-' buttons to increase or decrease the extraction power. Higher speeds are recommended for intense cooking, while lower speeds are suitable for simmering or general ventilation.
Image 4.2: Detailed view of the fan speed indicators and controls. This image shows the illuminated indicators for the selected fan speed and the '+' and '-' buttons for adjustment.
4.3 Lighting Control
Press the light button (often indicated by a light bulb icon) to turn the halogen lights on or off. The lighting provides illumination for your cooking area.
Image 4.3: Close-up of the integrated halogen light. This image focuses on the bright halogen light strip, which illuminates the cooking surface effectively.
5. Maintenance
Regular maintenance ensures the longevity and optimal performance of your AEG DPE5660M range hood.
5.1 Cleaning the Grease Filters
The range hood is equipped with baffle filters designed to trap grease particles. These filters should be cleaned regularly, typically every 2-4 weeks depending on usage.
- Removal: Locate the release latches on the filters. Push or pull the latch to release the filter and carefully lower it.
- Cleaning: Wash the filters by hand in hot soapy water or in a dishwasher. Ensure they are completely dry before re-installing.
- Re-installation: Insert the filters back into their slots and secure the latches.
Image 5.1: View of the removable baffle filters. This image shows the metallic mesh filters designed to capture grease, along with the handle for easy removal.
5.2 Cleaning the Exterior
Clean the exterior surfaces of the range hood with a soft cloth and a mild, non-abrasive detergent. Avoid using harsh chemicals or abrasive cleaning pads, as these can damage the grey finish.
5.3 Replacing Charcoal Filters (Recirculation Mode Only)
If using the recirculation mode, charcoal filters need to be replaced periodically (typically every 3-6 months, depending on usage). Refer to the specific instructions provided with the charcoal filters for replacement procedures.
6. Troubleshooting
If you encounter issues with your range hood, refer to the following common troubleshooting steps:
- Hood does not turn on: Check if the appliance is properly plugged into a power outlet. Verify the circuit breaker or fuse.
- Low suction power: Ensure the grease filters are clean and not clogged. If in recirculation mode, check if the charcoal filters need replacement. Verify that the ducting (if applicable) is not obstructed.
- Excessive noise: Check for loose components or improper installation. Ensure the fan blades are clear of obstructions.
- Lights not working: Check if the halogen bulbs are securely in place. Replace faulty bulbs if necessary.
If the problem persists after performing these checks, please contact customer support.
7. Specifications
| Feature | Specification |
|---|---|
| Model | DPE5660M |
| Brand | AEG |
| Mounting Type | Wall Mount |
| Ventilation Type | Exhaust or Recirculation |
| Air Flow Capacity | 415 Cubic Meters Per Hour |
| Number of Speeds | 4 |
| Noise Level | 60 dB |
| Controls Type | SoftTouch Push Button |
| Light Source Type | Halogen |
| Filter Type | Baffle |
| Material | Metal |
| Color | Grey |
| Voltage | 220 Volts |
| Wattage | 50 watts |
| Efficiency Class | A |
| Product Dimensions (D x W x H) | 11.81" x 23.54" x 15.55" |
| Item Weight | 11.4 Kilograms (25.1 pounds) |
8. Warranty and Support
8.1 Warranty Information
AEG products are manufactured to the highest quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official AEG website. Keep your proof of purchase for any warranty claims.
8.2 Customer Support
If you require further assistance, have questions about your product, or need to report a fault, please contact AEG customer support. Contact details can typically be found on the official AEG website or in the documentation provided with your appliance.