Introduction
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your new Teka TMX 60 Negra Kitchen Hood. Please read these instructions carefully before installation and use, and keep them for future reference.
The Teka TMX 60 Negra is a practical kitchen hood designed for air recirculation, featuring an active carbon filter. It offers a maximum extraction capacity of 250 m³/h and operates with a sound level ranging from 44 dB (minimum) to 66 dB (maximum).
Safety Information
WARNING: Please read all safety warnings and instructions carefully before installing or using this appliance. Failure to follow these instructions may result in electric shock, fire, and/or serious injury.
- Ensure the electrical installation is compliant with local regulations and that the voltage matches the appliance's requirements (110V).
- Do not operate the hood without filters properly installed.
- Regularly clean the filters to maintain optimal performance and prevent fire hazards.
- Do not flambé under the range hood.
- This appliance is intended for domestic use only.
- Disconnect the appliance from the power supply before any cleaning or maintenance.
- Keep children away from the appliance during operation and cleaning.
Product Overview
The Teka TMX 60 Negra kitchen hood is designed for efficient air purification in your kitchen. Key features include:
- Two Speeds: Adjustable fan speeds for varying ventilation needs.
- LED Lamp: Provides illumination for your cooking area.
- Washable Metal Filters: Easy to remove and clean, ensuring long-term performance.
- Active Carbon Filter: For effective air recirculation and odor removal.
- Under Cabinet Mount: Designed for seamless integration into your kitchen cabinetry.
Figure 1: The Teka TMX 60 Negra kitchen hood, black finish, installed under a cabinet in a contemporary kitchen setting. The hood features two visible metal filters and control knobs on the front right.
Figure 2: A close-up view from below the Teka TMX 60 Negra kitchen hood, highlighting the two removable metal grease filters and the control knobs for fan speed and lighting on the right side.
Setup and Installation
The Teka TMX 60 Negra kitchen hood is designed for under-cabinet mounting. Proper installation is crucial for optimal performance and safety.
Installation Requirements:
- Mounting Type: Under Cabinet Mount.
- Electrical Connection: 110V. Ensure a dedicated circuit is available if required by local codes.
- Clearance: Maintain appropriate clearance between the cooking surface and the bottom of the hood as per local building codes and appliance manufacturer recommendations.
Installation Steps:
- Prepare the Cabinet: Ensure the cabinet area where the hood will be mounted is clean, dry, and structurally sound.
- Mark Mounting Points: Use the provided template or measure carefully to mark the drilling points for mounting screws on the underside of the cabinet. Refer to the dimension diagram for guidance.
- Drill Holes: Drill pilot holes at the marked points.
- Mount the Hood: Secure the hood to the cabinet using appropriate screws. Ensure it is level and firmly attached.
- Electrical Connection: Connect the hood to the electrical supply according to wiring diagrams and local electrical codes. It is recommended to have this step performed by a qualified electrician.
- Install Filters: Insert the metal grease filters and the active carbon filter (if not pre-installed) into their respective slots.
- Test Operation: Turn on the power and test all functions (fan speeds, light) to ensure proper operation.
Figure 3: An illustrative diagram detailing the recommended dimensions for installing the Teka TMX 60 Negra kitchen hood under a cabinet. Key measurements of 15 units (height) and 50 units (width) are indicated, likely in centimeters, for proper fitment.
Operating Instructions
The Teka TMX 60 Negra kitchen hood is operated via simple knob controls located on the front panel.
Controls:
- Fan Speed Knob: This knob controls the extraction power. Rotate it to select between two available speeds:
- Speed 1: For light cooking and general ventilation.
- Speed 2: For heavy cooking, frying, or when strong extraction is needed.
- Light Switch: This switch controls the incandescent lamp. Flip the switch to turn the light ON or OFF, illuminating your cooking surface.
For best results, turn on the hood a few minutes before you start cooking and leave it on for a few minutes after you finish to ensure all odors and steam are cleared.
Maintenance
Regular maintenance of your Teka TMX 60 Negra kitchen hood will ensure its longevity and optimal performance.
Cleaning Metal Grease Filters:
The metal grease filters should be cleaned regularly, depending on usage (e.g., monthly for average use). These filters are dishwasher safe.
- Remove Filters: Locate the release tabs or handles on the filters and carefully pull them down or slide them out.
- Wash: Place the filters in a dishwasher on a normal cycle, or wash them by hand using hot water and a non-abrasive detergent.
- Dry: Allow the filters to dry completely before re-installing them.
- Re-install: Carefully slide or snap the dry filters back into their positions until they are securely in place.
Figure 4: A detailed view of the two removable metal grease filters of the Teka TMX 60 Negra kitchen hood, showing their perforated surface and the handles for easy removal and cleaning.
Replacing Active Carbon Filter:
The active carbon filter is used for air recirculation and helps remove odors. It cannot be washed and must be replaced periodically, typically every 3-6 months depending on usage.
- Access Filter: Refer to your hood's specific design for accessing the carbon filter compartment, usually located behind the metal grease filters.
- Remove Old Filter: Carefully remove the old, saturated carbon filter.
- Install New Filter: Place a new active carbon filter (Teka genuine part recommended) into the compartment, ensuring it fits securely.
- Re-install Metal Filters: Re-attach the metal grease filters.
General Cleaning:
- Clean the exterior surfaces of the hood with a soft cloth and mild, non-abrasive detergent.
- Do not use abrasive cleaners, steel wool, or harsh chemicals, as these can damage the finish.
- Ensure the hood is disconnected from power before cleaning.
Troubleshooting
Before contacting customer service, please refer to the following common issues and their solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Hood does not turn on. | No power supply. Controls are off. |
Check power outlet and circuit breaker. Ensure control knobs are in an ON position. |
| Poor extraction performance. | Grease filters are clogged. Carbon filter is saturated. Incorrect fan speed. |
Clean metal grease filters. Replace active carbon filter. Select a higher fan speed. |
| Excessive noise. | Filters not properly installed. Loose components. |
Ensure all filters are securely in place. Check for any loose screws or parts. |
| Light not working. | Light bulb is faulty. Light switch is off. |
Replace the incandescent lamp. Ensure the light switch is in the ON position. |
If the problem persists after trying these solutions, please contact Teka customer support.
Specifications
| Feature | Detail |
|---|---|
| Brand | Teka |
| Model | TMX 60 Negra |
| Mounting Type | Under Cabinet Mount |
| Material | Stainless Steel |
| Color | Black |
| Product Dimensions (D x W x H) | 19.68" x 23.62" x 5.9" (50cm x 60cm x 15cm) |
| Item Weight | 10.12 pounds (4.6 Kilograms) |
| Air Flow Capacity | 250 m³/h (2.5E+2 CMPH) |
| Noise Level | Min. 44 dB - Max. 66 dB |
| Number of Speeds | 2 |
| Controls Type | Knob |
| Light Source Type | Incandescent |
| Filter Type | Activated Carbon Filter, Metal filters |
| Included Components | Metal filters (dishwasher safe) |
| Voltage | 110V |
| Annual Energy Consumption | 200 Kilowatt Hours Per Year |
Warranty and Support
For warranty information and customer support, please refer to the documentation included with your purchase or visit the official Teka website. Keep your proof of purchase for any warranty claims.
For technical assistance, spare parts, or service requests, please contact Teka customer service through their official channels. When contacting support, please have your product model number (TMX 60 Negra) and serial number (if applicable) ready.
