Evolved Novelties Zero Tolerance Pop On The Go Stroker User Manual

1. Product Overview

The Evolved Novelties Zero Tolerance Pop On The Go Stroker is designed for personal use. It features a realistic internal texture within a durable cannister. The product includes a removable sleeve and a vibrating C-ring with a vibrating bullet.

Components:

• Stroker Cannister (ABS Plastic)
• Removable Stroker Sleeve (TPE Rubber)
• Vibrating C-Ring
• Vibrating Bullet
• Locking Removable Cap

Figure 1: Fully assembled Zero Tolerance Pop On The Go Stroker, featuring its black ergonomic cannister and red accent ring.

2. Setup

2.1 Unpacking

Carefully remove all components from the packaging. Inspect for any damage.

2.2 Initial Cleaning

Before first use, thoroughly clean the stroker sleeve and cannister. Refer to the "Maintenance and Cleaning" section for detailed instructions.

2.3 Battery Installation (Vibrating Bullet)

The vibrating bullet requires batteries (type not specified, typically button cells). Twist the cap of the vibrating bullet to open the battery compartment. Insert the required batteries, ensuring correct polarity. Securely close the cap.

2.4 Assembly

Insert the clean TPE stroker sleeve into the ABS cannister. Ensure it is seated correctly.

Apply a water-based lubricant to the entry of the stroker sleeve for comfortable use.

3. Operating Instructions

3.1 Using the Stroker

Apply a generous amount of water-based lubricant to the stroker's entry and to yourself.

Gently insert into the stroker. The internal textures are designed for varied sensations.

3.2 Using the Vibrating C-Ring

Insert the vibrating bullet into the designated slot on the C-ring.

Activate the vibrating bullet by pressing its power button.

Place the C-ring as desired for additional sensation.

3.3 Waterproof Use

The stroker is waterproof and can be used in the bath or shower. Ensure the vibrating bullet's battery compartment is securely sealed if used in water.

4. Maintenance and Cleaning

4.1 Disassembly

After each use, remove the locking cap from the cannister.

Carefully pull the TPE stroker sleeve out of the ABS cannister.

Remove the vibrating bullet from the C-ring.

Figure 2: The Zero Tolerance Pop On The Go Stroker with its internal TPE sleeve separated from the outer ABS cannister, demonstrating the removable design for cleaning.

4.2 Cleaning the Stroker Sleeve and Cannister

Wash the TPE sleeve and ABS cannister thoroughly with warm water and a mild, toy-safe soap.

Rinse all components completely to remove any soap residue.

Figure 3: A close-up view of the internal TPE sleeve of the Zero Tolerance Pop On The Go Stroker, highlighting its textured pleasure nubs and ribs.

4.3 Cleaning the Vibrating Bullet and C-Ring

Wipe the vibrating bullet and C-ring with a damp cloth and mild soap. Do not submerge the vibrating bullet unless it is explicitly rated as fully submersible.

Ensure no moisture enters the battery compartment of the vibrating bullet.

4.4 Drying and Storage

Allow all components to air dry completely before reassembly and storage.

Store the product in a clean, dry place away from direct sunlight and extreme temperatures.

5. Troubleshooting

5.1 Vibration Not Working

• Check if batteries are correctly installed in the vibrating bullet.
• Replace batteries with fresh ones.
• Ensure the power button on the vibrating bullet is pressed firmly.

5.2 Difficulty Cleaning

• Ensure the sleeve is fully removed from the cannister for thorough cleaning.
• Use a soft brush if necessary to clean textured areas.

5.3 Product Damage

If any component appears damaged or degraded, discontinue use and contact customer support.

6. Specifications

7. Important Information

7.1 Legal Disclaimer

Statements regarding this product have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition. This product is intended for adult use only.

7.2 Customer Support

For any questions, concerns, or support regarding your Evolved Novelties product, please contact the manufacturer directly.