AECOJOY Outdoor Patio Swing Chair User Manual

Introduction

Thank you for choosing the AECOJOY Outdoor Patio Swing Chair. This 2-seat porch swing with an adjustable canopy and removable cushions is designed to provide comfort and relaxation in your backyard, garden, yard, poolside, or balcony. This manual provides detailed instructions for assembly, operation, maintenance, and troubleshooting to ensure safe and enjoyable use of your new swing chair.

Image: The AECOJOY 2-Seat Outdoor Patio Swing Chair in a beige color, featuring a sturdy frame, comfortable cushions, and an adjustable canopy, set on a patio.

Safety Information

Please read and understand all safety warnings and instructions before assembling and using this product. Failure to follow these instructions may result in serious injury.

• Ensure all parts are present and undamaged before assembly. Do not use if any parts are missing or broken.
• Assemble the swing chair on a flat, stable surface.
• Do not exceed the maximum weight capacity of 600 lbs (approximately 272 kg). This swing is designed for two adults.
• Keep children and pets away from the assembly area.
• Regularly check all bolts and nuts for tightness. Retighten as necessary to ensure stability.
• Do not stand on the swing or use it as a ladder.
• Avoid swinging excessively high or violently, as this may cause the swing to tip over.
• In strong winds or severe weather, remove the canopy and cushions, and secure the swing to prevent damage or tipping.
• Keep away from open flames and heat sources.

Parts List

Before assembly, verify that all components listed below are included in your package. If any parts are missing or damaged, please contact customer service.

• Main Frame Components (Legs, Crossbars, Top Bar)
• Swing Seat Frame
• Canopy Frame and Fabric
• Suspension Springs and Chains
• Seat Cushions (2.7-inch thick)
• Hardware Kit (Bolts, Nuts, Washers, Wrenches)
• Non-slip Foot Pads

Image: A detailed view of the AECOJOY swing chair highlighting key components such as the strong stainless spring hook, thick cushions, detachable design, non-slip foot pad, and waterproof fabric.

Setup and Assembly

Assembly is required for this product. Please follow the steps carefully. All necessary tools are provided.

Step 1: Assemble the Main Frame

Connect the leg components and crossbars to form the sturdy triangular frame. Ensure all connections are secure but do not fully tighten bolts until the entire frame is assembled.

Image: Diagram illustrating the adjustable and convertible canopy mechanism and the stable triangular frame structure for added stability.

Step 2: Attach the Swing Seat

Attach the swing seat frame to the main frame using the provided suspension springs and chains. Ensure the springs are properly hooked and the chains are securely fastened.

Step 3: Install the Canopy

Assemble the canopy frame and attach the canopy fabric. Secure the canopy to the top bar of the main frame. The canopy is adjustable to provide optimal shade.

Step 4: Place Cushions and Final Tightening

Place the thick cushions onto the swing seat. Once all components are in place, go back and fully tighten all bolts and nuts to ensure maximum stability and safety.

Image: Close-up view of the swing chair seat, demonstrating the 180g polyester seat for breathability in warm weather and the 2.7-inch thick seat cushions for warmth and comfort in cooler weather.

Operating Instructions

Adjusting the Canopy

The canopy can be adjusted to different angles to provide optimal shade from the sun. Loosen the adjustable knob located on the side of the canopy frame, position the canopy to your desired angle, and then tighten the knob to secure it.

Image: A diagram showing the adjustable canopy and the knob used to loosen and tighten it for angle adjustments.

Using the Cushions

The swing chair features 2.7-inch thick cushions for comfort. These cushions are removable, allowing for versatility. For warmer weather, you can remove the cushions to utilize the 180g polyester seat for extra breathability. For cooler seasons, the cushions provide warmth and comfort.

Maintenance

• Cleaning: Clean the frame with a mild soap and water solution. Rinse thoroughly and dry completely. The canopy fabric and cushions can be spot cleaned with a damp cloth and mild detergent. Allow them to air dry completely before storage.
• Regular Inspection: Periodically check all nuts, bolts, and connections to ensure they remain tight. Retighten as needed. Inspect the suspension springs and chains for any signs of wear or damage.
• Weather Protection: While the canopy fabric is waterproof and anti-fading, it is recommended to remove the canopy and cushions during heavy rain, snow, or strong winds to prolong their lifespan. Store them in a dry, protected area.
• Winter Storage: During off-season or prolonged periods of non-use, it is advisable to store the entire swing chair indoors or cover it with a weather-resistant furniture cover to protect it from harsh elements.

Troubleshooting

Specifications

Image: A diagram showing the key dimensions of the AECOJOY swing chair, including height, width, depth, seat depth, and cushion thickness, along with the 600 lbs weight capacity.

Warranty and Support

Return Policy

This product is eligible for a 30-day easy return policy. Please refer to your purchase platform's return guidelines for detailed information on initiating a return or exchange.

Customer Service

For any questions regarding assembly, missing parts, or product issues, please contact AECOJOY customer service. Our team aims to respond to inquiries within 24 hours.

You can typically find contact information on the packaging, your order details, or by visiting the official AECOJOY store page on the platform where you made your purchase. For Amazon purchases, visit the AECOJOY Store.