Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your Swiss Madison St. Tropez SM-1T274 One-Piece Elongated Toilet. Please read all instructions carefully before beginning installation and retain this manual for future reference. Proper installation and care will ensure optimal performance and longevity of your product.
What's in the Box
Verify that all components are present before beginning installation. If any parts are missing or damaged, please contact Swiss Madison customer support.
Figure 1: Included Components. This image displays the St. Tropez One-Piece Toilet (SM-1T274), Dual-Flush Push Button (SM-TPT16), Tank Lid (SM-TTL54), Soft-Close Seat (SM-QRS54), Bolt Access Covers (SM-TPT10), and Wax Ring & Bolt Kit (SM-TPT01).
- St. Tropez One-Piece Toilet (SM-1T274)
- Dual-Flush Push Button (SM-TPT16)
- Tank Lid (SM-TTL54)
- Soft-Close Seat (SM-QRS54)
- Bolt Access Covers (SM-TPT10)
- Wax Ring & Bolt Kit (SM-TPT01)
Setup and Installation
Pre-Installation Check
- Ensure the water supply valve is turned off.
- Remove any existing toilet and clean the flange area thoroughly.
- Verify your rough-in measurement. This toilet is designed for a 10-inch rough-in.
Figure 2: 10-inch Rough-In. This diagram shows how to measure the rough-in distance from the finished wall to the center of the floor drain, indicating compatibility with a 10-inch rough-in.
Installation Steps
- Prepare the Flange: Install the included wax ring onto the toilet's waste outlet or directly onto the floor flange. Ensure a proper seal.
- Position the Toilet: Carefully lower the toilet onto the floor bolts, aligning the bolt holes with the bolts. Press down firmly to compress the wax ring and create a watertight seal.
- Secure the Toilet: Place washers and nuts onto the floor bolts. Hand-tighten the nuts, then use a wrench to tighten them evenly, alternating sides, until the toilet is secure. Do not overtighten, as this can crack the ceramic.
- Install Bolt Covers: Snap the bolt access covers (SM-TPT10) over the tightened nuts.
- Connect Water Supply: Connect the water supply line to the toilet's fill valve. Hand-tighten, then use a wrench for a quarter turn. Do not overtighten.
- Install Seat: Attach the soft-close, quick-release toilet seat (SM-QRS54) according to its specific instructions.
- Install Flush Button: Place the dual-flush push button (SM-TPT16) onto the tank lid and then place the lid (SM-TTL54) onto the toilet tank.
- Test Flush: Turn on the water supply and allow the tank to fill. Perform several test flushes to check for leaks and proper operation.
Figure 3: Installation Dimensions. This image provides internal measurements from the bottom of the toilet, useful for precise installation and alignment with plumbing.
Operating Instructions
Dual-Flush System
Your Swiss Madison St. Tropez toilet features a dual-flush system designed for water conservation. The flush button on top of the tank lid has two options:
- Small Button: Activates a 1.1 gallons per flush (GPF) for liquid waste, conserving water.
- Large Button: Activates a 1.6 gallons per flush (GPF) for solid waste, providing a powerful flush.
Vortex™ Flush Technology
The toilet utilizes Vortex™ flush technology with powerful dual nozzles. This design creates a cyclonic rinsing action that cleans the entire bowl surface more effectively than standard rim holes, ensuring a cleaner bowl with each flush.
Figure 4: Vortex™ Flush in Action. This image illustrates the powerful dual nozzles creating a swirling water action for superior bowl cleaning.
Maintenance and Cleaning
General Cleaning
- Clean the ceramic surfaces regularly with a soft cloth, mild soap, and water.
- Avoid abrasive cleaners, scouring pads, or harsh chemicals, as these can damage the finish.
- For bowl cleaning, use a toilet brush and a non-abrasive toilet bowl cleaner.
Soft-Close, Quick-Release Seat
The soft-close feature prevents slamming and reduces wear. For thorough cleaning, the seat can be easily removed:
- Open the seat and lid to a vertical position.
- Locate the quick-release buttons or tabs near the hinges.
- Press the buttons/tabs and lift the seat straight up to detach it from the toilet.
- Clean the seat and the toilet rim area.
- To reattach, align the seat hinges with the posts and press down until it clicks into place.
Figure 5: Soft-Close & Quick-Release Seat. This image shows the toilet seat with an indication of its soft-close and quick-release functionality for easy cleaning.
Fully Glazed & Skirted Trapway
The fully skirted design and glazed trapway simplify cleaning the exterior and interior of the toilet. The smooth, seamless surface of the skirted bowl prevents dust and debris accumulation, while the glazed trapway helps prevent clogs and ensures efficient waste removal.
Figure 6: Fully Glazed & Skirted Trapway. This image highlights the seamless, easy-to-clean design of the toilet's exterior and the efficient internal trapway.
Troubleshooting
If you encounter issues with your toilet, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Toilet does not flush or flushes weakly | Low water level in tank; clogged trapway; flapper/fill valve issue | Check water supply valve; adjust water level in tank; clear any obstructions in the bowl or trapway; inspect flapper and fill valve for proper function. |
| Toilet continuously runs | Flapper not sealing; fill valve malfunction; chain too tight | Check flapper for debris or wear; adjust fill valve; ensure flush chain has slight slack. |
| Leaks at base of toilet | Loose bolts; faulty wax ring; cracked flange | Tighten flange bolts evenly (do not overtighten); replace wax ring; inspect and repair/replace flange if damaged. |
| Slow tank refill | Partially closed water supply valve; clogged fill valve | Fully open water supply valve; clean or replace fill valve. |
If these solutions do not resolve the issue, please contact Swiss Madison customer support for further assistance.
Specifications
Detailed technical specifications for the Swiss Madison St. Tropez SM-1T274 One-Piece Elongated Toilet:
| Feature | Detail |
|---|---|
| Model Number | SM-1T274 |
| Color | Glossy White |
| Product Dimensions (D x W x H) | 27" x 15.15" x 31.2" |
| Material | Ceramic |
| Item Weight | 110 Pounds |
| Installation Type | Floor Mounted |
| Shape | Elongated (Oval) |
| Seat Material Type | Plastic |
| Rough-in Size | 10 inches |
| Flush Type | Dual Flush (1.1 GPF / 1.6 GPF) |
| Handle/Lever Placement | Top (Push Button) |
| Included Components | One Piece Toilet, Hardware, Bolts, Bolt Cover Caps, Seat, Lid |
| UPC | 810082330137 |
Figure 7: Product Dimensions. This diagram provides comprehensive measurements for the toilet, including overall height, width, depth, seat height, and rough-in details.
Warranty Information
Specific warranty details for Swiss Madison products are typically provided with your purchase documentation or can be found on the official Swiss Madison website. Generally, ceramic components are covered against defects in material and workmanship under normal use. Please refer to your product's warranty card or the manufacturer's website for the most current and complete warranty terms and conditions.
Customer Support
For technical assistance, replacement parts, or warranty claims, please contact Swiss Madison customer support. Have your model number (SM-1T274) and proof of purchase ready when contacting support.
- Website: Visit the official Swiss Madison website for FAQs, product registration, and contact information.
- Phone: Refer to your product packaging or the Swiss Madison website for the customer service phone number.
