Thule Raised Rail Edge Foot Pack

1. Introduction

This manual provides detailed instructions for the proper installation, operation, and maintenance of your Thule Raised Rail Edge Foot Pack (Model 720401). This foot pack is designed to securely attach Thule Edge roof rack systems to vehicles equipped with raised factory railings. For optimal performance and safety, please read and understand all instructions before installation and use.

The Thule Raised Rail Edge Foot Pack is part of a complete roof rack system. It requires Thule WingBar Edge load bars (sold separately) to function correctly.

2. Safety Information

• Always ensure the foot pack and load bars are securely fastened to your vehicle's raised railings before driving.
• Do not exceed the maximum load capacity of 165 pounds (75 kg) for the roof rack system, or your vehicle's manufacturer-specified roof load limit, whichever is lower.
• Regularly check all bolts, nuts, and straps for tightness, especially before long trips and after driving on rough terrain.
• Distribute the load evenly on the roof rack.
• Be aware of the increased height and width of your vehicle when the roof rack and cargo are installed, especially when entering garages, car washes, or low-clearance areas.
• Avoid using automatic car washes with the roof rack installed.
• Always use the ergonomic torque limiter key to ensure correct and safe tightening.

3. Setup and Installation

The Thule Raised Rail Edge Foot Pack is designed for easy installation on vehicles with existing raised railings. Ensure you have the complete foot pack (4 units) and the appropriate Thule WingBar Edge load bars for your vehicle (sold separately).

Installation Steps:

1. Prepare the Foot Pack: Unpack all components. Each foot pack unit includes a rubber lining designed to protect your vehicle's raised railings.
2. Attach to Load Bars: Slide the foot pack units onto the Thule WingBar Edge load bars. Ensure they are correctly oriented according to the markings.
3. Position on Vehicle: Place the assembled load bars with foot packs onto your vehicle's raised railings. Adjust the position to ensure even weight distribution and proper spacing as recommended by your vehicle's manual or Thule's fit guide.
4. Secure the Foot Pack: Use the ergonomic torque limiter key to tighten the foot pack clamps onto the raised railings. The key will indicate when the rack is safely and properly secured, preventing overtightening or undertightening.
5. Install Locks (Optional): For added security, Thule One-Key locks (sold separately) can be installed into the foot pack units.
6. Final Check: After installation, gently pull and push on the load bars to ensure they are firmly attached and do not move.

Image: Thule Raised Rail Edge Foot Pack installed on a vehicle with raised railings, showing the sleek, integrated design.

Image: Close-up of the Thule Raised Rail Edge Foot Pack, highlighting the secure attachment mechanism and Thule branding.

Installation Demonstration Video:

4. Operating Instructions

Once the Thule Raised Rail Edge Foot Pack and WingBar Edge load bars are securely installed, you can attach various Thule accessories (e.g., bike racks, ski carriers, cargo boxes) to expand your vehicle's carrying capacity.

• Accessory Attachment: The WingBar Edge load bars feature T-slot compatibility, allowing for easy and secure attachment of Thule accessories. Refer to the specific accessory's instruction manual for detailed attachment procedures.
• Load Distribution: Always distribute cargo evenly across the load bars. Place heavier items closer to the center of the vehicle and secure all items firmly to prevent shifting during transit.
• Check Fasteners: Before each use, especially when carrying cargo, verify that all foot pack and accessory fasteners are tight.

5. Maintenance

Proper maintenance ensures the longevity and continued safe operation of your Thule Raised Rail Edge Foot Pack.

• Cleaning: Clean the foot pack and load bars regularly with mild soap and water. Avoid abrasive cleaners or solvents that could damage the finish or rubber components.
• Inspection: Periodically inspect the foot pack for any signs of wear, damage, or corrosion. Pay close attention to the rubber lining and clamping mechanisms.
• Lubrication: If applicable, lubricate moving parts or lock cylinders with a non-petroleum-based lubricant as needed.
• Storage: When not in use for extended periods, it is recommended to remove the roof rack system and store it in a dry, protected area to prevent unnecessary wear and exposure to harsh weather conditions.

6. Troubleshooting

If you encounter any issues with your Thule Raised Rail Edge Foot Pack, consider the following common solutions:

• Loose Fit: If the foot pack feels loose, re-tighten the clamping mechanism using the ergonomic torque limiter key until the correct tension is achieved. Ensure the foot pack is correctly seated on the raised railings.
• Excessive Noise: Wind noise can occur. Ensure all components are tightly secured. Check if any accessories are improperly mounted or if the load bars are positioned too far forward or backward.
• Difficulty Installing Accessories: Verify that your accessories are compatible with T-slot mounting. Ensure the T-slot channel is clear of debris.
• Missing Parts: If any parts are missing upon receipt, contact your retailer or Thule customer support immediately.

7. Specifications

8. Warranty

The Thule Raised Rail Edge Foot Pack comes with a Limited Lifetime Manufacturer Warranty. This warranty covers defects in materials and workmanship for the original purchaser. For specific terms, conditions, and claim procedures, please refer to the official Thule warranty documentation or visit the Thule website.

9. Support

For further assistance, product information, or to purchase compatible accessories, please visit the official Thule website or contact Thule customer support. Ensure you have your product model number (720401) and proof of purchase available when seeking support.

Thule Website: www.thule.com