Ocean STONE 60cm Island Hood User Manual

Introduction

Thank you for choosing the Ocean STONE 60cm Island Hood. This manual provides essential information for the safe installation, operation, and maintenance of your new appliance. Please read it thoroughly before use and keep it for future reference.

Image: The Ocean STONE 60cm Island Hood, a stainless steel kitchen appliance designed for island installation.

Safety Information

Important: Read all instructions before installing or using this appliance. Failure to follow these instructions may result in electric shock, fire, or personal injury.

• Ensure the electrical supply matches the rating plate on the appliance.
• Installation must be performed by a qualified technician in accordance with local regulations.
• Do not operate the hood without filters properly installed.
• Regularly clean grease filters to prevent fire hazards.
• This appliance is for domestic use only.
• Do not flambé under the range hood.

Package Contents

Verify that all components are present and undamaged before installation.

• Ocean STONE Island Hood unit
• Aluminum grease filters
• Carbon filters (for recirculation mode)
• Mounting hardware
• User Manual

Setup and Installation

This island hood is designed for ceiling mounting above a cooking island. Professional installation is recommended.

Pre-Installation Checks:

• Ensure adequate ceiling support for the hood's weight (15 kg).
• Confirm proper electrical wiring is available at the installation point (220V).
• Determine if the hood will operate in extraction (ducted) or recirculation (ductless) mode. Carbon filters are required for recirculation.

Mounting Steps:

1. Mark the drilling points on the ceiling according to the provided template.
2. Drill holes and insert appropriate anchors.
3. Secure the mounting bracket to the ceiling.
4. Attach the hood body to the mounting bracket.
5. Connect the electrical supply.
6. Install the ducting (if using extraction mode) or carbon filters (if using recirculation mode).
7. Attach the decorative chimney sections.

Operating Instructions

The Ocean STONE hood features push-button controls for fan speed and lighting.

Control Panel:

The control panel is located on the front of the hood and consists of push buttons.

• Power Button: Press to turn the hood on or off.
• Speed Buttons (1, 2, 3): Select desired fan speed. Speed 1 is for light cooking, Speed 3 for heavy cooking or strong odors.
• Light Button: Press to turn the LED lights on or off.

For optimal performance, turn on the hood a few minutes before cooking and leave it running for a few minutes after cooking to clear residual fumes.

Maintenance

Regular maintenance ensures efficient operation and extends the life of your hood.

Cleaning Aluminum Grease Filters:

• Grease filters should be cleaned approximately every 2 months, or more frequently depending on usage.
• To remove, locate the release latches and pull down.
• Filters are dishwasher safe. Use a mild detergent and a low-temperature cycle.
• Alternatively, wash by hand in hot water with a degreasing agent.
• Ensure filters are completely dry before re-installing.

Replacing Carbon Filters (Recirculation Mode Only):

• Carbon filters cannot be washed and must be replaced every 3-6 months, depending on usage.
• To replace, remove the aluminum grease filters first.
• Twist or unclip the old carbon filters and install new ones.
• Refer to the specific carbon filter instructions for detailed replacement steps.

Cleaning the Hood Exterior:

• Clean the stainless steel exterior with a soft cloth and a non-abrasive stainless steel cleaner.
• Do not use abrasive cleaners, scouring pads, or corrosive detergents.

Troubleshooting

Before contacting customer service, review the following common issues and solutions.

Specifications

Warranty and Support

For warranty information and customer support, please refer to the warranty card included with your product or contact Ocean customer service. Keep your proof of purchase for any warranty claims.