Singsation MIC200

Singsation Wireless Handheld Microphone MIC200 User Manual

Model: MIC200

Introduction

Thank you for choosing the Singsation Wireless Handheld Microphone MIC200. This manual provides essential information for setting up, operating, and maintaining your wireless microphone system. Please read these instructions carefully before use to ensure optimal performance and longevity of your device.

The Singsation MIC200 is designed for use with Singsation karaoke machines (SPKA30, SPKA25, SPKA700) and is compatible with most other karaoke systems featuring a standard ¼-inch (6.3mm) receiver input. Enjoy superior sound quality and the freedom of wireless performance.

Package Contents

Verify that all components are present in your package:

  • Wireless Handheld Microphone
  • Rechargeable VHF Receiver
  • Micro-USB Charging Cable
  • User Manual (this document)

Note: Two AA batteries for the microphone are not included and must be purchased separately.

Setup

1. Install Microphone Batteries

The handheld microphone requires two AA batteries (not included).

  1. Unscrew the bottom part of the microphone handle.
  2. Insert two AA batteries, ensuring correct polarity (+/-).
  3. Screw the bottom part back onto the microphone.
Image showing how to install AA batteries into the microphone and the rechargeable receiver.

This image illustrates the battery compartment of the microphone and the rechargeable receiver. It shows where to insert two AA batteries into the microphone and highlights the rechargeable battery within the receiver.

2. Charge the VHF Receiver

The VHF receiver has a built-in rechargeable battery.

  1. Connect the micro-USB charging cable to the receiver's DC 5V port.
  2. Connect the other end of the cable to a USB power source (e.g., USB wall adapter, computer USB port).
  3. The LED indicator on the receiver will show charging status. Charge fully before first use.
Close-up image of the VHF receiver with its ports and switches labeled.

This image provides a detailed view of the VHF receiver, showing the ON/OFF switch, LED indicator, DC 5V charging port, and RF A/B switch.

3. Connect the Receiver to Your Karaoke System

The receiver features a standard ¼-inch (6.3mm) audio jack.

  1. Plug the VHF receiver directly into the microphone input jack on your karaoke device or speaker.
  2. Ensure the connection is secure.
Image showing the wireless microphone and the receiver with its 6.35mm connector.

This image displays the wireless microphone alongside the VHF receiver, highlighting the 6.35mm connector on the receiver, ready to be plugged into a karaoke system.

Image showing the Singsation wireless microphone connected to a Singsation karaoke system.

This image demonstrates the wireless microphone connected to a Singsation karaoke system, illustrating how the system works with various karaoke devices.

Operating Instructions

1. Power On and Pairing

  1. Turn the ON/OFF switch on the VHF receiver to the ON position. The LED indicator will light up.
  2. Turn the ON/OFF switch on the handheld microphone to the ON position.
  3. The microphone and receiver will automatically pair. The LED on the receiver will indicate a successful connection (refer to receiver's LED behavior for specific status).

2. Adjusting Volume

Adjust the microphone volume using the volume controls on your connected karaoke machine or speaker. The Singsation MIC200 does not have onboard volume control.

3. Usage Tips

  • Maintain a clear line of sight between the microphone and the receiver for optimal wireless performance. The wireless range is approximately 30 feet.
  • Hold the microphone approximately 2-6 inches from your mouth for best sound pickup.
  • Avoid covering the microphone grille with your hand, as this can affect sound quality.
  • Note on Multiple Microphones: Only one Singsation wireless microphone can be used per karaoke machine simultaneously. If you wish to use two microphones for duets, one must be wired or a different wireless system on a separate frequency.

Maintenance

Cleaning

  • Wipe the microphone and receiver with a soft, dry cloth.
  • Do not use abrasive cleaners, solvents, or harsh chemicals.
  • Avoid getting moisture into any openings.

Battery Care

  • Remove AA batteries from the microphone if it will not be used for an extended period to prevent leakage.
  • Recharge the VHF receiver regularly to maintain battery health.
  • Do not expose batteries to excessive heat or direct sunlight.

Troubleshooting

ProblemPossible CauseSolution
No sound from microphone
  • Microphone or receiver is off.
  • Batteries are dead or incorrectly installed.
  • Receiver not properly connected to karaoke system.
  • Microphone and receiver not paired.
  • Karaoke system volume is too low.
  • Ensure both microphone and receiver are switched ON.
  • Replace AA batteries in microphone; ensure receiver is charged.
  • Check ¼-inch (6.3mm) connection to karaoke system.
  • Turn both devices off and then on again to re-initiate pairing.
  • Increase volume on your karaoke system.
Poor sound quality / Static
  • Interference from other wireless devices.
  • Microphone too far from receiver.
  • Low microphone batteries.
  • Move away from other wireless devices.
  • Reduce distance between microphone and receiver (within 30 ft).
  • Replace AA batteries in microphone.
Receiver not charging
  • Charging cable is faulty or not connected properly.
  • USB power source is not active.
  • Check micro-USB cable connection; try a different cable.
  • Try a different USB power source.

Specifications

FeatureDetail
Model NumberMIC200
BrandSingsation
Microphone TypeWireless Handheld, Dynamic
Polar PatternUnidirectional
ConnectivityVHF Wireless, 6.35mm Jack (Receiver)
Wireless RangeUp to 30 feet (approx. 9 meters)
Receiver Power SourceRechargeable Lithium-Ion Battery (included)
Microphone Power Source2 x AA Batteries (not included)
Signal-to-Noise Ratio70 dB
Item Weight10.5 Ounces (approx. 298 grams)
Item Dimensions (L x W x H)12 x 2 x 5 inches (approx. 30.5 x 5.1 x 12.7 cm)
ManufacturerVoxx Accessories Corporation

Warranty Information

The Singsation Wireless Handheld Microphone MIC200 comes with a 1-year limited warranty from the date of purchase. This warranty covers manufacturing defects in materials and workmanship under normal use. It does not cover damage caused by misuse, accident, unauthorized modification, or normal wear and tear.

Please retain your proof of purchase for warranty claims.

Customer Support

For technical assistance, troubleshooting beyond this manual, or warranty inquiries, please contact Singsation customer support. Refer to the contact information provided with your product packaging or visit the official Singsation website for the most up-to-date support details.

Manufacturer: Voxx Accessories Corporation

© 2024 Singsation. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.