Lexon Mina Small Mushroom Lamp - LED Portable Bedside Light User Manual

1. Introduction

This manual provides essential information for the safe and efficient use of your Lexon Mina Small Mushroom Lamp. Please read these instructions thoroughly before operating the device and retain them for future reference.

2. Safety Instructions

• Do not expose the lamp to extreme temperatures or direct sunlight.
• Avoid dropping the lamp, as this may cause damage.
• Do not attempt to disassemble or repair the lamp yourself. Contact qualified service personnel.
• Keep out of reach of small children.
• Use only the provided USB-C cable for charging.

3. Package Contents

• Lexon Mina Small Mushroom Lamp
• USB-C Charging Cable
• User Manual

4. Product Overview

The Lexon Mina lamp features a minimalist mushroom design, offering portable LED lighting with adjustable light temperatures and dimming capabilities. It is constructed from aluminum and includes a rechargeable battery.

Figure 1: Lexon Mina Small Mushroom Lamp, showcasing its compact design and light blue finish.

Figure 2: Size comparison illustrating the relative dimensions of the Mina M, Mina (this product), and Mina L lamps.

5. Setup

5.1 Initial Charging

1. Locate the USB-C charging port on the base of the lamp.
2. Connect the provided USB-C cable to the lamp and a compatible USB power adapter (not included).
3. Charge the lamp for approximately 2 hours for a full charge. The indicator light (if present) will change to signify a full charge.

Figure 3: The lamp offers up to 12 hours of light on a full charge, which takes approximately 2 hours via USB-C.

6. Operating Instructions

6.1 Power On/Off and Light Mode Selection

The lamp is controlled by a single button located on its base.

1. To Turn On/Off: Press and hold the button on the base for a few seconds.
2. To Change Light Temperature: While the lamp is on, short press the button to cycle between warm and cold light modes.

Figure 4: The lamp offers both cool and warm light modes, controlled by a single button on its base.

6.2 Dimming Function

The Lexon Mina lamp features a memory dimming function.

1. While the lamp is on, press and hold the button to adjust the brightness. Release the button when the desired brightness level is reached.
2. The lamp will remember the last brightness setting when turned off and on again.

7. Maintenance

7.1 Cleaning

• Wipe the lamp with a soft, dry cloth.
• Do not use abrasive cleaners or solvents.

7.2 Storage

When not in use for extended periods, store the lamp in a cool, dry place. Ensure the battery is partially charged before storage to prolong its lifespan.

8. Troubleshooting

• Lamp does not turn on: Ensure the lamp is fully charged. Check the USB-C cable and power adapter for proper connection.
• Light is dim or flickers: The battery may be low. Recharge the lamp.
• Cannot change light mode/brightness: Ensure you are pressing the button correctly as described in Section 6.

9. Specifications

10. Warranty and Support

For warranty information or technical support, please refer to the documentation included with your purchase or visit the official Lexon website. Keep your proof of purchase for warranty claims.