AEG CX7-2-45AN

AEG CX7-2-45AN Ergorapido Cordless 2-in-1 Vacuum Cleaner

User Instruction Manual

Introduction

This manual provides essential instructions for the safe and efficient use of your AEG CX7-2-45AN Ergorapido Cordless 2-in-1 Vacuum Cleaner. Please read this manual thoroughly before operating the appliance and retain it for future reference. Proper use and maintenance will ensure optimal performance and extend the lifespan of your vacuum cleaner.

AEG CX7-2-45AN Ergorapido Cordless 2-in-1 Vacuum Cleaner

Image: The AEG CX7-2-45AN Ergorapido Cordless 2-in-1 Vacuum Cleaner, showcasing its sleek design and dual functionality as a stick vacuum and a detachable handheld unit.

Important Safety Instructions

Setup and Initial Use

1. Assembly

Your AEG Ergorapido vacuum cleaner comes partially assembled. To complete assembly:

  1. Insert the handheld unit into the main body of the stick vacuum until it clicks securely into place.
  2. Attach the floor nozzle to the bottom of the stick vacuum. Ensure it is firmly connected.

2. Charging the Battery

Before first use, fully charge the vacuum cleaner for approximately 4 hours. The charging indicator lights will show the charging status.

Operating Instructions

1. Power On/Off and Suction Control

2. Using as a Stick Vacuum

For general floor cleaning, use the appliance in its upright stick vacuum configuration. The motorized brush roll is ideal for carpets and hard floors.

3. Using as a Handheld Vacuum

To detach the handheld unit for spot cleaning, furniture, or car interiors:

  1. Press the release button located on the main body of the stick vacuum.
  2. Gently pull the handheld unit upwards to remove it.
  3. Attach desired accessories (e.g., crevice tool, brush nozzle) to the handheld unit's suction opening.
  4. To reattach, align the handheld unit with the stick vacuum body and push down until it clicks into place.

Maintenance

Regular maintenance ensures your vacuum cleaner operates at peak efficiency.

1. Emptying the Dustbin

2. Cleaning the Filters

3. Cleaning the Brush Roll

Troubleshooting

ProblemPossible CauseSolution
Vacuum does not turn on.Battery is not charged.Charge the battery fully.
Power button not pressed correctly.Ensure the power button is pressed firmly.
Reduced suction power.Dustbin is full.Empty the dustbin.
Filters are clogged.Clean or replace the filters.
Nozzle or hose is blocked.Check for and remove any blockages.
Brush roll not spinning.Hair or debris tangled in brush roll.Clean the brush roll as described in the Maintenance section.
Brush roll access cover not closed properly.Ensure the brush roll cover is securely latched.

Specifications

Note: Specifications are subject to change without notice for product improvement.

Warranty and Support

For warranty information, technical support, or to purchase replacement parts, please refer to the warranty card included with your product or visit the official AEG website. Do not attempt to repair the appliance yourself, as this may void your warranty and pose safety risks. Always contact authorized service personnel for repairs.

Keep your proof of purchase for warranty claims.