Important Safety Information
WARNING: For outdoor use only. Never operate this appliance indoors or in an unventilated area. Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Read the installation, operating, and maintenance instructions thoroughly before installing or servicing this equipment.
- Keep clear of combustible materials. Maintain adequate clearance from sides and top.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- Propane gas is not natural gas. Use only propane for this heater.
- Always ensure the heater is on a firm, level surface.
- Turn off the gas supply at the cylinder after use.
Package Contents
Verify all components are present and undamaged before assembly. Refer to the parts diagram in your printed manual for detailed identification.
- Heater Head Assembly
- Main Support Pole (Upper and Lower sections)
- Base Assembly with Wheels
- Propane Tank Holder Frame
- Reflector Shield (Multi-piece)
- Drink Shelf Tabletop
- Hardware Kit (Screws, nuts, washers, wrench)
- Instruction Manual
Assembly Instructions
Follow these steps carefully for proper assembly. It is recommended to have two people for certain steps, especially when handling the upper sections.
- Attach Wheels to Base: Secure the two built-in wheels to the base assembly using the provided hardware. Ensure they are firmly attached for easy mobility.
- Install Propane Tank Holder: Attach the propane tank holder frame to the base. Make sure the central pole attachment point is aligned. Tighten all screws securely.
- Mount Base Cover: Slide the cylindrical base cover over the tank holder frame and onto the base. This cover conceals the propane tank and provides the tabletop support.
- Connect Main Support Pole: Thread the propane line from the heater head through the upper and lower sections of the main support pole. Connect the lower pole section to the tank holder frame, ensuring the propane line passes through. Secure with screws.
- Attach Heater Head: Carefully attach the heater head assembly to the top of the main support pole. Ensure the propane line is properly connected and all bolts are tightened.
- Assemble Reflector Shield: The reflector shield comes in multiple pieces. Remove any protective film. Assemble the pieces into a circular pattern and secure them with the provided screws. Attach the assembled reflector shield to the top of the heater head.
- Install Drink Shelf Tabletop: Place the round drink shelf tabletop onto the designated area on the main support pole.
Figure 1: Key features and components of the patio heater.
Figure 2: Dimensions and propane tank fit.
Operating Instructions
Before operating, ensure the heater is assembled correctly and the propane tank is securely connected and open.
- Connect Propane Tank: Ensure the propane tank is connected to the heater's gas line. Open the valve on the propane tank fully.
- Ignition: Press and turn the control knob to the 'LOW' position. While holding the knob in, press the igniter button repeatedly until the pilot flame ignites. Continue to hold the control knob for 10-15 seconds after ignition to allow the thermocouple to heat up.
- Adjust Heat: Once ignited, release the control knob. You can then adjust the heat output from 'LOW' to 'HIGH' by rotating the control knob to your desired setting.
- Shutdown: To turn off the heater, turn the control knob to the 'OFF' position. Close the valve on the propane tank.
Figure 3: Ignition system and heat adjustment.
Maintenance
Regular maintenance ensures safe and efficient operation of your patio heater.
- Cleaning: Clean the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners or flammable cleaning agents.
- Storage: When not in use for extended periods, disconnect the propane tank and store the heater in a cool, dry place, preferably covered to protect it from dust and weather.
- Inspection: Periodically inspect the gas hose and connections for any signs of wear, cuts, or leaks. Replace if necessary.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Heater will not ignite | No gas flow; Igniter issue | Check propane tank valve; Ensure igniter button is pressed firmly. |
| Pilot flame goes out | Low gas pressure; Wind; Thermocouple issue | Check propane level; Shield from wind; Contact customer support. |
| Low heat output | Low gas pressure; Control knob setting | Check propane level; Adjust control knob to 'HIGH'. |
Specifications
| Feature | Detail |
|---|---|
| Brand | COSTWAY |
| Model Number | 61848BK-CYHW |
| Heat Output | 50,000 BTU |
| Heating Coverage | Up to 13 feet in diameter |
| Fuel Type | Propane |
| Special Features | Round Table Top, Tip-over Protection, Wheels |
| Product Dimensions | 32"D x 32"W x 87"H |
| Item Weight | 35 pounds |
| Material | High-quality Steel Frame with Powder Coating |
| Usage | Outdoor |
Warranty and Support
For warranty information, product support, or to order replacement parts, please refer to the contact details provided in your product packaging or visit the official COSTWAY website. Keep your purchase receipt for warranty claims.
