1. Introduction
The Team Associated Pro2 SC10 is a Ready-To-Run (RTR) 1/10 scale RC replica of Pro 2 trucks used in off-road racing. This instruction manual provides essential information for setting up, operating, and maintaining your Pro2 SC10 Short Course Truck. It features a rear motor short-course chassis, adjustable aluminum big-bore coil-over shocks, a sealed-gear differential, and heavy-duty CVA driveshafts. Power is supplied by a water-resistant Reedy electronic speed controller and a 3300kV electric motor, controlled by a 2-channel 2.4GHz radio with a Dynamic Vehicle Control (DVC) receiver.
Image: Front-side view of the Team Associated Pro2 SC10 Short Course Truck, showcasing its dynamic design.
2. Setup
2.1 Unboxing and Initial Inspection
Carefully remove all components from the packaging. Inspect the truck and all accessories for any signs of damage. Ensure all listed items are present.
2.2 Battery Installation (Not Included)
The Team Associated Pro2 SC10 requires a NiMH or 2/3s LiPo battery pack (not included). Ensure the battery is fully charged before installation. Secure the battery using the hook-and-loop battery straps on the low center-of-gravity molded composite chassis.
2.3 Transmitter Setup
Install the required batteries into the 2-channel 2.4GHz radio transmitter. Familiarize yourself with the controls, including steering, throttle, and any trim adjustments.
Image: The 2-channel 2.4GHz radio transmitter for controlling the RC truck.
2.4 Component Overview
The truck features a powerful Reedy 3300kV brushless motor and a water-resistant, high-power Reedy brushless speed control with T-plug connector and LiPo low-voltage cutoff. The receiver is housed in a water-resistant enclosed box.
Image: The powerful Reedy 3300kV brushless motor, a key component for high-speed performance.
Image: Top-down view of the Pro2 SC10 chassis, showing the layout of internal components.
3. Operating Instructions
3.1 Powering On
- Turn on the transmitter first.
- Connect the battery to the ESC in the truck.
- Turn on the truck's power switch.
3.2 Driving the Truck
The Pro2 SC10 is designed for off-road racing with features like fully adjustable suspension geometry and aluminum 12mm big-bore, coil-over shock absorbers. The DVC (Dynamic Vehicle Control) receiver with a built-in adjustable gyro assists in maintaining stability and control.
- Steering: Use the steering wheel on the transmitter to control direction.
- Throttle: Use the trigger for forward and reverse movement.
- Adjustable Suspension: Fine-tune the suspension for optimal performance on various terrains.
- Durable Design: Built with a durable and lightweight aluminum top shaft and rugged steel turnbuckles.
Image: The Pro2 SC10 truck navigating a dirt track, highlighting its off-road capabilities.
Image: Rear view of the Pro2 SC10, emphasizing its robust construction and rear CVA drive shafts.
Image: Side profile of the Pro2 SC10, illustrating its adjustable suspension geometry.
4. Maintenance
4.1 Cleaning
After each use, especially in dirty or wet conditions, clean your truck. Use a soft brush or compressed air to remove dirt and debris. Avoid using harsh chemicals that may damage plastic or electronic components.
4.2 Inspection
Regularly check all screws, nuts, and bolts for tightness. Inspect the tires for wear and tear, and ensure the suspension components are functioning smoothly. Check the condition of the CVA drive shafts and sealed gear differential.
4.3 Battery Care
Always follow the manufacturer's instructions for charging and storing your NiMH or LiPo batteries. Disconnect the battery from the truck when not in use and store it in a cool, dry place.
5. Troubleshooting
5.1 No Power
- Check if the battery is fully charged and properly connected.
- Ensure the transmitter and truck power switches are turned on.
- Verify all electrical connections are secure.
5.2 Loss of Control
- Check transmitter batteries.
- Ensure the truck and transmitter are properly bound.
- Adjust steering and throttle trims on the transmitter.
- Verify the DVC receiver's gyro settings.
5.3 Reduced Performance
- Check for debris in moving parts or drivetrain.
- Inspect the motor and ESC for overheating.
- Ensure tires are not excessively worn.
6. Specifications
| Feature | Detail |
|---|---|
| Product Dimensions | 21.18 x 11.1 x 7.48 inches |
| Item Weight | 4.04 pounds |
| ASIN | B09DJB23ZS |
| Item model number | AS70020 |
| Manufacturer recommended age | 14 years and up |
| Manufacturer | Team Associated |
7. Warranty and Support
For warranty information, technical support, or to purchase replacement parts, please visit the official Team Associated website or contact their customer service department. Keep your proof of purchase for any warranty claims.
