Introduction
Thank you for choosing the Serta Luxuriously Soft Plush Electric Blanket. This manual provides essential information for the safe and efficient use of your new electric blanket. Please read all instructions carefully before use and retain this manual for future reference.
This King size electric blanket (92 in x 100 in) in Sea Blue features a soft microlight to polyester fabric, 10 heat settings, and a 1-12 hour auto shut-off timer for your comfort and safety. It is ETL certified and designed for machine washing.
Important Safety Instructions
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before using this blanket.
- Do not use with a generator, power converter, or inverter.
- Do not use with damaged cords or plugs. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
- Do not use on an infant, a child, an incapacitated person, a paraplegic, a quadriplegic, a diabetic, anyone insensitive to heat, or anyone who cannot clearly understand the instructions and/or operate the controls.
- Do not use on a waterbed, bunk bed, adjustable bed, or children's cribs and beds.
- Do not use with pets.
- Do not use if wet.
- Do not use if folded, bunched, or rolled.
- Do not use pins or other metallic objects with this blanket.
- Do not leave the controller covered when in use to avoid overheating.
- Unplug the blanket when not in use.
- Do not dry clean this product. Dry cleaning agents may damage the insulation of the heating element.
- Do not iron this product.
- Do not use bleach.
Setup Instructions
Follow these steps to properly set up your Serta Electric Blanket:
- Unpack the Blanket: Carefully remove the electric blanket from its packaging.
- Position the Blanket: Lay the electric blanket flat on your bed, ensuring it is spread out evenly without any folds or bunches. The connector for the controller should be positioned at the foot end of the bed.
- Connect the Controller(s): For King size blankets, there are two controllers. Firmly plug each controller cord into the corresponding connector on the blanket. Ensure a secure connection.
- Plug into Power: Plug the power cord(s) from the controller(s) into a 120V/60Hz electrical outlet. Do not use extension cords or power strips.
- Ensure Proper Placement: Make sure the controller(s) remain uncovered during use to prevent overheating. Keep the power and controller cords loose and untwisted to avoid pinching or damage.
Operating Instructions
Your Serta Electric Blanket is designed for ease of use with its intuitive controller(s).
Controller Functions
- ON/OFF Button: Press to turn the blanket on or off.
- TIMER/HEAT Button: Press to cycle between adjusting the timer and heat settings.
- '+' and '-' Buttons: Use these buttons to increase or decrease the heat level or timer duration.
- LCD Display: Shows the current heat setting (1-10) or timer duration (1-12 hours).
Adjusting Heat Settings
- Press the ON/OFF button to turn on the blanket. The display will show the default heat setting.
- Press the TIMER/HEAT button until the heat indicator is active (if applicable, or simply observe the heat level on the LCD).
- Use the '+' or '-' buttons to select your desired heat level from 1 (low) to 10 (high).
Setting the Auto Shut-Off Timer
- With the blanket on, press the TIMER/HEAT button until the timer indicator is active (if applicable, or observe the timer duration on the LCD).
- Use the '+' or '-' buttons to select the desired auto shut-off time, from 1 to 12 hours. The blanket will automatically turn off after the selected time has elapsed.
Dual Control (King/Queen Sizes)
King and Queen size blankets are equipped with two controllers, allowing independent heat and timer settings for each side of the bed. Each user can customize their comfort level without affecting the other side.
Care and Maintenance
Proper care ensures the longevity and performance of your Serta Electric Blanket.
Washing Instructions
The Serta Electric Blanket is machine washable. Always disconnect the controller(s) from the blanket before washing.
- Pre-soak (Optional): For best results, pre-soak the blanket for 15 minutes in cold water with a small amount of mild detergent.
- Machine Wash: Wash on a delicate or gentle cycle in cold water. Use minimal detergent. Do not use bleach.
- Rinse: Rinse thoroughly in cold water.
- Spin Cycle: Run a short spin cycle to remove excess water. Remove the blanket immediately after the spin cycle to prevent creasing.
Drying Instructions
- Tumble Dry: Tumble dry on a low or medium heat setting for no more than 5 minutes.
- Air Dry: Remove the blanket from the dryer while still slightly damp. Gently stretch the blanket to its original size and hang it over a clothesline or shower rod to finish drying. Do not use clothespins, as they can damage the internal wires.
- Do Not Iron: Never iron the electric blanket.
Storage
To prolong the life of your electric blanket, store it properly at the end of the season.
- Ensure the blanket is completely dry before storing.
- Roll the blanket loosely rather than folding it tightly. This helps prevent damage to the internal heating wires.
- Store in a cool, dry place. Do not place heavy objects on top of the stored blanket.
Troubleshooting
If you encounter issues with your Serta Electric Blanket, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Controller light is blinking. | Loose connection or internal error. | Unplug the blanket from the wall outlet. Firmly reconnect the controller cord to the blanket. Plug the power cord back into the wall outlet. If the issue persists, contact customer support. |
| Controller feels warm to the touch. | Normal operation. | This is normal. Small amounts of electricity cycle through the controller during operation, which may cause it to feel slightly warm. This is not a malfunction. |
| Blanket is not heating. | Not plugged in, loose connection, or incorrect setting. | Ensure the power cord is securely plugged into a working outlet. Check that the controller cord is firmly connected to the blanket. Verify the blanket is turned on and a heat setting is selected. |
| Blanket heats unevenly. | Blanket is folded, bunched, or not spread flat. | Ensure the blanket is spread out smoothly and evenly on the bed. Avoid folding or bunching the blanket during use. |
If these troubleshooting steps do not resolve the issue, please refer to the Warranty and Support section for further assistance.
Specifications
| Feature | Detail |
|---|---|
| Model Number | ST54-0209 |
| Size | King (92"W x 100"L) |
| Color | Sea Blue |
| Material | 100% Microlight to Polyester |
| Heat Settings | 10 Levels |
| Auto Shut-off Timer | 1-12 Hours |
| Input Voltage | 120V/60Hz |
| Power Cord Length | 6 ft |
| Controller Cord Length | 11 ft |
| Controllers | 2 (for King size) |
| Safety Certification | ETL Certified |
| Care Instructions | Machine Washable |
| Item Weight | 4.31 pounds |
| UPC | 086569542809 |
Warranty and Support
Warranty Information
Your Serta Electric Blanket is backed by a 5-year limited manufacturer warranty. This warranty covers defects in materials and workmanship under normal use. Please retain your proof of purchase for warranty claims.
Customer Support
For warranty service, technical assistance, or any questions not addressed in this manual, please contact Serta customer support. Specific contact details can typically be found on the product packaging or the official Serta website. When contacting support, please have your model number (ST54-0209) and proof of purchase readily available.