Introduction
This manual provides detailed instructions for the safe and efficient operation, installation, and maintenance of your ZOKOP 2IN1 Mini Portable Compact Washing Machine. Please read this manual thoroughly before using the appliance and retain it for future reference.
Important Safety Instructions
- Read all instructions before use.
- Ensure the power supply matches the machine's requirements (110V/60Hz).
- Do not operate the machine with a damaged power cord or plug.
- Keep children and pets away from the machine during operation.
- Do not immerse the electrical parts in water.
- Unplug the machine when not in use or before cleaning.
- Place the machine on a stable, level surface.
- Do not wash waterproof materials.
- Do not overload the machine.
Product Overview
The ZOKOP 2IN1 Mini Portable Compact Washing Machine features a twin tub design for separate washing and spinning functions.

Figure 1: Front view of the ZOKOP Twin Tub Portable Washing Machine, showing the wash and spin tubs, and control knobs.
Components
- Wash Tub: For washing clothes.
- Spin Tub: For dewatering clothes.
- Control Knobs:
- Wash Selector (Gentle/Normal/Drain)
- Wash Timer (up to 15 minutes)
- Spin Timer (up to 5 minutes)
- Inlet Hose: For water supply.
- Drain Pipe: For draining dirty water.
- Pulsator: Located at the bottom of the wash tub, for agitating clothes.

Figure 2: Close-up view of the wash tub interior, showing the pulsator at the bottom.
Setup
Unpacking
Carefully remove the washing machine from its packaging. Check for any damage during transit. Retain packaging for future transport if needed.
Placement
Place the washing machine on a firm, level surface to minimize vibration and noise during operation. Ensure there is adequate space around the machine for ventilation and access.
Water Connection
- Connect the provided 2m water inlet hose to a water faucet.
- Insert the other end of the inlet hose into the water inlet opening on the washing machine.
Drain Setup
Position the 2m drain pipe to allow for proper drainage of water. The built-in drain pump facilitates draining dirty water. Ensure the drain pipe is not kinked or blocked.
Power Connection
Plug the power cord into a grounded 110V/60Hz electrical outlet.
Operating Instructions
Washing Clothes
- Open the lid of the wash tub.
- Load clothes into the wash tub. Do not exceed the rated washing capacity of 8 lbs.
- Add appropriate amount of water and detergent.
- Close the lid.
- Set the Wash Selector knob to the desired wash mode (Gentle or Normal).
- Turn the Wash Timer knob to set the washing duration (up to 15 minutes). The machine will start washing automatically.

Figure 3: The washing machine in action, demonstrating the cleaning process with clothes and water.

Figure 4: The pulsator at the bottom of the wash tub, designed to create water currents for effective cleaning and reduced winding.
Draining Water
After washing, set the Wash Selector knob to "Drain" to empty the water from the wash tub.
Spinning Clothes
- Transfer the washed clothes from the wash tub to the spin tub. Do not exceed the rated spin capacity of 5 lbs.
- Ensure clothes are evenly distributed in the spin tub to prevent imbalance.
- Close the spin tub lid.
- Turn the Spin Timer knob to set the spinning duration (up to 5 minutes). The machine will start spinning.

Figure 5: Illustration of the twin tub design, allowing for simultaneous washing and dewatering operations.
- Once the spin cycle is complete, open the lid and remove the clothes.
Maintenance
Cleaning the Exterior
Wipe the exterior of the machine with a soft, damp cloth. Do not use abrasive cleaners or solvents.
Cleaning the Tubs
After each use, rinse the wash and spin tubs with clean water. Periodically, clean the tubs with a mild detergent and a soft brush to remove any residue.
Drain Filter
Check and clean the drain filter regularly to prevent blockages and ensure efficient drainage. (Refer to product diagram for filter location if applicable).
Storage
If storing the machine for an extended period, ensure it is completely dry. Store in a cool, dry place away from direct sunlight.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Machine does not start | Not plugged in; Power outage; Timer not set. | Check power connection; Check circuit breaker; Set timer knob. |
| Water does not drain | Drain pipe kinked or blocked; Drain selector not set to "Drain". | Straighten drain pipe; Clear any blockages; Set selector to "Drain". |
| Excessive vibration/noise during spin | Clothes unevenly distributed in spin tub; Machine not on level surface. | Rearrange clothes evenly; Adjust machine's position on a level surface. |
| Water leakage | Inlet/drain hose loose; Overfilling. | Tighten hose connections; Do not exceed maximum water level. |
If the problem persists after attempting these solutions, please contact customer support.
Specifications
| Feature | Detail |
|---|---|
| Model | XPB46-RS4 |
| Power Supply | 110V/60Hz |
| Rated Washing Capacity | 8 lbs |
| Rated Spin Capacity | 5 lbs |
| Rated Wash Input Power | 300W |
| Rated Spin Input Power | 250W |
| Total Power | 550W |
| Color | White & Blue |
| Dimensions (L x W x H) | (23.23 x 13.98 x 26.57) inches / (59 x 35.5 x 67.5) cm |
| Weight | 11 kg / 24.25 lbs |
| Material | Plastic & PP |
| Motor Speed | 1300 rpm/mins |

Figure 6: Diagram illustrating the dimensions of the washing machine: 23.23 inches (L), 13.98 inches (W), and 26.57 inches (H).
Warranty and Support
For any questions or assistance, please contact customer support. The product description mentions: "If you have any questions, please contact us, we will reply as soon as possible."
For support inquiries, refer to the contact information provided by your retailer or the manufacturer's official website.